Datasheet.kr   

ADP162 데이터시트 PDF




Analog Devices에서 제조한 전자 부품 ADP162은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


 

PDF 형식의 ADP162 자료 제공

부품번호 ADP162 기능
기능 CMOS Linear Regulators
제조업체 Analog Devices
로고 Analog Devices 로고


ADP162 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.




전체 24 페이지수

미리보기를 사용할 수 없습니다

ADP162 데이터시트, 핀배열, 회로
Data Sheet
Ultralow Quiescent Current,
150 mA, CMOS Linear Regulators
ADP160/ADP161/ADP162/ADP163
FEATURES
Ultralow quiescent current
IQ = 560 nA with 0 µA load
IQ = 860 nA with 1 µA load
Stable with 1 µF ceramic input and output capacitors
Maximum output current: 150 mA
Input voltage range: 2.2 V to 5.5 V
Low shutdown current: <50 nA typical
Low dropout voltage: 195 mV at 150 mA load
Initial accuracy: ±1%
Accuracy over line, load, and temperature: ±3.5%
15 fixed output voltage options: 1.2 V to 4.2 V
Adjustable output available
PSRR performance of 72 dB at 100 Hz
Current limit and thermal overload protection
Logic-control enable
Integrated output discharge resistor
5-lead TSOT package
4-ball, 0.5 mm pitch WLCSP
APPLICATIONS
Mobile phones
Digital cameras and audio devices
Portable and battery-powered equipment
Post dc-to-dc regulation
Portable medical devices
TYPICAL APPLICATION CIRCUITS
VIN = 2.3V
1µF
ADP160/ADP162
VOUT = 1.8V
1 VIN VOUT 5
2 GND
1µF
ON
OFF
3 EN
NC 4
NC = NO CONNECT
Figure 1. 5-Lead TSOT ADP160/ADP162 with Fixed Output Voltage, 1.8 V
VIN = 4.2V
1µF
ON
OFF
ADP161/ADP163
VOUT = 3.2V
1 VIN VOUT 5
2 GND
1µF
R1
3 EN
ADJ 4
R2
Figure 2. 5-Lead TSOT ADP161/ADP163 with Adjustable Output Voltage, 3.2 V
VIN = 3.3V
1µF
ON
OFF
ADP160/ADP162
12
VOUT = 2.8V
A VIN
VOUT
TOP VIEW
1µF
(Not to Scale)
B EN
GND
Figure 3. 4-Ball WLCSP ADP160/ADP162 with Fixed Output Voltage, 2.8 V
GENERAL DESCRIPTION
The ADP160/ADP161/ADP162/ADP163 are ultralow quiescent
current, low dropout, linear regulators that operate from 2.2 V
to 5.5 V and provide up to 150 mA of output current. The low
195 mV dropout voltage at 150 mA load improves efficiency and
allows operation over a wide input voltage range.
The ADP16x are specifically designed for stable operation with a
tiny 1 µF ± 30% ceramic input and output capacitors to meet
the requirements of high performance, space-constrained
applications.
The ADP160 is available in 15 fixed output voltage options,
ranging from 1.2 V to 4.2 V. The ADP160/ADP161 also include
a switched resistor to discharge the output automatically when
the LDO is disabled. The ADP162 is identical to the ADP160
but does not include the output discharge function.
The ADP161 and ADP163 are available as adjustable output voltage
regulators. They are only available in a 5-lead TSOT package.
The ADP163 is identical to the ADP161 but does not include
the output discharge function.
Short-circuit and thermal overload protection circuits prevent
damage in adverse conditions. The ADP160 and ADP162 are
available in a tiny 5-lead TSOT and a 4-ball, 0.5 mm pitch
WLCSP package for the smallest footprint solution to meet a
variety of portable power applications.
Rev. H
Document Feedback
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarksandregisteredtrademarksarethepropertyoftheirrespectiveowners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700 ©2010–2013 Analog Devices, Inc. All rights reserved.
Technical Support
www.analog.com




ADP162 pdf, 반도체, 판매, 대치품
ADP160/ADP161/ADP162/ADP163
Data Sheet
Parameter
UNDERVOLTAGE LOCKOUT
Input Voltage Rising
Input Voltage Falling
Hysteresis
OUTPUT NOISE
POWER SUPPLY REJECTION RATIO
Symbol
UVLO
UVLORISE
UVLOFALL
UVLOHYS
OUTNOISE
PSRR
Conditions
10 Hz to 100 kHz, VIN = 5 V, VOUT = 3.3 V
10 Hz to 100 kHz, VIN = 5 V, VOUT = 2.5 V
10 Hz to 100 kHz, VIN = 5 V, VOUT = 1.2 V
100 Hz, VIN = 5 V, VOUT = 3.3 V
100 Hz, VIN = 5 V, VOUT = 2.5 V
100 Hz, VIN = 5 V, VOUT = 1.2 V
1 kHz, VIN = 5 V, VOUT = 3.3 V
1 kHz, VIN = 5 V, VOUT = 2.5 V
1 kHz, VIN = 5 V, VOUT = 1.2 V
Min Typ Max Unit
1.60
100
105
100
80
60
65
72
50
50
62
2.19 V
V
mV
µV
rms
µV
rms
µV
rms
dB
dB
dB
dB
dB
dB
1 Accuracy when VOUT is connected directly to ADJ. When the VOUT voltage is set by external feedback resistors, the absolute accuracy in adjust mode depends on the
tolerances of resistors used.
2 Based on an end-point calculation using 0 μA and 150 mA loads.
3 Dropout voltage is defined as the input-to-output voltage differential when the input voltage is set to the nominal output voltage. This applies only for output
voltages above 2.2 V.
4 Start-up time is defined as the time between the rising edge of EN to VOUT being at 90% of its nominal value.
5 Current limit threshold is defined as the current at which the output voltage drops to 90% of the specified typical value. For example, the current limit for a 3.0 V
output voltage is defined as the current that causes the output voltage to drop to 90% of 3.0 V or 2.7 V.
INPUT AND OUTPUT CAPACITOR, RECOMMENDED SPECIFICATIONS
Table 2.
Parameter
MINIMUM INPUT AND OUTPUT CAPACITANCE1
CAPACITOR ESR
Symbol
CMIN
RESR
Conditions
TA = −40°C to +125°C
TA = −40°C to +125°C
Min
0.7
0.001
Typ Max
0.2
Unit
µF
Ω
1 The minimum input and output capacitance should be greater than 0.7 µF over the full range of operating conditions. The full range of operating conditions in the
application must be considered during device selection to ensure that the minimum capacitance specification is met. X7R and X5R type capacitors are recommended;
however, Y5V and Z5U capacitors are not recommended for use with any LDO.
Rev. H | Page 4 of 24

4페이지










ADP162 전자부품, 판매, 대치품
Data Sheet
ADP160/ADP161/ADP162/ADP163
12
A VIN
VOUT
ADP160/
ADP162
B EN
GND
TOP VIEW
(Not to Scale)
Figure 6. 4-Ball WLCSP Pin Configuration, ADP160/ADP162
Table 7. 4-Ball WLCSP Pin Function Descriptions, ADP160/ADP162
Pin No. Mnemonic Description
A1 VIN
Regulator Input Supply. Bypass VIN to GND with a 1 µF or greater capacitor.
B1 EN
Enable Input. Drive EN high to turn on the regulator; drive EN low to turn off the regulator. For automatic
startup, connect EN to VIN.
A2 VOUT
Regulated Output Voltage. Bypass VOUT to GND with a 1 µF or greater capacitor.
B2 GND
Ground.
Rev. H | Page 7 of 24

7페이지


구       성 총 24 페이지수
다운로드[ ADP162.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
ADP160

CMOS Linear Regulators

Analog Devices
Analog Devices
ADP1606

2MHz Synchronous Boost DC-to-DC Converter

ANALOG DEVICES
ANALOG DEVICES

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵