DataSheet39.com

What is EL9201?

This electronic component, produced by the manufacturer "Intersil Corporation", performs the same function as "(EL9200 - EL9202) Programmable VCOM".


EL9201 Datasheet PDF - Intersil Corporation

Part Number EL9201
Description (EL9200 - EL9202) Programmable VCOM
Manufacturers Intersil Corporation 
Logo Intersil Corporation Logo 


There is a preview and EL9201 download ( pdf file ) link at the bottom of this page.





Total 14 Pages



Preview 1 page

No Preview Available ! EL9201 datasheet, circuit

®
Data Sheet
EL9200, EL9201, EL9202
April 7, 2005
FN7438.0
Programmable VCOM
Features
The EL9200, EL9201, and EL9202 represent programmable
• 128 step adjustable sink current
VCOM amplifiers for use in TFT-LCD displays. Featuring 1,
2, and 4 channels of VCOM amplification, respectively, each
device features just a single programmable current source
• EEPROM memory
• 2-pin adjustment and disable
for adding offset to one VCOM output. This current source is
• Single, dual or quad amplifiers
programmable using a single wire interface to one of 128
- 44MHz bandwidth
levels. The value is stored on an internal EEPROM memory.
The EL9200 is available in the 12-pin DFN package and the
EL9201 and EL9202 are available in 24-pin QFN packages.
mAll are specified for operation over the -40°C to +85°C
otemperature range.
.cTypical Block Diagram
t4UVSD
AVDD
eeCE
VS+ INN
-
+
EEPROM
RF RG
VOUT
INP
GND
AVDD
R1
R2
ShCTL
CONTROL
taGND
UP/DOWN
COUNTER
ANALOG
POT
IOUT
SET
RSET
- 80V/µs slew rate
- 60mA continuous output
- 180mA peak output
• Up to 18V operation
• 2.6V to 3.6V logic control
• Pb-free available (RoHS compliant)
Applications
• TFT-LCD VCOM supplies for
- LCD-TVs
- LCD monitors
www.Da www.DataSheet4U.com1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright © Intersil Americas Inc. 2005. All Rights Reserved.
All other trademarks mentioned are the property of their respective owners.

line_dark_gray
EL9201 equivalent
Pin Descriptions
PIN
VINX-
IN/OUT
Input
EL9200, EL9201, EL9202
DESCRIPTION
Amplifier X inverting input, where:
X = A for EL9200
X = A, B for EL9201
X = A, B, C, D for EL9202
EQUIVALENT CIRCUIT
VS+
VINX+
VS+
VOUTX
NC
GND
IOUT
SET
CE
CTL
AVDD
VSD
Input
Supply
Output
-
Supply
Output
Output
Input
Input
Supply
Supply
Amplifier X non-inverting input, where:
X = A for EL9200
X = A, B for EL9201
X = A, B, C, D for EL9202
Op amp supply; bypass to GND with 0.1µF capacitor
Amplifier X output, where:
X = A for EL9200
X = A, B for EL9201
X = A, B, C, D for EL9202
CIRCUIT 1
Reference Circuit 1
GND
VS+
No connect; not internally connected
Ground connection
Adjustable sink current output pin; the current sinks into the
OUT pin is equal to the DAC setting times the maximum
adjustable sink current divided by 128; see SET pin function
description for the maxim adjustable sink current setting
Maximum sink current adjustment point; connect a resistor
from SET to GND to set the maximum adjustable sink
current of the OUT pin; the maximum adjustable sink
current is equal to (AVDD/20) divided by RSET
Counter enable pin; connect CE to VDD to enable counting
of the internal counter; connect CE to GND to inhibit
counting
Internal counter up/down control and internal EEPROM
programming control input; if CE is high, a mid-to-low
transition increments the 7-bit counter, raising the DAC
setting, increasing the OUT sink current, and lowering the
divider voltage at OUT; a mid-to-high transition decrements
the 7-bit counter, lowering the DAC setting, decreasing the
OUT sink current, and increasing the divider voltage at
OUT; applying 4.9V and above with appropriately arranged
timing will overwrite EEPROM with the contents in the 7-bit
counter; see EEPROM Programming section for details
analog voltage supply; bypass to GND with 0.1µF
capacitor
System power supply input; bypass to GND with 0.1µF
capacitor
GND
GND
CIRCUIT 2
5 FN7438.0
April 7, 2005


line_dark_gray

Preview 5 Page


Part Details

On this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for EL9201 electronic component.


Information Total 14 Pages
Link URL [ Copy URL to Clipboard ]
Download [ EL9201.PDF Datasheet ]

Share Link :

Electronic Components Distributor


An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists.


SparkFun Electronics Allied Electronics DigiKey Electronics Arrow Electronics
Mouser Electronics Adafruit Newark Chip One Stop


Featured Datasheets

Part NumberDescriptionMFRS
EL9200The function is (EL9200 - EL9202) Programmable VCOM. Intersil CorporationIntersil Corporation
EL9201The function is (EL9200 - EL9202) Programmable VCOM. Intersil CorporationIntersil Corporation
EL9202The function is (EL9200 - EL9202) Programmable VCOM. Intersil CorporationIntersil Corporation

Semiconductors commonly used in industry:

1N4148   |   BAW56   |   1N5400   |   NE555   |  

LM324   |   BC327   |   IRF840  |   2N3904   |  



Quick jump to:

EL92     1N4     2N2     2SA     2SC     74H     BC     HCF     IRF     KA    

LA     LM     MC     NE     ST     STK     TDA     TL     UA    



Privacy Policy   |    Contact Us     |    New    |    Search