|
|
PDF SIW1711 Data sheet ( Hoja de datos )
| Número de pieza | SIW1711 | |
| Descripción | BLUETOOTH RADIO MODEM | |
| Fabricantes | RF Micro Devices | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de SIW1711 (archivo pdf) en la parte inferior de esta página. Total 12 Páginas | ||
|
No Preview Available !
0
Features
• Single chip IC with 2.4 GHz
transceiver and GFSK modem with
digital interface to external baseband
processor.
• Fully compliant with Bluetooth
specification 1.1 and 1.2.
• Supports multiple external reference
clocks or crystal frequencies with on-
chip reference PLL.
• Direct-conversion architecture with
no external channel filter or VCO
resonator components.
• Single-ended RX/TX pins reduce
system BOM cost by eliminating a
balun. On-chip RX/TX switching
eliminates external RX/TX switch.
• Typical -85 dBm receiver sensitivity
with excellent interference rejection
performance.
• Class 2 and 3 transmit output power
up to +4 dBm with output power
control loop for accurate power
control.
• Hardware AGC dynamically adjusts
receiver performance in changing
environments.
• Low out-of-band spurious emissions
prevents interference with mobile
phone frequencies.
• Option for Class 1 designs with
RX/TX switch control and multiple
modes of gain control.
• On-chip voltage regulation simplifies
voltage input requirement. Regulator
bypass mode enables use of external
regulator.
• 1.8 Volt analog and digital core
voltages; 1.63 Volt to 3.63 Volt
external I/O interface voltage.
• Low power consumption in active and
standby modes.
SiW1711
BLUETOOTH® RADIO
MODEM
RF_IN
Voltage Regulator and Power
Distribution
LNA
0
90
ADC
PLL
Control
VCO/
PLL
IDAC
PWR
CNTL
RF_OUT
DRIVER
0
90
XTAL_P/CLK
XTAL_N
BB_CLK
Clock Generation and
Distribution
SPI_SS
SPI_TXD
SPI_RXD
SPI_CLK
Serial Programming
Interface (SPI)
ADC
DAC
GFSK
MODEM
RX_TX_DATA
CD_TXEN
DAC
Control
Register
File
System
Control
Logic
ENABLE_RM
HOP_STROBE
RESET_N
TX_RX_SWITCH
Product Description
The SiW1711™ Radio Modem is Silicon Wave's third-generation radio modem for
Bluetooth® wireless communications and is based on 0.18µm CMOS technology. This
highly integrated transceiver was specifically designed to meet the rigorous RF perfor-
mance required for integrating Bluetooth into mobile phone applications.
The SiW1711 Radio Modem combines a 2.4GHz radio transceiver and Gaussian Fre-
quency Shift Keying (GFSK) modem with digital control functions. The IC also incorpo-
rates analog and digital voltage regulators, a reference Phase Lock Loop (PLL) to
enable multiple input frequencies, and a power-on-reset (POR) circuit.
The SiW1711 Radio Modem uses direct conversion (zero-IF) architecture. This allows
digital filtering for excellent interference rejection as compared to low IF solutions, and
also results in fewer spurious responses. The receiver has excellent sensitivity due to a
low noise RF design combined with an advanced modem design. A fast hardware AGC
enables full discovery of any device within the dynamic range of the receiver (solves
near-far issues). The transmitter can maintain a stable output power level up to +4dBm
for class 2 operation, which in combination with the excellent receiver performance
ensures the maximum possible range at the lowest system cost.
The device is available in a 32-pin QFN package with 5 x 5 x 1 mm dimensions. Known
good die with bumps is also available. Operating temperature range is guaranteed from
-40°C to +85°C with available extended high temperature range to 105°C.
Optimum Technology Matching® Applied
Si BJT
Si Bi-CMOS
GaAs HBT
GaAs MESFET
9SiGe HBT
Si CMOS
GaInP/HBT
GaN HEMT
SiGe Bi-CMOS
60 0047 R00Grf SiW1711 Radio Modem IC DS
September 30, 2004
Ordering Information
SiW1711
Bluetooth® Radio Modem
RF Micro Devices, Inc.
7628 Thorndike Road
Greensboro, NC 27409, USA
Tel (336) 664 1233
Fax (336) 664 0454
http://www.rfmd.com
1 of 12
1 page  
SiW1711
Digital Regulator Specification (TOP = 25°C)
Parameter
Output voltage
Line regulation
Load regulation
Dropout voltage
Output maximum current
Quiescent current
Ripple rejection
Description
(I OUT = 10 mA)
(I OUT = 0 mA, VBATT_DIG = 2.3 V to 3.63 V)
(I OUT = 3 mA to 80 mA)
(I OUT = 10 mA)
–
–
f RIPPLE = 400 Hz
Min
1.55
–
–
–
–
–
–
Typ
1.85
8.0
9.0
–
–
10
40
Internal Analog Voltage Regulator Specification (TOP=+25°C, VBATT_ANA = 3.3 V)
Parameter
Description
Min Typ
Output voltage (40 mA load) –
1.71
1.80
Ripple rejection
–
– 20
Radio Specification
Parameter
VCO operating range
PLL lock time
Frequency
–
Description
Min
2402
–
Typ
–
55
Max
2.16
–
–
250
80
–
–
Max
1.89
–
Max
2480
100
Unit
V
mV
mV
mV
mA
µA
dB
Unit
V
dB
Unit
MHz
µs
RF Impedances
Parameter1
Description
TX On
RF impedance
TX Off
RX On
RX Off
1The impedance values are for typical samples in 32-pin QFN package.
Min Typ Max
– 448//0.6 –
– 53.1//2.2 –
– 267//1.1 –
– 23.4//0 –
Unit
Ω/pF
Ω/pF
Ω/pF
Ω/pF
Receiver Specification1
(VBATT_ANA, VBATT_DIG=3.3V, VCC=int. analog reg. output, and nominal2 Bluetooth test conditions)
Parameter
Description
Min
Typ
Max
Unit
Receiver
sensitivity
BER < 0.1%
–
-85.0
-80.0
dBm
Maximum usable signal
BER < 0.1%
-10 0
– dBm
C/I co-channel
(0.1% BER)
Co-channel selectivity
– 8.0 11.0 dB
C/I 1MHz
(0.1% BER)
Adjacent channel selectivity
– -4.0 0
dB
C/I 2MHz
(0.1% BER)
C/I ≥3MHz
(0.1% BER)
2nd adjacent channel selectivity
3rd adjacent channel selectivity
–
-38.0
-35.0
dB
– -43 -40 dB
Out-of-band
blocking3
30MHz to 2000MHz
2000MHz to 2399MHz
2498MHz to 3000MHz
3000MHz to 12.75GHz
-10 –
-27 –
-27 –
-10 –
– dBm
– dBm
– dBm
– dBm
Intermodulation
Max interferer level to maintain 0.1% BER,
interference signals at 3 MHz and 6 MHz offset.
-39
-36
– dBm
Receiver spurious
emission
30MHz to 1GHz
1 GHz to 12.75 GHz
– – -57 dBm
– – -47 dBm
1Measured with a proper matching circuit without bandpass filter.
2Nominal and extreme Bluetooth test conditions as defined by the Bluetooth Test and Interoperability Working Group published RF Test
Specification 1.1.
3Out-of-band blocking guaranteed by design.
60 0047 R00Grf SiW1711 Radio Modem IC DS
5 of 12
5 Page 
Product Marking
32-Pin, QFN Drawing
Pin 1 Corner
Pin 1 Bar
SIW
Trace Code
Lot Number
XXXXXX
LLLLL
SiW1711
Part Number
Operational Temperature Range1
SiW1711FIF
Industrial
SiW1711FIF-T13
Industrial
SiW1711DIF-B
Industrial
SiW1711DIF-T13
Industrial
1 Industrial temperature range: -40°C to +85°C
Package
32-pin QFN
32-pin QFN
KGD with bumps
KGD with bumps
Ordering Quantity
490 per tray
5,000 on 13” reel
100 per waffle pack
5,000 on 13” reel
60 0047 R00Grf SiW1711 Radio Modem IC DS
11 of 12
11 Page | ||
| Páginas | Total 12 Páginas | |
| PDF Descargar | [ Datasheet SIW1711.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| SIW1711 | BLUETOOTH RADIO MODEM | RF Micro Devices |
| SIW1711DIF-B | BLUETOOTH RADIO MODEM | RF Micro Devices |
| SIW1711DIF-T13 | BLUETOOTH RADIO MODEM | RF Micro Devices |
| SIW1711FIF | BLUETOOTH RADIO MODEM | RF Micro Devices |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |