Datasheet.kr   

RWP05040-10 데이터시트 PDF




RFHIC에서 제조한 전자 부품 RWP05040-10은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 RWP05040-10 자료 제공

부품번호 RWP05040-10 기능
기능 Wideband Power Amplifier
제조업체 RFHIC
로고 RFHIC 로고


RWP05040-10 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.



전체 7 페이지수

미리보기를 사용할 수 없습니다

RWP05040-10 데이터시트, 핀배열, 회로
Wideband Power Amplifier
RWP05040-10
Product Features
• GaN on SiC Broadband High Power Amplifier
• 20 ~ 1000MHz Operation Bandwidth
• Small Signal Gain 36dB min.
• 40W Typical. @ P3dB
Applications
• General Purpose
Package Type : DP-75
Description
The power amplifier module is designed for Broadcasting, Telecommunication, Medical and Other markets.
Operating frequency range is from 20 ~ 1000MHz.
Gallium Nitride on SiC technology is used and attached on an aluminum sub carrier. Full in/out matching for broadband
performance is already applied.
Improved thermal handling by patented technology.
Electrical Specifications @ VCC = 28V; Tc = 45°C; ZS = ZL = 50Ω
PARAMETER
Operating Frequency
Small Signal Gain
Gain Variation vs Frequency
P3 dB
OIP3 @ Po = +33dBm
(1MHz Tone spacing, CW 2-Tone)
Input Return Loss
UNIT
MHz
dB
dBpp
dBm
dBm
dB
MIN
20
36
-
44
42
41
51
46
43
-
TYP
-
38
±1
46
45
43
53
48
45
-12
MAX
1000
40
±2
-
-
-
-
-
-
-7
2nd Harmonic suppression
dBc -
-34 -31
Supply Voltage
Quiescent Current consumption
Current Consumption
V 27.5
A 1.9
A-
28
2.1
3.5
30
2.3
4
On/Off Switching Time*
uS - 3 5
Shut Down or Switch On/Off
0 - 0.5
TTL Voltage**
V
2.5 5 5.5
Note.
*. Gate On/Off : High speed switching
**. Drain On/Off : 500ms delay
CONDITION
-
-
-
20 ~ 300MHz
300 ~ 600MHz
600 ~ 1000MHz
20 ~ 300MHz
300 ~ 600MHz
600 ~ 1000MHz
-
CW 1-tone
@Po = +30dBm, Freq 400MHz
Vcc(=Vds)
-
CW 1-tone @ Po=+46dBm
On : TTL "Low"
Off : TTL "High"(30mA@Disable)
On : TTL “Low”(Enable)
Off : TTL “High”
Korean Facilities : 82-31-8069-3036 / [email protected]
US Facility : 919-677-8780 / [email protected]
1/7
All specifications may change without notice
Version 3.2




RWP05040-10 pdf, 반도체, 판매, 대치품
Wideband Power Amplifier
RWP05040-10
Precautions
1. This product is designed to be used for broadband amplification. Heat
generation is higher when there is no RF signal in the device.
Therefore, the worst case scenario is when there is no RF signal, and
the amplifier is “on” with current draw.
The temperature must be calculated properly.
Case temperature must maintain below 80°C.
Right side drawing notes how to use a temperature monitoring
function to protect against overheating.
2. Thermal Grease or Metal Thermal Interface Materials are
recommended for heat dissipation. An example would be spreading
thermal grease on the bottom of the device
RF IN
Vcc(+28V)
Shut Down
(+5V)
RF OUT
Temp Monitor
Switch ON/OFF
+Vcc
+
-
Ref Voltage
Comparator Block (with hysteresis gap)
Korean Facilities : 82-31-8069-3036 / [email protected]
US Facility : 919-677-8780 / [email protected]
4/7
All specifications may change without notice
Version 3.2

4페이지










RWP05040-10 전자부품, 판매, 대치품
Wideband Power Amplifier
RWP05040-10
Revision History
Part Number
RWP05040-10
RWP05040-10
RWP05040-10
Release Date
2015.11.10
2015.6.30
2015.1.15
Version
3.2
3.1
3.0
Modification
Note
Electrical Specifications
Notice Change
Data Sheet Status
-
-
-
RFHIC Corporation reserves the right to make changes to any products herein or to discontinue any product at any time without notice. While product specifications have been thoroughly
examined for reliability, RFHIC Corporation strongly recommends buyers to verify that the information they are using is accurate before ordering. RFHIC Corporation does not assume
any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or incidental damages.
RFHIC products are not intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or
sells such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC Corporation and its directors, officers, stockholders, employees,
representatives and distributors harmless against any and all claims arising out of such unauthorized use.
Sales, inquiries and support should be directed to the local authorized geographic distributor for RFHIC Corporation. For customers in the US, please contact the US Sales Team at 919-
677-8780. For all other inquiries, please contact the International Sales Team at 82-31-8069-3036.
Korean Facilities : 82-31-8069-3036 / [email protected]
US Facility : 919-677-8780 / [email protected]
7/7
All specifications may change without notice
Version 3.2

7페이지


구       성 총 7 페이지수
다운로드[ RWP05040-10.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
RWP05040-10

Wideband Power Amplifier

RFHIC
RFHIC

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵