EL6255C Datasheet PDF - Elantec Semiconductor
| Part Number | EL6255C | |
| Description | 4-Channel Laser Diode Driver + Oscillator | |
| Manufacturers | Elantec Semiconductor | |
| Logo |  |
|
|
There is a preview and EL6255C download ( pdf file ) link at the bottom of this page. Total 2 Pages | ||
Preview 1 page No Preview Available !
EL6255C - Product Brief
4-Channel Laser Diode Driver + Oscillator
Features
• Shrink-small package outline
• Voltage-controlled output current
source to 150 mA per channel,
requiring one external set resistor
per channel
• Current-controlled output current
source to 150 mA per channel
• Rise time = 1.0 ns
• Fall time = 1.1 ns
• On chip oscillator with frequency
and amplitude control by use of
external resistors to ground
• Oscillator to 500 MHz
• Oscillator to 100 mA pk/pk
• Single +5V supply (±10%)
• Current amplification = 100
• Disable feature for power-up
protection and power savings
• TTL/CMOS control signals
Applications
• DVD drives
• CD-RW applications
• Writable optical drives
• Laser diode current switching
Ordering Information
Part No
EL6255CU
Temp. Range
0°C to +70°C
Package
QSOP-16
Outline #
MDP0040
General Description
The EL6255C is a high-performance four channel laser diode current
amplifier that provides controlled current to a grounded laser diode.
The four amplifiers can provide up to 150 mA per channel of DC or
pulsed current. Channels 2, 3, and 4 must be used as the write chan-
nels, with switching speeds of one nanosecond rise/fall time. All four
channels are summed together at the IOUT output, allowing the user to
create multilevel waveforms in order to optimize laser diode perfor-
mance. The level of the output current is set by an analog voltage
applied to an external resistor which converts the voltage into a current
at the IIN pin (virtually ground). The current seen at this pin is then
amplified by 100X to become a current source at pin IOUT.
An on-chip 500 MHz oscillator is provided to allow current modula-
tion when in the read mode. This is turned on when the OSCEN pin is
held high (floating not recommended). Complete control of amplitude
and frequency is set by two external resistors connected to ground at
pins RFREQ and RAMP (see graphs in this data sheet for further
explanation). The oscillator will also turn off whenever any of the
OUTEN pins for channels 2, 3, and 4 (the write channels) are low (see
truth table).
Output current pulses are enabled when an ‘L’ signal is applied to the
OUTEN pins. No output current flows when OUTEN is ‘H’, and addi-
tional laser diode protection is provided since the OUTEN input will
float high when open. Complete IOUT shut-off is also achieved by
holding the ENABLE pin low, which will override the OUTEN con-
trol pins.
Connection Diagram
IINR 1
IIN2 2
RFREQ 3
IIN3 4
IIN4 5
OUTEN2 6
OUTEN3 7
OUTEN4 8
16 VCC
15 VCC
14 IOUT
13 GND
12 RAMP
11 ENABLE
10 OSCEN
9 VCC
Note: All information contained in this data sheet has been carefully checked and is believed to be accurate as of the date of publication; however, this data sheet cannot be a “controlled document”. Current revisions, if any, to these
specifications are maintained at the factory and are available upon your request. We recommend checking the revision level before finalization of your design documentation.
© 2001 Elantec Semiconductor, Inc.
|
| |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for EL6255C electronic component. |
| Information | Total 2 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ EL6255C.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | MFRS |
| EL6255 | The function is 4-Channel Laser Diode Driver + Oscillator. Elantec Semiconductor | |
| EL6255C | The function is 4-Channel Laser Diode Driver + Oscillator. Elantec Semiconductor | |
| EL6255CU | The function is 4-Channel Laser Diode Driver + Oscillator. Elantec Semiconductor | |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
EL62
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||