|
|
Número de pieza | BU4551B | |
Descripción | Quad 2-channel analog multiplexer / demultiplexer | |
Fabricantes | ROHM Semiconductor | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de BU4551B (archivo pdf) en la parte inferior de esta página. Total 19 Páginas | ||
No Preview Available ! Datasheet
General Purpose CMOS Logic IC
Quad 2ch Analog Multiplexer/Demultiplexer
BU4551B BU4551BF BU4551BFV
General Description
The BU4551B, BU4551BF, BU4551BFV are
multiplexers/demultiplexers with capabilities of
selection and mixture of analog signal and digital
signal.
This series are configured with quad 2 channels
input/output. The digital signal of the control terminal
turns on the corresponding switch of each channel.
The large am plitude voltage (VDD-VEE) can be
switched by the control signal with small logical
amplitude voltage (VDD-VSS).
Key Specifications
Operating Supply Voltage Range:
Input Voltage Range:
Operating Temperature Range:
3V to 16V
VSS to VDD
-40°C to +85°C
Packages
DIP16
SOP16
SSOP-B16
W(Typ) x D(Typ) x H(Max)
19.40mm x 6.50mm x 7.95mm
10.00mm x 6.20mm x 1.71mm
5.00mm x 6.40mm x 1.35mm
Features
Low power consumption
Wide operating supply voltage
High input impedance
DIP16
SOP16
Truth Table
CONTROL
0
1
SSOP-B16
ON SWITCH
W0,X0,Y0,Z0
W1,X1,Y1,Z1
〇Product structure : Silicon monolithic integrated circuit
.www.rohm.com
© 2015 ROHM Co., Ltd. All rights reserved.
TSZ22111 • 14 • 001
〇This product has no designed protection against radioactive rays
1/16
TSZ02201-0RDR0GZ00310-1-2
08.Jan.2015 Rev.001
1 page BU4551B BU4551BF BU4551BFV
Waveforms of Switching Characteristics
W0~W1
X0~X1
Y0~Y1
Z0~Z1
(INPUT)
VDD
VEE
50%
W/X/Y/Z
(OUTPUT)
50%
tPLH
tPHL
Figure 1. Propagation Delay Time
(IN→OUT) (tPLH,tPHL)
VDD
CONTROL
(INPUT)
VSS
50%
W/X/Y/Z
(OUTPUT)
(A,B,C,IN
HIBIT)→O
UT)
(tPLH,tPHL)
T
50%
90%
tPZH
tPHZ
Figure 3. Propagation Delay Time
(CONTROL→OUT) (tPLH,tPHL)
VDD
CONTROL
(INPUT)
VSS
50%
W/X/Y/Z
(OUTPUT)
50%
10%
tPZL
tPLZ
Figure 5. Propagation Delay Time
(CONTROL→OUT) (tPZL,tPLZ)
VDD
CONTROL
W/X/Y/Z
W0 to W1
X0 to X1
Y0 to Y1
IN Z0 to Z1
RL
VEE, VSS
Figure 2. Test Circuit 1 (tPLH,tPHL)
OUT
CL
VDD
CONTROL
W/X/Y/Z
VDD
W0 to W1
X0 to X1
Y0 to Y1
Z0 to Z1
RL
VEE, VSS
Figure 4. Test Circuit 2 (tPZH,tPHZ)
OUT
CL
VDD
CONTROL
RL
W/X/Y/Z
W0 to W1
X0 to X1
Y0 to Y1
Z0 to Z1
VEE, VSS
Figure 6. Test Circuit 3 (tPZL,tPLZ)
CL
OUT
www.rohm.com
© 2015 ROHM Co., Ltd. All rights reserved.
TSZ22111 • 15 • 001
5/16
TSZ02201-0RDR0GZ00310-1-2
08.Jan.2015 Rev.001
5 Page BU4551B BU4551BF BU4551BFV
Operational Notes – continued
11. Unused Input Pins
Input pins of an IC are often connected to the gate of a MOS transistor. The gate has extremely high impedance and
extremely low capacitance. If left unconnected, the electric field from the outside can easily charge it. The small
charge acquired in this way is enough to produce a significant effect on the conduction through the transistor and
cause unexpected operation of the IC. So unless otherwise specified, unused input pins should be connected to the
power supply or ground line.
12. Regarding the Input Pin of the IC
In the construction of this IC, P-N junctions are inevitably formed creating parasitic diodes or transistors. The
operation of these parasitic elements can result in mutual interference among circuits, operational faults, or physical
damage. Therefore, conditions which cause these parasitic elements to operate, such as applying a voltage to an
input pin lower than the ground voltage should be avoided. Furthermore, do not apply a voltage to the input pins
when no power supply voltage is applied to the IC. Even if the power supply voltage is applied, make sure that the
input pins have voltages within the values specified in the electrical characteristics of this IC.
13. Ceramic Capacitor
When using a ceramic capacitor, determine the dielectric constant considering the change of capacitance with
temperature and the decrease in nominal capacitance due to DC bias and others.
14. Area of Safe Operation (ASO)
Operate the IC such that the output voltage, output current, and power dissipation are all within the Area of Safe
Operation (ASO).
www.rohm.com
© 2015 ROHM Co., Ltd. All rights reserved.
TSZ22111 • 15 • 001
11/16
TSZ02201-0RDR0GZ00310-1-2
08.Jan.2015 Rev.001
11 Page |
Páginas | Total 19 Páginas | |
PDF Descargar | [ Datasheet BU4551B.PDF ] |
Número de pieza | Descripción | Fabricantes |
BU4551B | Quad 2-channel analog multiplexer / demultiplexer | ROHM Semiconductor |
BU4551BF | Quad 2-channel analog multiplexer / demultiplexer | ROHM Semiconductor |
BU4551BFV | Quad 2-channel analog multiplexer / demultiplexer | ROHM Semiconductor |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |