DataSheet.es    


PDF BA5415A Data sheet ( Hoja de datos )

Número de pieza BA5415A
Descripción High-output dual power amplifier
Fabricantes ROHM Semiconductor 
Logotipo ROHM Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de BA5415A (archivo pdf) en la parte inferior de esta página.


Total 10 Páginas

No Preview Available ! BA5415A Hoja de datos, Descripción, Manual

Audio ICs
High-output dual power amplifier
BA5415A / BA5416
The BA5415A and BA5416 are dual power amplifier ICs that operate off a 9V to 15V supply. When driving a 4load
off a 9V supply, the BA5415A does not require a heatsink. The BA5416 uses a lost-cost package. The basic characteris-
tics (total harmonic distortion etc.) of the amplifiers are excellent, and both ICs include a standby switch function.
FApplications
Radio cassette players.
FFeatures
1) High output.
POUT = 5.4W (VCC = 12V, RL = 3and THD = 10%)
POUT = 2.5W (VCC = 9V, RL = 4and THD = 10%)
2) Excellent audio quality.
THD = 0.1% (f = 1kHz, PO = 0.5W)
VNO = 0.3mVrms (Rg = 10k)
RR = 60dB (fRR = 100Hz)
3) Wide operating power suppy voltage range.
VCC = 5.0V to 18.0V (BA5416: 5.0V to 15.0V)
4) Switching noise (“pop” noise) generated when the
power is switched on and off is small.
5) Ripple mixing when motor starts has been pre-
vented.
6) Built-in thermal shutout.
7) Built-in standby switch. Output is not influenced by
the standby pin voltage.
8) “On” mute time does not depend on VCC.
9) Soft clipping.
10) Heatsink not required (for BA5415A, with VCC = 9V
and RL y 4).
FAbsolute maximum ratings (Ta = 25_C)
FRecommended operating conditions (Ta = 25_C)
395

1 page




BA5415A pdf
Audio ICs
FOperation notes
(1) Input circuit
The structure of the input circuit is shown in Fig. 4. The
IC can be used without coupling capacitors, but a maxi-
mum of 0.5µA of bias current (IBIN) flows from the input
pin, so if potentiometer sliding noise results from this,
connect an input capacitor CIN as shown below.
To prevent degradation of the IC characteristics, the input
bias resistor is not built into the IC. Connect an input bias
resistor (RIN) between the input and GND (the recom-
mended value is about 33k).
BA5415A / BA5416
(3) Oscillation countermeasures
We recommend that the capacitor (C1) connected be-
tween the B. S pin and the VCC pin for oscillation preven-
tion be a metal-film component with good temperature
and high-frequency characteristics.
Ceramic capacitors have poor temperature characteris-
tics, so if used, allow sufficient oscillation margin. It is
also possible to connect a capacitor for oscillation pre-
vention between the output and GND (C2).
The oscillation margin depends on the PCB pattern and
the mounting position of the capacitor. Design your PCB
after referring to the application example PCB.
(2) Gain adjustment
The gain is given by the following formula.
RNF)RF
GV = 20log RF
It is possible to reduce the gain by increasing RF, but the
amount of feedback will increase, and oscillation will be
more likely to occur. We recommend that you set the gain
to 30dB or higher.
(4) VCC and GND lines
The Pre. GND and Pow. GND are joined at pin 12, so
there is a chance of crosstalk or degraded distortion per-
formance due to common ground impedance in the PCB
pattern. In addition, the power supply capacitor con-
nected between VCC and GND is influenced by the PCB
pattern, and common VCC and GND impedance may de-
grade the ripple rejection and distortion. Design the PCB
after referring to the application example PCB (the rec-
ommended value for the power supply capacitor is
1000µF of greater).
399

5 Page










PáginasTotal 10 Páginas
PDF Descargar[ Datasheet BA5415A.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
BA5415High-output dual power amplifierROHM Semiconductor
ROHM Semiconductor
BA5415AHigh-output dual power amplifierROHM Semiconductor
ROHM Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar