DataSheet.es    


PDF MAX881R Data sheet ( Hoja de datos )

Número de pieza MAX881R
Descripción Low-Noise Bias Supply in MAX with Power-OK for GaAsFET PA
Fabricantes Maxim Integrated 
Logotipo Maxim Integrated Logotipo



Hay una vista previa y un enlace de descarga de MAX881R (archivo pdf) en la parte inferior de esta página.


Total 8 Páginas

No Preview Available ! MAX881R Hoja de datos, Descripción, Manual

19-1372; Rev 1; 6/98
EVAALVUAAILTAIOBNLEKIT
Low-Noise Bias Supply in µMAX
with Power-OK for GaAsFET PA
General Description
The MAX881R low-noise, inverting power supply is
designed for biasing GaAsFET power amplifiers in
portable wireless applications. This device is a charge-
pump inverter followed by a negative linear regulator.
The input voltage range is 2.5V to 5.5V. The output is
preset at -2.0V or can be set, using two resistors, to any
voltage from -0.5V to (-VIN + 0.6V). It can deliver up to
4mA. The internal linear regulator also filters the output
to 1mVp-p ripple and noise.
Other features include a power-OK (POK) output that sig-
nals when the negative voltage is within 7.5% of its set
point. It protects the GaAsFET by not allowing power to
be applied to the GaAsFET’s drain until it is properly
biased. The signal can be routed either to a microcon-
troller or directly to a switch at the GaAsFET drain. The
MAX881R is available in a space-saving 10-pin µMAX
package.
Applications
Cell Phones
PCS Phones
PHS Phones
Wireless Handsets
Wireless Modems
Two-Way Pagers
Mobile Radios
Wireless Computers
Typical Operating Circuit
Features
o Small µMAX Package
o 1mVp-p Output Voltage Ripple and Noise
o Power-OK Signal to Control GaAsFET Drain
Switch
o 0.05µA Logic-Controlled Shutdown
o 1ms Guaranteed Start-Up
o 2.5V to 5.5V Input
o -0.5V to (-VIN + 0.6V) Output at up to 4mA
o Operates with One 4.7µF and Three 0.22µF
Capacitors (no inductors needed)
PART
MAX881REUB
Ordering Information
TEMP. RANGE
-40°C to +85°C
PIN-PACKAGE
10 µMAX
Pin Configuration
INPUT
2.5V TO 5.5V
ON
OFF
IN OUT
MAX881R
SHDN
C1+
C1-
NEGOUT FB
POK
GND
OUTPUT
-2V (OR ADJ)
4mA, 1mVp-p
RIPPLE
CONTROLS
GaAsFET PA’s
DRAIN SWITCH
TOP VIEW
C1+ 1
C1- 2
NEGOUT 3
POK 4
SHDN 5
MAX881R
µMAX
10 IN
9 N.C.
8 GND
7 OUT
6 FB
N.C. = NOT INTERNALLY CONNECTED
________________________________________________________________ Maxim Integrated Products 1
For free samples & the latest literature: http://www.maxim-ic.com, or phone 1-800-998-8800.
For small orders, phone 408-737-7600 ext. 3468.

1 page




MAX881R pdf
Low-Noise Bias Supply in µMAX
with Power-OK for GaAsFET PA
Pin Description
PIN NAME
FUNCTION
1 C1+ Positive Terminal for C1
2 C1- Negative Terminal for C1
3
NEGOUT
Negative Output Voltage (unregulated)
4
POK
Active-Low, Open-Drain Power-OK Output. Goes low when OUT reaches 92.5% of its set value.
5
SHDN
Active-Low, Logic-Level Shutdown Input. Connect to IN for normal operation. Do not leave this pin
unconnected.
Dual-Mode™ Feedback Input. When FB is connected to GND, the output is preset to -2V. To select
6 FB other voltages, connect FB to an external resistor-divider (Figure 4). Do not leave this pin
unconnected.
7
OUT
Regulated Negative Output Voltage
8
GND
Ground
9
N.C.
No Connection. Not internally connected.
10 IN Positive Power-Supply Input
Dual-Mode is a trademark of Maxim Integrated Products.
SHDN
C1+
C1
C1-
CHARGE PUMP
NEGOUT
C2
IN
C3
OUT
C4
FB
0.5V 0.4625V
MAX881R
POK
GND
Figure 1. Functional Diagram
_______________________________________________________________________________________ 5

5 Page










PáginasTotal 8 Páginas
PDF Descargar[ Datasheet MAX881R.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
MAX881Low-Noise Bias Supply in MAX with Power-OK for GaAsFET PAMaxim Integrated
Maxim Integrated
MAX8811High SPeed Dual Phase DriverMaxim Integrated Products
Maxim Integrated Products
MAX881428V Linear Li Battery ChargerMaxim Integrated Products
Maxim Integrated Products
MAX8815AStep-Up ConverterMaxim Integrated Products
Maxim Integrated Products

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar