|
|
PDF BA3888S Data sheet ( Hoja de datos )
| Número de pieza | BA3888S | |
| Descripción | High-definition sound processor | |
| Fabricantes | ROHM Semiconductor | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de BA3888S (archivo pdf) en la parte inferior de esta página. Total 8 Páginas | ||
|
No Preview Available !
Audio ICs
High-definition sound processor
BA3888S
The BA3888S is a sound processor IC that performs phase and harmonic compensation on audio signals to accurately
reproduce the “rise” section of audio signals that determines the characteristics of the sound, and thus reproduce the
original recording as naturally as possible.
FApplications
VCRs, tape recorders and video equipped television
FFeatures
1) Corrects distortion in the rising section of audio sig-
nals that results from miss-matched speakers and
amplifiers, and reproduces the original sound faith-
fully.
2) To allow application with all types of speakers and
sources, the clarity can be adjusted using DC control.
3) DC control provided for selection of either processor
mode or bypass mode.
4) Bass boost can be set in the range 0dB to 9dB (Typ.)
using external components.
5) A noise gate circuit naturally cuts hiss at low volume.
FAbsolute maximum ratings (Ta = 25_C)
FRecommended operating conditions (Ta = 25_C)
437
1 page  
Audio ICs
BA3888S
The input signal is separated into three regions : bass
(20Hz to 150Hz), middle (150Hz to 2.4kHz) and treble
(2.4kHz to 20kHz). These regions are then joined again
with the middle and treble regions phase shifted -180_
and -360_ respectively with respect to the bass signal.
This phase shift adjusts the delay time characteristic for
each band and minimizes the distortion of the rising sec-
tion of the audio signal.
Amplitude compensation (harmonic compensation)
To maintain appropriate auditory balance for the treble
region that is made up of harmonic components, a high-
speed detector and high-performance VCA circuit are
used for amplitude control of the treble component. The
amount of compensation is determined from a calcula-
tion performed based on the DC level input to the CTL
pin, and the DC level detected from the input signal. The
internal control signal obtained from this calculation com-
pensates the amplitude of the treble component input to
the VCA. This amplitude compensation recovers the har-
monic component, and improves the reproduction clarity
(definition level) of instruments and vocals.
Bass boost
To maintain good balance with the dynamically changing
treble component, it is possible to boost the bass compo-
nent. The amount of bass boost can be set in the range
0dB to 9dB by connecting a resistor between pins 16 and
17. When pins 16 and 17 are not connected, the bass
boost is 0dB, (Typ.), and when they are shorted, the bass
boost is at its maximum value of 9dB.
Noise gate
A high-cut filter is provided to continuously vary the
amount of attenuation depending on the input level, and
reduce the hiss from tape media that is audible at low vol-
ume or on blank sections of tape. This means, that at nor-
mal levels, the attenuation of the high-cut filter is minimal,
and almost no audio information is lost. As the level be-
comes smaller, the attenuation of the high-cut filter grad-
ually increases to cut hiss in a natural sounding way.
Mode switch
The DC voltage on the CTL pin can be used to switch the
IC between processing mode and bypass mode. When
processing mode is selected, the audio signal is en-
hanced using the compensation circuits described above
before being output. When bypass mode is selected, the
signal bypasses all of the compensation circuits, and
only passes through a buffer amplifier before output.
441
5 Page | ||
| Páginas | Total 8 Páginas | |
| PDF Descargar | [ Datasheet BA3888S.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| BA3888S | High-definition sound processor | ROHM Semiconductor |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |