Datasheet.kr   

EL4331CS-T7 데이터시트 PDF




Intersil Corporation에서 제조한 전자 부품 EL4331CS-T7은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 EL4331CS-T7 자료 제공

부품번호 EL4331CS-T7 기능
기능 Triple 2:1 Mux-Amp AV = 1
제조업체 Intersil Corporation
로고 Intersil Corporation 로고


EL4331CS-T7 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.



전체 10 페이지수

미리보기를 사용할 수 없습니다

EL4331CS-T7 데이터시트, 핀배열, 회로
®
Data Sheet
May 12, 2004
EL4331
FN7162.1
Triple 2:1 Mux-Amp AV = 1
The EL4331 is a triple, very high
speed, 2:1 Multiplexing Amplifier. It is
intended primarily for component video
multiplexing, and is especially suited for pixel switching. The
amplifiers have their gain set to 1, internally. All three
amplifiers are switched simultaneously from their A to B
inputs by the TTL/CMOS compatible, common A/B control
pin.
The EL4331 has a power-down mode, in which the total
supply current drops to less than 1mA. In this mode, each
output will appear as a high impedance.
The EL4331 runs from standard ±5V supplies, and is
available in the narrow 16-pin small outline package. The
package is specified for operation over the full -40°C to
+85°C temperature range.
Pinout
EL4331
(16-PIN SO)
TOP VIEW
Features
• 3ns A-B switching
• 300MHz bandwidth
• Power-down mode
• TTL/CMOS compatible controls
• Fixed gain of 1
• 400V/µs slew rate
• Pb-free available
Applications
• RGB multiplexing
• Picture-in-picture
• Cable driving
• HDTV processing
• Switched gain amplifiers
• ADC input multiplexer
Ordering Information
PART NUMBER PACKAGE
TAPE &
REEL PKG. DWG. #
EL4331CS
16-Pin SO (0.150”)
-
MDP0027
EL4331CS-T7 16-Pin SO (0.150”)
7”
MDP0027
EL4331CS-T13 16-Pin SO (0.150”)
13”
MDP0027
EL4331CSZ
(Note)
16-Pin SO (0.150”)
(Pb-Free)
-
MDP0027
EL4331CSZ-T7 16-Pin SO (0.150”)
(Note)
(Pb-Free)
7”
MDP0027
EL4331CSZ-T13 16-Pin SO (0.150”)
(Note)
(Pb-Free)
13”
MDP0027
NOTE: Intersil Pb-free products employ special Pb-free material
sets; molding compounds/die attach materials and 100% matte tin
plate termination finish, which is compatible with both SnPb and
Pb-free soldering operations. Intersil Pb-free products are MSL
classified at Pb-free peak reflow temperatures that meet or exceed
the Pb-free requirements of IPC/JEDEC J Std-020B.
1 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright © Intersil Americas Inc. 2004. All Rights Reserved. Elantec is a registered trademark of Elantec Semiconductor, Inc.
All other trademarks mentioned are the property of their respective owners.




EL4331CS-T7 pdf, 반도체, 판매, 대치품
Typical Performance Curves (Continued)
EL4331
Switching a Family of DC Levels to a Sine Wave and
Back
Output Response In and Out of Power-Down with a
Family of DC Inputs
Output Power-Down Turn-Off Response
Output Power-Down Turn-On Response
Frequency Response with 150and 5pF
Load
Frequency Response with 240and 5pF
Load
4

4페이지










EL4331CS-T7 전자부품, 판매, 대치품
EL4331
Pin Descriptions
PIN NAME
A1, A2, A3
B1, B2, B3
GND1, GND2, GND3
OUT1, OUT2, OUT3
VCC
VEE
A/B
PD
PIN DESCRIPTION
“A” inputs to amplifiers 1, 2 and 3 respectively
“B” inputs to amplifiers 1, 2 and 3 respectively
These are the individual ground pins for each channel.
Amplifier outputs. Note there is no short circuit protection.
Positive power supply. Typically +5V.
Negative power supply, typically -5V.
Common input select pin, a logic high selects the “A” inputs, logic low selects the “B” inputs. If left to float, this pin
will float high and the “A” channels will be selected.
A logic low puts the part into its power-down mode. Note that when this pin is at a logic high (+5V), it will sink typically
1mA. When pulled low, it will source a few µA, typically < 25µA. This pin should not be left floating.
Applications Information
Circuit Operation
Each multiplexing amplifier has two input stages. The
multiplexing amplifiers switch from their “A” inputs to their “B”
inputs under control of the common A/B select pin. The
switching has a make before break action. Each amplifier is
internally connected for unity gain, allowing larger switching
matrixes to be built up. Note however, that each amplifier
likes to see a load of 250or less; load resistances higher
than this, can lead to excessive peaking. Load capacitance
should be kept down below 40pF, and 40pF requires a load
resistance of 150to keep the output from excessive
peaking. Higher capacitive loads can best be driven using a
series resistor to isolate the amplifier from the reactive load.
The ground pins are used as a reference for the logic
controls. Both A/B and PD are referenced to ground. The
supplies do not have to be symmetrical around ground, but
the logic inputs are referred to the ground pins, and the logic
swing must not exceed the +V supply. Due to the fact that all
three channels share common control pins, the three
grounds have to be at the same potential. One third of the
1mA that PD will sink (at 5V) will be seen at each ground pin.
Also, the individual grounds are internally connected to their
channel compensation capacitor in an effort to keep
crosstalk low.
A/B Switching
Referring to the photographs showing the 0V–0V switching
glitches, it will be noted that slower edges on the A/B control
pin result in switching glitches of somewhat less total energy.
The switching action is a make-before-break, so the two
inputs essentially get mixed at the output for a few
nanoseconds. Note that the two inputs are buffered, so there
is no component of one input injected into the other input.
The input impedance does not depend on whether an input
has been selected.
Power-Down
Referring to the photographs of the power-down function and
Figure 4, it will be noted that there is a considerable glitch in
the output as the part powers down. It will also be noted that
the power-down time is considerably longer than power up,
1µs compared to 150ns. In power-down mode, the whole
amplifier, its reference and bias lines are all powered down.
At the same time, the output stage has been configured so
that the powered down output appears as a high impedance.
This allows circuits such as the multiplexer shown in
application #4 to be realized, although the price is the
significant output disturbance as one part turns on before the
other has fully turned off.
Single Supply Operation
Due to the fact that video signals often have negative sync
levels and invariably require ground to be within the signal
swing, running the EL4331 on a single supply rail
compromises many aspects of its performance. It is difficult
to generate a solid, clean, pseudo ground a few volts away
from ground without using more power, and components
than simply providing a negative power rail. A signal ground
has to be capable of handling all the return currents from all
the inputs, as well as the outputs, from DC to frequencies in
excess of 400MHz. While this is by no means impossible, a
negative rail can be generated from a standard +5V rail for a
couple of dollars and a square inch, or less, of board space.
However, a pseudo ground can be derived with for example
an LM336, to give an “AC ground” 2.5V above 0V. The logic
inputs will need some form of level shifting to ensure that the
logic “1” and “0” specifications can be met. The pseudo
ground must be well bypassed to the real ground; note that
the pseudo ground will have to sink/source all the current
that flows in the internal compensation capacitors during
slewing. This can easily be several milliamps in a few
nanoseconds. If the pseudo ground “moves” because one
channel is forcing current into the derived ground, cross-talk
into the other two channels will become very significant.
7

7페이지


구       성 총 10 페이지수
다운로드[ EL4331CS-T7.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
EL4331CS-T13

Triple 2:1 Mux-Amp AV = 1

Intersil Corporation
Intersil Corporation
EL4331CS-T7

Triple 2:1 Mux-Amp AV = 1

Intersil Corporation
Intersil Corporation

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵