|
|
PDF DW9255 Data sheet ( Hoja de datos )
| Número de pieza | DW9255 | |
| Descripción | 35.42MHz SAW Filter for GPS Receivers | |
| Fabricantes | Mitel Networks Corporation | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de DW9255 (archivo pdf) en la parte inferior de esta página. Total 5 Páginas | ||
|
No Preview Available !
DWD9W2925555
35.42MHz SAW Filter for GPS Receivers
DS3861 - 3.1 November 1997
The DW9255 is a Surface Acoustic Wave (SAW) bandpass
filter for use with the GP2000 Global Positioning System
(GPS) receiver chip-set, available from Mitel Semiconductor.
It is pre-tuned to the exact 2nd IF filter requirements of the
GP2010 & GP2015 RF front-end devices, with a centre-
frequency of 35.42MHz. The response is tuned for a flat
passband, steep stopband and uniform passband group-delay
with 3 external inductors. The device is realised on a Lithium
Tantalate substrate and housed in a small leadless ceramic
Surface Mount package.
The DW9255 gives significant improvement in correlated
GPS Signal-to-Noise Ratio (SNR) performance compared to
conventional LC bandpass filter schemes. This aids satellite
signal acquisition and tracking capability from the GP2000
GPS chip-set. This device effectively filters out-of-band
(unwanted) noise in the GPS signal. The Automatic Gain
Control (AGC) within the GP2010 and GP2015 RF Front-end
devices will then operate only on in-band noise for optimum
gain and superior correlated GPS signal strength.
FEATURES
s Centre Frequency of 35.42MHz
s Insertion Loss of 17dB ±1dB (typical)
s 1dB Bandwidth 1.9MHz (typical)
s Passband Ripple 0.8dB (typical)
s Low Profile Ceramic Surface Mount Package
s Operating Temperature Range -40° to +85°C
APPLICATION
s Commercial Global Positioning
RELATED PRODUCTS AND PUBLICATIONS
Data
Part
Description
Reference
GP2010 GPS receiver RF Front-end
DS4056
GP2015 Miniature GPS receiver
RF Front-end
DS4374
2
GND 3
1
12 GND
GND 4
GND 5
11
DW9255
10
GND
GND
GND 6
7
9 GND
8
LCS12/1
2
GND 3
1
12 GND
GND 4
GND 5
11
DW9255
10
GND
GND
GND 6
7
9 GND
8
LCS12/4
Fig.1 Pinout
1
1 page  
http://www.mitelsemi.com
North America
Tel: +1 (770) 486 0194
Fax: +1 (770) 631 8213
World Headquarters - Canada
Tel: +1 (613) 592 2122
Fax: +1 (613) 592 6909
Asia/Pacific
Tel: +65 333 6193
Fax: +65 333 6192
Europe, Middle East,
and Africa (EMEA)
Tel: +44 (0) 1793 518528
Fax: +44 (0) 1793 518581
Information relating to products and services furnished herein by Mitel Corporation or its subsidiaries (collectively “Mitel”) is believed to be reliable. However, Mitel assumes no
liability for errors that may appear in this publication, or for liability otherwise arising from the application or use of any such information, product or service or for any infringement of
patents or other intellectual property rights owned by third parties which may result from such application or use. Neither the supply of such information or purchase of product or
service conveys any license, either express or implied, under patents or other intellectual property rights owned by Mitel or licensed from third parties by Mitel, whatsoever.
Purchasers of products are also hereby notified that the use of product in certain ways or in combination with Mitel, or non-Mitel furnished goods or services may infringe patents or
other intellectual property rights owned by Mitel.
This publication is issued to provide information only and (unless agreed by Mitel in writing) may not be used, applied or reproduced for any purpose nor form part of any order or
contract nor to be regarded as a representation relating to the products or services concerned. The products, their specifications, services and other information appearing in this
publication are subject to change by Mitel without notice. No warranty or guarantee express or implied is made regarding the capability, performance or suitability of any product or
service. Information concerning possible methods of use is provided as a guide only and does not constitute any guarantee that such methods of use will be satisfactory in a specific
piece of equipment. It is the user’s responsibility to fully determine the performance and suitability of any equipment using such information and to ensure that any publication or
data used is up to date and has not been superseded. Manufacturing does not necessarily include testing of all functions or parameters. These products are not suitable for use in
any medical products whose failure to perform may result in significant injury or death to the user. All products and materials are sold and services provided subject to Mitel’s
conditions of sale which are available on request.
M Mitel (design) and ST-BUS are registered trademarks of MITEL Corporation
Mitel Semiconductor is an ISO 9001 Registered Company
Copyright 1999 MITEL Corporation
All Rights Reserved
Printed in CANADA
TECHNICAL DOCUMENTATION - NOT FOR RESALE
5 Page | ||
| Páginas | Total 5 Páginas | |
| PDF Descargar | [ Datasheet DW9255.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| DW9255 | 35.42MHz SAW Filter for GPS Receivers | Mitel Networks Corporation |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |