|
|
PDF LS7501 Data sheet ( Hoja de datos )
| Número de pieza | LS7501 | |
| Descripción | TONE ACTIVATED TELEPHONE LINE SWITCH CONTROLLERS | |
| Fabricantes | LSI | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de LS7501 (archivo pdf) en la parte inferior de esta página. Total 4 Páginas | ||
|
No Preview Available !
LSI/CSI
LS7501-7510
U
®
L
LSI Computer Systems, Inc. 1235 Walt Whitman Road, Melville, NY 11747 (516) 271-0400 FAX (516) 271-0405
A3800
TONE ACTIVATED TELEPHONE LINE SWITCH CONTROLLERS
FEATURES:
• Circuit activated by Tone with specific Frequency and
Time Duration.
• Frequency and Time Duration values are mask
programmable.
• Small Signal (as low as - 30 DBM) and Digital Level
Tone signals accommodated.
• On-chip active oscillator network and 32,768 Hz
Crystal generates timing.
• Low power consumption.
• +4.0V to +6V operation (VDD - VSS).
APPLICATIONS:
• Remote telephone line testing
• Remote meter reading
• Security system dialers.
Nov. 1993
CONNECTION DIAGRAM - TOP VIEW
STANDARD 16 PIN PLASTIC DIP
DTO 1
TIME BASE 2
VF OUT 3
VI OUT 4
FDEN 5
DTEN INPUT 6
16 V DD (+V)
15 X2
14 X1
13 DIGITAL TONE
12 AMP IN
11 AMP OUT
GENERAL DESCRIPTION:
The LS7501 - LS7510 are CMOS frequency discriminator
circuits designed to respond to a specific frequency
TONE signal when that frequency is maintained within
+10Hz during a continuous 4.5 second Sample Interval
Time. When a valid TONE occurs the Set Relay Level
output goes high for 20 seconds.
A typical application will use the Set Relay Level output
to temporarily switch the telephone line connection.
Valid Frequencies are mask programmable from 11Hz to
4095 Hz, in 1 Hz steps. Valid Sample Interval Times are
mask-programmable from 0.5 seconds to 8.0 seconds, in
0.5 second steps. Table 1 shows mask programmable
options for the available LS7501 - LS7510 part numbers.
Table 1. MASK PROGRAMMED OPTIONS
Part # Frequency (Hz) Part # Frequency (Hz)
LS7501
LS7502
LS7503
LS7504
LS7505
2683
2713
2743
2773
2833
LS7506
LS7507
LS7508
LS7509
LS7510
2863
2893
2923
2953
2983
NOTE: All Part Numbers are programmed with a Sample
Interval Time of 4.5 seconds. Referring to the LS75XX
Block Diagram (Figure 2) each Part Number has the Set
Relay Level option on Pin 8. The 32 KHz option is on Pin
2 with one exception. LS7502 has the 8Hz option.
SET RELAY PULSE 7
10 RESET
SET RELAY LEVEL 8
9 V SS (-V)
FIGURE 1
CIRCUIT OPERATION:
Referencing Figure 2, an external C is used to generate a
Power-On Reset pulse at Pin 10. When the Frequency Dis-
criminator samples a valid frequency at Pin 13 for an entire
0.5 second sample period, Pin 3 goes high and the Sample
Interval Timer begins timing. If the Pin 13 frequency is not
valid during any subsequent sample period, Pin 3 goes low
and resets the Sample Interval Timer. When Pin 13 fre-
quency is valid for the programmed period of the Sample In-
terval Timer, a high-going pulse occurs at Pin 4. Normally,
Pin 4 externally connects to Pin 6 and the pulse will cause
the Frequency Discriminator to be disabled, enable the Dis-
connect Timer and bring Set Relay Level high at Pin 8.
When the Disconnect Timer times out (20 seconds) a high-
going pulseoccurs at Pin 1. Normally, Pin 1 externally con-
nects to Pin 5 and the pulse will cause the Frequency Dis-
criminator to be enabled, disable the Disconnect Timer and
bring Set Relay Level low at Pin 8. The circuit operating se-
quence begins again.
A digital level Tone signal connects to Pin 13. A small-signal
Tone frequency should be AC coupled to Pin 12 with Pin 11
externally connected to Pin 13. The 32,768 Hz crystal con-
nects between Pin 14 and Pin 15. Pin 10 has an internal
pull-down resistor.
1 page | ||
| Páginas | Total 4 Páginas | |
| PDF Descargar | [ Datasheet LS7501.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| LS7501 | TONE ACTIVATED TELEPHONE LINE SWITCH CONTROLLERS | LSI |
| LS7502 | TONE ACTIVATED TELEPHONE LINE SWITCH CONTROLLERS | LSI |
| LS7503 | TONE ACTIVATED TELEPHONE LINE SWITCH CONTROLLERS | LSI |
| LS7504 | TONE ACTIVATED TELEPHONE LINE SWITCH CONTROLLERS | LSI |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |