DataSheet.es    


PDF BU8311KS Data sheet ( Hoja de datos )

Número de pieza BU8311KS
Descripción Panel interface
Fabricantes ROHM Semiconductor 
Logotipo ROHM Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de BU8311KS (archivo pdf) en la parte inferior de esta página.


Total 12 Páginas

No Preview Available ! BU8311KS Hoja de datos, Descripción, Manual

Communication ICs
Panel interface
BU8310AK / BU8311KS / BU8313K
The BU8310AK, BU8311KS, and BU8313K are large-scale integrated circuits for telephones, which enable a serial in-
put / output interface between the key input required for telephone panel boards and LED control functions. They reduce
the number of wiring harnesses needed between the main board in the telephone and the panel board, and take some
of the processing load off the main CPU.
FApplications
Telephones and cordless telephones
FFeatures
1) Keypad matrix interface
1 Key input is output as 16-bit serial data.
2 Internal chattering prevention circuit built into the
key input circuit.
2) LED interface
1 LED control commands input as 16-bit serial data.
2 Bits with a pattern generator and pattern register
can be assigned three independent flashing pat-
terns in addition to being lighted or off.
3 Power consumption can be reduced using RST
pin input.
4 LED on and off control can be initiated using ENA
pin input or by commands setting all LEDs valid or
invalid.
277

1 page




BU8311KS pdf
Communication ICs
BU8310AK / BU8311KS / BU8313K
FInput / output circuits
281

5 Page





BU8311KS arduino
Communication ICs
FOperation notes
(1) Serial output of key data when several keys are
pressed at the same is as shown below.
BU8310AK / BU8311KS / BU8313K
(3) When the power supply is turned on, the internal reg-
isters should be reset using either RST pin input or the
register reset command.
(4) If the RST pin is set to LOW or the register reset com-
mand is executed while data is being output, the SDO
output logic is not reset.
(5) If the D, P, and Q registers are rewritten, all eight bits
should be written, and not just the pertinent bits.
The key data when 32 and 43 are pressed at the same
time will be the same as the key data when 33 and 42
are pressed at the same time.
(2) Pressing different keys
When a different key is pressed from the one already
pressed, KD is turned temporarily to provide notification
of the change.
(6) Operation states in response to RST, KSCN and ENA pin input
287

11 Page







PáginasTotal 12 Páginas
PDF Descargar[ Datasheet BU8311KS.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
BU8311KSPanel interfaceROHM Semiconductor
ROHM Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar