Datasheet.kr   

UM17525 데이터시트 PDF




Union Semiconductor에서 제조한 전자 부품 UM17525은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


 

PDF 형식의 UM17525 자료 제공

부품번호 UM17525 기능
기능 VLDO Linear Regulator
제조업체 Union Semiconductor
로고 Union Semiconductor 로고


UM17525 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.



전체 8 페이지수

미리보기를 사용할 수 없습니다

UM17525 데이터시트, 핀배열, 회로
UM175XX
300mA, Micropower, VLDO Linear Regulator
UM175XX SOT23-5
General Description
The UM175XX series are VLDO (very low dropout) linear regulators designed for low power
portable applications. Typical output noise is only 75μVRMS and maximum dropout is just 90mV
at the load current of 150mA.The internal P-channel MOSFET pass transistor requires no base
current, allowing the device to draw only 100μA during normal operation at the maximum load
current of 300mA.
Other features include high output voltage accuracy, excellent transient response, under voltage
lockout, stability with ultralow ESR ceramic capacitors as small as 1μF, short-circuit and thermal
overload protection and output current limiting.
The UM175XX series are available in a low profile SOT23-5 package.
Applications
z Bluetooth/802.11 Cards
z PDAs and Notebook Computers
z Portable Instruments and
Battery-Powered Systems
z Cellular Phones
Features
z Very Low Dropout: 90mV(max) at 150mA
z Maximum Input Voltage: 6.0V
z Low Noise:75μVRMS (10Hz to 100kHz)
z ±2%Voltage Accuracy at 150mA
z Fast Transient Response
z Under Voltage Lockout
z Fixed Output Voltage:
3.3V/3.0V/2.8V/2.7V/2.5V/1.8V/1.5V/1.3V/
1.2V
z Output Current Limit
z No Protection Diodes Needed
z Stable with 1μF Output Capacitor
z Short-Circuit and Thermal Overload
Protection
z Low Profile SOT23-5 Package
Pin Configurations
Top View
UM175XX
M: Monthly Code
SOT23-5
________________________________________________________________________
http://www.union-ic.com Rev.02 Oct.2008
1/8




UM17525 pdf, 반도체, 판매, 대치품
UM175XX
Pin Function
IN (Pin 1): Power for UM175XX and Load. Power is supplied to the devices through the IN pin.
The IN pin should be locally bypassed to ground if the UM175XX series are more than a few
inches away from another source of bulk capacitance. In general, the output impedance of a
battery rises with frequency, so it is usually advisable to include an input bypass capacitor in
battery-powered circuits. A capacitor in the range of 0.1μF to 1μF is usually sufficient. The
UM175XX series are designed to withstand reverse voltages on the IN pin with respect to both
ground and the output pin. In the case of a reversed input, which can happen if a battery is
plugged in backwards, the UM175XX will act as if there is a large resistor in series with its input
with only a small amount of current flow.
GND (Pin 2): Ground and Heat Sink. Solder to a ground plane or large pad to maximize heat
dissipation.
___________
SHDN
(Pin 3): Shutdown, Active Low. This pin is used to put the UM175XX into shutdown. The
___________
SHDN
pin cannot be left
floating and must be tied to the input pin if not used.
NC (Pin 4): Not Connected.
OUT (Pin 5): Voltage Regulated Output. The OUT pin supplies power to the load. A minimum
output capacitor of 1μF is required to ensure stability. Larger output capacitors may be required
for applications with large transient loads to limit peak voltage transients. See the Applications
Information section for more information on output capacitance.
Typical Application Circuit
VIN
3.4V to 6.0V
IN OUT
1uF
OFF ON
SHDN
GND
VOUT
3.3V
1uF
________________________________________________________________________
http://www.union-ic.com Rev.02 Oct.2008
4/8

4페이지










UM17525 전자부품, 판매, 대치품
Package Information
Outline Drawing
UM175XX
UM175XX: SOT23-5
Symbol
A
A1
A2
b
c
D
E
E1
e
e1
L
θ
DIMENSIONS
MILLIMETERS INCHES
Min
1.050
Max
1.250
Min Max
0.041 0.049
0.000 0.100 0.000 0.004
1.050 1.150 0.041 0.045
0.300 0.500 0.012 0.020
0.100 0.200 0.004 0.008
2.820 3.020 0.111 0.119
1.500 1.700 0.059 0.067
2.650 2.950 0.104 0.116
0.950REF
0.037REF
1.800 2.000 0.071 0.079
0.300 0.600 0.012 0.024
0° 8° 0° 8°
Land Pattern
Tape and Reel Orientation
NOTES:
1. Compound dimension: 2.92×1.60
2. Unit: mm;
3. General tolerance ±0.05mm unless otherwise
specified;
4. The layout is just for reference.
________________________________________________________________________
http://www.union-ic.com Rev.02 Oct.2008
7/8

7페이지


구       성 총 8 페이지수
다운로드[ UM17525.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
UM17525

VLDO Linear Regulator

Union Semiconductor
Union Semiconductor
UM17527

VLDO Linear Regulator

Union Semiconductor
Union Semiconductor

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵