Datasheet.kr   

ITSX68C 데이터시트 PDF




IDTech에서 제조한 전자 부품 ITSX68C은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 ITSX68C 자료 제공

부품번호 ITSX68C 기능
기능 SXGA+ Color TFT/LCD Module
제조업체 IDTech
로고 IDTech 로고


ITSX68C 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.



전체 29 페이지수

미리보기를 사용할 수 없습니다

ITSX68C 데이터시트, 핀배열, 회로
Engineering Specification
Engineering Specification
Type 14.1 SXGA+ Color TFT/LCD Module
Model Name:ITSX68C
Document Control Number : OEM I-68C-02
Note:Specification is subject to change without notice. Consequently it is better to contact to
International Display Technology before proceeding with the design
of your product incorporating this module.
Product Development
International Display Technology
(C) Copyright International Display Technology 2002 All Rights reserved.
January 15,2002
OEM I-68C-02
1/29




ITSX68C pdf, 반도체, 판매, 대치품
Engineering Specification
1.0 Handling Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth
when handling.
7) Do not open nor modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a Module has to be put back into the packing container slot after once it was taken out
from the container, do not press the center of the CFL Reflector edge.
Instead, press at the far ends of the CFL Reflector edge softly. Otherwise the TFT Module may
be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the
Interface Connector of the TFT Module.
11) After installation of the TFT Module into an enclosure ( Notebook PC Bezel, for example),
do not twist nor bent the TFT Module even momentary. At designing the
enclosure, it should be taken into consideration that no bending/twisting forces are applied
to the TFT Module from outside. Otherwise the TFT Module may be damaged.
12) The fluorescent lamp in the liquid crystal display (LCD) contains mercury. Do not put it in trash that is
disposed of in landfills. Dispose of it as required by local ordinances or regualtions.
13) Small amount of materials having no flammability grade is used in the LCD module.
The LCD module should be supplied by power complied with requirements of
Limited Power Source (2.11, IEC60950 or UL1950), or be applied exemption
conditions of flammability requirements (4.4.3.3, IEC60950 or UL1950) in an end product.
14) The LCD module is designed so that the CFL in it is supplied by Limited Current Circuit
(2.4, IEC60950 or UL1950). Do not connect the CFL in Hazardous Voltage Circuit.
15) Gently wipe the covers and the screen with a soft cloth.
16) Remove finger marks and grease with a damp cloth and mild detergent; do not use solvents or abrasives.
17) Never apply detergent or other liquid directly to the screen. Dampen the cloth and then wipe.
O The information contained herein is presented only as a guide for the applications of our
products. No responsibility is assumed by International Display Technooogy for any
infringements of patents or other right of the third partied which may result from its use. No
license is granted by implication or otherwise under any patent or patent rights of International
Display Technology or others.
O The information contained herein may be changed without prior notice. It is therefore
advisable to contact International Display Technology before proceeding with the design of
equipment incorporationg this product.
(C) Copyright International Display Technology 2002 All Rights reserved.
January 15,2002
OEM I-68C-02
4/29

4페이지










ITSX68C 전자부품, 판매, 대치품
Engineering Specification
2.2 Functional Block Diagram
The following diagram shows the functional block of this Type 14.1 Color TFT/LCD Module.
The first LVDS port transmits even pixels while the second LVDS port transmits odd pixels.
Y-Driver
< 8 pairs LVDS >
6bit color data
for R/G/B
(even/odd)
DTCLK(even/odd)
DSPTMG
Vsync
Hsync
LCD DRIVE
CARD
EVEN
PIXCEL
ODD
PIXCEL
LCD
Controller
Dual LVDS
RECEIVER
G/A
VDD
GND
DC-DC
Converter
Ref circuit
LCD-DRIVE Connector
JAE FI-XB30S-HF10 (30pin)
X-Driver
TFT ARRAY/CELL
1400(R/G/B) x 1050
Backlight Unit
Lamp Connector
JST BHSR-02VS-1 (2pin)
(C) Copyright International Display Technology 2002 All Rights reserved.
January 15,2002
OEM I-68C-02
7/29

7페이지


구       성 총 29 페이지수
다운로드[ ITSX68C.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
ITSX68

SXGA+ Color TFT/LCD Module

IDTech
IDTech
ITSX68C

SXGA+ Color TFT/LCD Module

IDTech
IDTech

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵