Datasheet.kr   

SK100E116 데이터시트 PDF




Semtech Corporation에서 제조한 전자 부품 SK100E116은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


 

PDF 형식의 SK100E116 자료 제공

부품번호 SK100E116 기능
기능 Quint Differential Line Receiver
제조업체 Semtech Corporation
로고 Semtech Corporation 로고


SK100E116 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.



전체 4 페이지수

미리보기를 사용할 수 없습니다

SK100E116 데이터시트, 핀배열, 회로
HIGH-PER.ORMANCE PRODUCTS
Description
.eatures
SK10/100E116
Quint Differential
Line Receiver
The SK10/100E116 is a quint differential line receiver
designed for use in new, high-performance ECL systems.
The receiver design features clamp circuitry to cause a
defined output state if both the inverting and non-inverting
inputs are left open; in this case the Q output goes low,
while the Q* output goes high. This feature makes the
device ideal for twisted pair applications.
If both inverting and non-inverting inputs are at an equal
potential of >–2.9V, the receiver does not go to a defined
state, but rather shares current in normal differential
amplifier fashion, producing output voltage levels midway
between high and low. This may even cause the device to
oscillate.
• 500 ps Maximum Propagation Delay
• Extended VEE Range of –4.2V to –5.5V
• VBB Output for Single-Ended Reception
• Internal 75KInput Pull-Down Resistors
• ESD Protection of >4000V
• Fully Compatible with MC10E/100E116
• Specified Over Industrial Temperature Range:
–40oC to +85oC
• Available in 28-Pin PLCC Package
PIN Description
The SK10/100E116 provides VBB output for either single-
ended use or as a DC bias for AC coupling to the device.
The VBB output pin should be used only as a DC bias for
the E116 as its current sink/source capability is limited.
Whenever used, the VBB pin should be bypassed to VCC
via a 0.01 µF capacitor.
Pin
D0, D0*–D4, D4*
Q0, Q0*-Q4, Q4*
VBB
VCC0
.unction
Differential Input Pairs
Differential Output Pairs
Reference Voltage Output
VCC to Output
.unctional Block Diagram
D0
D0*
D1
D1*
D2
D2*
D3
D3*
D4
D4*
VBB
Revision 1 /.ebruary 21, 2001
Q0
Q0*
Q1
Q1*
Q2
Q2*
Q3
Q3*
Q4
Q4*
D3* 26
D2 27
D2* 28
VEE 1
VBB 2
D0 3
D0* 4
PLCC
TOPVIEW
18 Q3*
17 Q3
16 VCC
15 Q2*
14 Q2
13 VCC0
12 Q1*
1 www.semtech.com




SK100E116 pdf, 반도체, 판매, 대치품
SK10/100E116
HIGH-PER.ORMANCE PRODUCTS
AC Characteristics (continued)
Notes:
1. 10EL circuits are designed to meet the DC specifications shown in the table after thermal equilibrium has
been established. The circuit is in a test socket or mounted on a printed circuit board and transverse
airflow greater than 500 lfpm is maintained. Outputs are terminated through a 50resistor to VCC2.0V.
2. 100K circuits are designed to meet the DC specification shown in the table where transverse airflow
greater than 500 lfpm is maintained.
3. Minimum input swing for which AC parameters guaranteed.
4. CMR range is referenced to the most positive side of the differential input signal. Normal operation is
obtained if the high level falls within the specified range and the peak-to-peak voltage lies between
VPP(min) and 1V. The lower end of the CMR range varies 1:1 with VCC and is equal to VCC - 2.0V.
5. Voltages referenced to VCC = 0V (ECL mode).
6. Within device skew is defined as indentical transition on similar path through a device.
7. Duty cycle is defined only for differential operation when the delays are measured from the crosspoint of
the inputs to the crosspoints of the outputs.
8. For standard ECL DC Specifications, refer to the ECL Logic Family Standard DC Specifications Data
Sheet.
9. Voltages are referenced to V = 0V (ECL Mode).
CC
10. For part ordering description, see HPP Part Ordering Information Date Sheet.
Ordering Information
Ordering Code
SK10E116PJ
SK10E116PJT
SK100E116PJ
SK100E116PJT
Package ID
28-PLCC
28-PLCC
28-PLCC
28-PLCC
Temperature
Range
Industrial
Industrial
Industrial
Industrial
Contact Information
Division Headquarters
10021 Willow Creek Road
San Diego, CA 92131
Phone: (858) 695-1808
FAX: (858) 695-2633
Semtech Corporation
High-Performance Products Division
Revision 1 /.ebruary 21, 2001
4
Marketing Group
1111 Comstock Street
Santa Clara, CA 95054
Phone: (408) 566-8776
FAX: (408) 727-8994
www.semtech.com

4페이지












구       성 총 4 페이지수
다운로드[ SK100E116.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
SK100E111

1:9 Differential Clock Driver

Semtech Corporation
Semtech Corporation
SK100E111PJ

1:9 Differential Clock Driver

Semtech Corporation
Semtech Corporation

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵