Datasheet.kr   

MC3363 데이터시트 PDF




Motorola Semiconductors에서 제조한 전자 부품 MC3363은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 MC3363 자료 제공

부품번호 MC3363 기능
기능 LOW POWER DUAL CONVERSION FM RECEIVER
제조업체 Motorola Semiconductors
로고 Motorola Semiconductors 로고


MC3363 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.




전체 10 페이지수

미리보기를 사용할 수 없습니다

MC3363 데이터시트, 핀배열, 회로
www.DataSheet4U.com
Order this document by MC3363/D
Low Power Dual
Conversion FM Receiver
MC3363
The MC3363 is a single chip narrowband VHF FM radio receiver. It is a dual
conversion receiver with RF amplifier transistor, oscillators, mixers,
quadrature detector, meter drive/carrier detect and mute circuitry. The
MC3363 also has a buffered first local oscillator output for use with frequency
synthesizers, and a data slicing comparator for FSK detection.
Wide Input Bandwidth – 200 MHz Using Internal Local Oscillator
Wide Input Bandwidth – 450 MHz Using External Local Oscillator
RF Amplifier Transistor
Muting Operational Amplifier
Complete Dual Conversion
Low Voltage: VCC = 2.0 V to 6.0 Vdc
Low Drain Current: ICC = 3.6 mA (Typical) at VCC = 3.0 V,
Excluding RF Amplifier Transistor
Excellent Sensitivity: Input 0.3 µV (Typical) for 12 dB SINAD
Using Internal RF Amplifier Transistor
Data Shaping Comparator
Received Signal Strength Indicator (RSSI) with 60 dB
Dynamic Range
Low Number of External Parts Required
Manufactured in Motorolas MOSAIC® Process Technology
LOW POWER
DUAL CONVERSION
FM RECEIVER
SEMICONDUCTOR
TECHNICAL DATA
DW SUFFIX
PLASTIC PACKAGE
CASE 751F
(SO-28L)
ORDERING INFORMATION
Device
Operating
Temperature Range
Package
MC3363DW TA = – 40 to +85°C
SO–28L
Figure 1. Pin Connections and Representative
Block Diagram
1st Mixer Input 1
Base 2
Emitter 3
Collector 4
2nd LO Emitter 5
2nd LO Base 6
2nd Mixer Output 7
VCC 8
Limiter Input 9
Limiter Decoupling 10
Limiter Decoupling 11
Meter Drive (RSSI) 12
www.DataSheet4U.com Carrier Detect 13
Quadrature Coil 14
28 1st Mixer Input
27 Varicap Control
26 1st LO Tank
25 1st LO Tank
24 1st LO Output
23 1st Mixer Output
22 2nd Mixer Input
21 2nd Mixer Input
20 VEE
19 Mute Output
18 Comparator Output
17 Comparator Input
16 Recovered Audio
15 Mute Input
MOTOROLA ANALOG IC DEVICE DATA
© Motorola, Inc. 1996
Rev 0
1




MC3363 pdf, 반도체, 판매, 대치품
www.DataSheet4U.com
MC3363
CIRCUIT DESCRIPTION
The MC3363 is a complete FM narrowband receiver from
RF amplifier to audio preamp output. The low voltage dual
conversion design yields low power drain, excellent
sensitivity and good image rejection in narrowband voice and
data link applications.
In the typical application, the input RF signal is amplified
by the RF transistor and then the first mixer amplifies the
signal and converts the RF input to 10.7 MHz. This IF signal
is filtered externally and fed into the second mixer, which
further amplifies the signal and converts it to a 455 kHz IF
signal. After external bandpass filtering, the low IF is fed into
the limiting amplifier and detection circuitry. The audio is
recovered using a conventional quadrature detector.
Twice-IF filtering is provided internally.
The input signal level is monitored by meter drive circuitry
which detects the amount of limiting in the limiting amplifier.
The voltage at the meter drive pin determines the state of the
carrier detect output, which is active low.
APPLICATIONS INFORMATION
The first local oscillator is designed to serve as the VCO in
a PLL frequency synthesized receiver. The MC3363 can
operate together with the MC145166/7 to provide a two-chip
ten–channel frequency synthesized receiver in the 46/49
cordless telephone band. The MC3363 can also be used with
the MC14515X series of CMOS PLL synthesizers and
MC120XX series of ECL prescalers in VHF frequency
synthesized applications to 200 MHz.
For single channel applications the first local oscillator can
be crystal controlled. The circuit of Figure 4 has been used
successfully up to 60 MHz. For higher frequencies an
external oscillator signal can be injected into Pins 25 and/or
26 — a level of approximately 100 mVrms is recommended.
The first mixers transfer characteristic is essentially flat to
450 MHz when this approach is used (keeping a constant
10.7 MHz IF frequency). The second local oscillator is a
Colpitts type which is typically run at 10.245 MHz under
crystal control.
The mixers are doubly balanced to reduce spurious
responses. The first and second mixers have conversion
gains of 18 dB and 21 dB (typical), respectively. Mixer gain is
stable with respect to supply voltage. For both conversions,
the mixer impedances and pin layout are designed to allow
the user to employ low cost, readily available ceramic filters.
Following the first mixer, a 10.7 MHz ceramic bandpass
filter is recommended. The 10.7 MHz filtered signal is then
fed into the second mixer input Pin 21, the other input Pin 22
being connected to VCC.
The 455 kHz IF is filtered by a ceramic narrow bandpass
filter then fed into the limiter input Pin 9. The limiter has 10 µV
sensitivity for – 3.0 dB limiting, flat to 1.0 MHz.
The output of the limiter is internally connected to the
quadrature detector, including a quadrature capacitor. A
parallel LC tank is needed externally from Pin 14 to VCC. A 68
kshunt resistance is included which determines the peak
separation of the quadrature detector; a smaller value will
lower the Q and expand the deviation range and linearity, but
decrease recovered audio and sensitivity.
A data shaping circuit is available and can be coupled to
the recovered audio output of Pin 16. The circuit is a
comparator which is designed to detect zero crossings of
FSK modulation. Data rates of up to 35000 baud are
detectable using the comparator. Best sensitivity is obtained
when data rates are limited to 1200 baud maximum.
Hysteresis is available by connecting a high-valued resistor
from Pin 17 to Pin 18. Values below 120 kare not
recommended as the input signal cannot overcome the
hysteresis.
The meter drive circuitry detects input signal level by
monitoring the limiting of the limiting amplifier stages.
Figure 5 shows the unloaded current at Pin 12 versus input
power. The meter drive current can used directly (RSSI) or
can be used to trip the carrier detect circuit at a specified
input power.
A muting op amp is provided and can be triggered by the
carrier detect output (Pin 13). This provides a carrier level
triggered squelch circuit which is activated when the RF input
at the desired input frequency falls below a present level. The
level at which this occurs is determined by the resistor placed
between the meter drive output (Pin 12) and VCC. Values
between 80 – 130 kare recommended. This type of squelch
is pictured in Figures 3 and 4.
Hysteresis is available by connecting a high-valued
resistor Rh between Pins 12 and 13. The formula is:
Hyst = VCC / (Rh x 10 – 7) dB
The meter drive can also be used directly to drive a meter
or to provide AGC. A current to voltage converter or other
linear buffer will be needed for this application.
A second possible application of the op amp would be in a
noise triggered squelch circuit, similar to that used with the
MC3357/MC3359/MC3361B FM IFs. In this case the op amp
would serve as an active noise filter, the output of which
would be rectified and compared to a reference on a squelch
gate. The MC3363 does not have a dedicated squelch gate,
but the NPN RF input stage or data shaping comparator
might be used to provide this function if available. The op
amp is a basic type with the inverting input and the output
available. This application frees the meter drive to allow it to
be used as a linear signal strength monitor.
The circuit of Figure 4 is a complete 50 MHz receiver from
antenna input to audio preamp output. It uses few
components and has good performance. The receiver
operates on a single channel and has input sensitivity of
t 0.3 µV for 12 dB SINAD.
NOTE: For further application and design information, refer to AN980.
www.DataSheet4U.com
4 MOTOROLA ANALOG IC DEVICE DATA

4페이지










MC3363 전자부품, 판매, 대치품
www.DataSheet4U.com
MC3363
www.DataSheet4U.com
MOTOROLA ANALOG IC DEVICE DATA
Figure 5.
7

7페이지


구       성 총 10 페이지수
다운로드[ MC3363.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
MC3360P

1/4 Watt Audio Amplifier

Motorola Semiconductors
Motorola Semiconductors
mc3361

LOW POWER NARROWBAND FM IF

Motorola Semiconductors
Motorola Semiconductors

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵