|
|
|
부품번호 | IR2133PBF 기능 |
|
|
기능 | 3-PHASE BRIDGE DRIVER | ||
제조업체 | International Rectifier | ||
로고 | |||
전체 27 페이지수
Data Sheet No. PD60107 revX
IR2133/IR2135(J&S)&(PbF)
IR2233/IR2235(J&S)&(PbF)
3-PHASE BRIDGE DRIVER
Features
• Floating channel designed for bootstrap operation
Fully operational to +600V or+1200V
Tolerant to negative transient voltage
dV/dt immune
• Gate drive supply range from 10V/12V to 20V DC and
up to 25V for transient
• Undervoltage lockout for all channels
• Over-current shut down turns off all six drivers
• Independent 3 half-bridge drivers
• Matched propagation delay for all channels
• 2.5V logic compatible
• Outputs out of phase with inputs
• All parts are also available LEAD-FREE
Product Summary
VOFFSET
IO+/-
VOUT
ton/off (typ.)
Deadtime (typ.)
600V or 1200V max.
200 mA / 420 mA
10 - 20V or 12 - 20V
750/700 ns
250 ns
Packages
Description
The IR2133IR2135/IR2233IR2355 (J&S) are high voltage, high speed
power MOSFET and IGBT driver with three independent high side and
low side referenced output channels for 3-phase applications. Propri-
etary HVIC technology enables ruggedized monolithic construction.
Logic inputs are compatible with CMOS or LSTTL outputs, down to
28-Lead SOIC
28-Lead PDIP
2.5V logic. An independent operational amplifier provides an analog
feedback of bridge current via an external current sense resistor. A
44-Lead PLCC w/o 12 leads
current trip function which terminates all six outputs can also be de-
rived from this resistor. A shutdown function is available to terminate all six outputs. An open drain FAULT signal is provided to
indicate that an over-current or undervoltage shutdown has occurred. Fault conditions are cleared with the FLT-CLR lead. The
output drivers feature a high pulse current buffer stage designed for minimum driver cross-conduction. Propagation delays are
matched to simplify use in high frequency applications. The floating channels can be used to drive N-channel power MOSFETs or
IGBTs in the high side configuration which operates up to 600 volts or 1200 volts.
Typical Connection
up to 600V or 1200V
(Refer to Lead Assignments for correct pin configuration). This/These diagram(s) show electrical connections only.
Please refer to our Application Notes and DesignTips for proper circuit board layout.
www.irf.com
1
IR2133/IR2135/IR2233/IR2235(J&S)&(PbF)
Static Electrical Characteristics — Continued
VBIAS (VCC, VBS1,2,3) = 15V unless otherwise specified and TA = 25oC. All static parameters other than IO and VO
are referenced to VSS and are applicable to all six channels (HS1,2,3 & LS1,2,3). The VO and IO parameters are
referenced to COM and VS1,2,3 and are applicable to the respective output leads: HO1,2,3 or LO1,2,3.
Symbol Parameter Definition
Min. Typ. Max. Units Test Conditions
IFLTCLR+ “High” Fault Clear Input Bias Current
—
IFLTCLR- “Low” Fault Clear Input Bias Current
—
VBSUV+ VBS Supply Undervoltage Positive Going Threshold
(for IR2133/IR2233) 7.6
(for IR2135/IR2235) 9.2
VBSUV- VBS Supply Undervoltage Negative Going Threshold
(for IR2133/IR2233) 7.2
(for IR2135/IR2235) 8.3
VBSUVH VBS Supply Undervoltage Lockout Hysteresis
(for IR2133/IR2233)
—
(for IR2135/IR2235) —
VCCUV+ VCC Supply Undervoltage Positive Going Threshold
(for IR2133/IR2233) 7.6
(for IR2135/IR2235) 9.2
VCCUV- VCC Supply Undervoltage Negative Going Threshold
(for IR2133/IR2233) 7.2
(for IR2135/IR2235) 8.3
VCCUVH VCC Supply Undervoltage Lockout Hysteresis
(for IR2133/IR2233)
—
(for IR2135/IR2235) —
Ron,FLT FAULT- Low On Resistance
—
IO+ Output High Short Circuit Pulsed Current
200
200 350
100 250
8.6 9.6
10.4 11.6
8.2 9.2
9.4 10.5
0.4 —
1—
8.6 9.6
10.4 11.6
8.2 9.2
9.4 10.5
0.4 —
1—
70 100
250 —
IO- Output Low Short Circuit Pulsed Current
420 500 —
FLT-CLR = 0V
µA FLT-CLR = 5V
V
Ω
VOUT = 0V, VIN = 0V
PW ≤ 10 µs
mA VOUT = 15V, VIN = 5V
PW ≤ 10 µs
VOS
IIN,AMP
CMRR
PSRR
Amplifier Input Offset Voltage
Amplifier Input Bias Current
Amplifier Common Mode Rejection Ratio
Amplifier Power Supply Rejection Ratio
—0
——
50 70
50 70
30
4
—
—
mV CA+=0.2V, CA-=CAO
nA CA+ = CA- = 2.5V
CA+ = 0.1V & 5V, CA- = CAO
dB CA+=0.2V, CA-=CAO
VCC = 10V & 20V
VOH,Amp Amplifier High Level Output Voltage
VOL,Amp Amplifier Low Level Output Voltage
ISRC,Amp Amplifier Output Source Current
ISNK,Amp Amplifier Output Sink Current
IO+,Amp Amplifier Output High Short Circuit Current
IO-,Amp Amplifier Output Low Short Circuit Current
5 5.2 5.4 V CA+ = 1V, CA- = 0V
— — 20 mV CA+ = 0V, CA- = 1V
47
—
CA+ = 1V, CA- = 0V, CAO = 4V
0.5 1
— 10
— CA+ = 0V, CA- = 1V, CAO = 2V
mA
— CA+ = 5V, CA- = 0V, CAO = 0V
—4
—
CA+ = 0V, CA- = 5V, CAO = 5V
4 www.irf.com
4페이지 IR2133/IR2135/IR2233/IR2235(J&S)&(PbF)
HIN
LIN 50%
50%
ton
HO
LO
tr
90%
toff
90%
tf
10%
10%
Figure 2. Switching Time Waveform Definitions
HIN
50%
LIN
50%
LO
50% 50%
HO
DT DT
Figure 3. Deadtime Waveform Definitions
FLT-CLR
50%
ITRIP
50%
FAULT
50%
50%
Any Output
tflt
titrip
50%
tfltclr
Figure 4. Overcurrent Shutdown Waveform
t in,fil
t in,fil
HIN/LIN
on off
on
HO/LO
high
off on off
low
Figure 4.5. Input Filter Function
50%
SD
tsd
HO 90%
LO
Figure 5. Shutdown Waveform Definitions
www.irf.com
7
7페이지 | |||
구 성 | 총 27 페이지수 | ||
다운로드 | [ IR2133PBF.PDF 데이터시트 ] |
당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는 |
구매 문의 | 일반 IC 문의 : 샘플 및 소량 구매 ----------------------------------------------------------------------- IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한 광범위한 전력 반도체를 판매합니다. 전력 반도체 전문업체 상호 : 아이지 인터내셔날 사이트 방문 : [ 홈페이지 ] [ 블로그 1 ] [ 블로그 2 ] |
부품번호 | 상세설명 및 기능 | 제조사 |
IR2133PBF | 3-PHASE BRIDGE DRIVER | International Rectifier |
DataSheet.kr | 2020 | 연락처 | 링크모음 | 검색 | 사이트맵 |