Datasheet.kr   

SURTA2000XL 데이터시트 PDF




APC에서 제조한 전자 부품 SURTA2000XL은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


 

PDF 형식의 SURTA2000XL 자료 제공

부품번호 SURTA2000XL 기능
기능 Smart-UPS RT Uninterruptible Power Supply User Manual
제조업체 APC
로고 APC 로고


SURTA2000XL 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.



전체 16 페이지수

미리보기를 사용할 수 없습니다

SURTA2000XL 데이터시트, 핀배열, 회로
APC Smart-UPS® RT SURTA1500XL/SURTA1500XLJ/SURTA2000XL
Uninterruptible Power Supply User Manual
Introduction/Before Installation
About this Manual
The APC Smart-UPS® RT (SURTA1500XL, SURTA1500XLJ, and SURTA2000XL) is a high-
performance, Uninterruptible Power Supply (UPS) designed to prevent blackouts, brownouts, sags
and surges from reaching your computers, servers, and other sensitive electronic equipment.
This manual describes procedures on how to properly unpack and install the UPS, connect the battery
and equipment, configure accessories, and start up the system.
Illustrations are representative. Your configuration, including components and optional APC equip-
ment, may be different from the models shown in this manual. The user manual is accessible from the
supplied CD and the APC web site, www.apc.com.
Contact Information
Refer to www.apc.com to contact APC or for additional information about this product.
Safety Information
Read the Safety Guide before you begin the installation, operate the UPS, or
perform equipment maintenance. Failure to comply with safety instructions
Warning could result in bodily injury or equipment damage.
Unpacking and Equipment Placement
The UPS is heavy. Two people are required to lift the UPS.
Select a location sturdy enough to handle the weight of the UPS.
Heavy
1. Unpack the equipment. The packaging is recyclable; save it for reuse or dispose of it properly.
2. Inspect the equipment upon receipt. Notify the carrier and dealer if there is damage.
3. Check the package contents:
• UPS and front bezel
• UPS literature kit containing:
– product documentation
– safety information
– warranty information
120 V models:
• PowerChute® CD
• Serial and USB
communication
cables
100 V models:
• Serial
communication
cable
4. Place the UPS where it will be used.
– Ensure that air vents on the front and rear of the UPS are not blocked.




SURTA2000XL pdf, 반도체, 판매, 대치품
Installation
The EPO feature provides immediate de-energizing of the UPS and connected equipment from a
remote location, without switching to battery operation.
1. Use one of the following cable types to connect the UPS to the EPO switch.
– CL2: Class 2 cable for general use.
– CL2P: Plenum cable for use in ducts, plenums, and other spaces used for environmental air.
– CL2R: Riser cable for use in a vertical run in a floor-to-floor shaft.
– CLEX: Limited use cable for use in dwellings and for use in raceways.
– For installation in Canada: Use only CSA certified, type ELC (extra-low voltage control
cable).
– For installation in other countries: Use standard low-voltage cable in accordance with national
and local regulations.
2. Locate the EPO connector on the rear of the UPS. Use a normally-open contact to connect
cable to each EPO terminal .

Connect the Battery and Install the Front Bezel
The battery is shipped in the disconnect position. Do not connect the battery until you are ready to use
the equipment.
1. Remove the battery cover .
2. Remove the warning label and protective sticker from the battery connector. Place the sticker on
the back of the battery cover for re-use.
3. Snap the battery connectors together .
4. Reinstall the battery cover .
5. Install the front bezel .
 
4 Smart-UPS RT SURTA1500XL/SURTA1500XLJ/SURTA2000XL Uninterruptible Power Supply User Manual

4페이지










SURTA2000XL 전자부품, 판매, 대치품
Operation
Indicator
LED
Indicator Title
Bypass
Fault
Description
The Bypass LED illuminates indicating that the UPS is in bypass mode.
Utility power is sent directly to connected equipment during bypass mode
operation. Bypass mode operation is the result of an internal UPS fault, an
overload condition, or a user initiated command through an accessory. Bat-
tery operation is not available while the UPS is in bypass mode.
The UPS detects an internal fault.
Overload
Replace Battery/Bat-
tery Disconnected
The connected equipment is drawing more than the UPS power rating
allows.
The battery is disconnected or must be replaced.
Display Panel Functions
Feature
Button
Feature Title
Power On
Power Off
Cold Start
Self-Test
Function
Press this button to turn on the UPS. Continue reading for additional
capabilities.
Press this button to turn off the UPS output.
NOTE: The battery will continue to charge and the fans will continue to run
while the UPS is connected to the utility.
When there is no utility power and the UPS is off, press and hold the
button to power up the UPS and connected equipment.
The UPS will emit two beeps. During the second beep, release the button.
Automatic: The UPS performs a self-test automatically when tuned on, and
every two weeks thereafter (by default). During the self-test, the UPS
briefly operates the connected equipment On Battery.
Manual: Press and hold the
test.
button for a few seconds to initiate the self-
On Battery Operation
The UPS switches to battery operation automatically if the utility power fails. While running On Bat-
tery, an alarm beeps four times every 30 seconds.
Press the button to silence this alarm. If the utility power does not return, the UPS continues to
supply power to the connected equipment until the battery is fully discharged.
When 2 minutes of run time remain, the UPS emits a continuous beeping. If PowerChute is not being
used, files must be manually saved and the computer must be turned off before the UPS fully dis-
charges the battery.
Refer to www.apc.com for information on battery runtimes. The UPS battery runtime differs based on
usage and environment.
Smart-UPS RT SURTA1500XL/SURTA1500XLJ/SURTA2000XL Uninterruptible Power Supply User Manual 7

7페이지


구       성 총 16 페이지수
다운로드[ SURTA2000XL.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
SURTA2000XL

Smart-UPS RT Uninterruptible Power Supply User Manual

APC
APC

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵