Datasheet.kr   

IBM42F10LNNAA30 데이터시트 PDF




IBM Microelectronics에서 제조한 전자 부품 IBM42F10LNNAA30은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 IBM42F10LNNAA30 자료 제공

부품번호 IBM42F10LNNAA30 기능
기능 (IBM42x1xxNNAA30) Gigabit Ethernet / Fiber Channel Small Form Factor PTH Transceiver
제조업체 IBM Microelectronics
로고 IBM Microelectronics 로고


IBM42F10LNNAA30 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.



전체 24 페이지수

미리보기를 사용할 수 없습니다

IBM42F10LNNAA30 데이터시트, 핀배열, 회로
www.DataSheet4U.com
.
IBM42G12SNNAA30 IBM42G10SNNAA30 IBM42F12SNNAA30 IBM42F10SNNAA30
IBM42G12LNNAA30 IBM42G10LNNAA30 IBM42F12LNNAA30 IBM42F10LNNAA30
Gigabit Ethernet/Fibre Channel Small Form Factor PTH Transceiver
Features
• International Class 1 laser safety certified
• 1.0625Gb/s or 1.25Gb/s data rates
• (ANSI) Fibre Channel compliant [1]
• (IEEE 802.3) Gigabit Ethernet compliant [3]
• Short wavelength (SW) (distance 550m)
• Long wavelength (LW) (distance 10,000m)
• Gigabit electrical serial interface
• Serial electrical light conversion
• LVTTL Signal-Detect Output
• AC coupling of PECL signals
• Single +3.3V Power Supply
• Withstand normal wave solder and aqueous
spray cleaning
• UL & CSA approved
• Low bit error rate (< 10-12)
• High reliability: AFR < 0.01%/khr @ 50 C
Applications
• Gigabit Fibre Channel
• Gigabit Ethernet
• Client/Server environments
• Distributed multi-processing
• Fault tolerant applications
• Visualization, real-time video, collaboration
• Channel extenders, data storage, archiving
• Data acquisition
Description
The 1.0625/1.25Gb/s Small Form Factor PTH
Transceiver (SFF-PTH-1063/1250-SW/LW-
2X5/2X6) is an integrated fiber optic transceiver that
provides a high-speed serial link at a signaling rate
up to 1.25Gb/s. The SFF-PTH-1063-SW/LW-
2X5/2X6 conforms to the American National Stan-
dards Institute’s (ANSI) Fibre Channel, FC-PI speci-
fication for short and long wavelength operation
(100-M5-SN-I,100-M6-SN-I, and 100-SM-LC-L).
The SFF-PTH-1250-SW-2X5/2X6 conforms to IEEE
802.3z 1000Base-SX standard [3], and the SFF-
PTH-1250-LW-2X5/2X6 conforms to IEEE 802.3z
1000Base-LX standard [3].
The SFF-PTH-1063/1250-SW/LW-2X5/2X6 is ide-
ally suited for Gigabit Ethernet, and Fibre Channel
applications which include point to point links as well
as Fibre Channel Arbitrated Loop (FC-AL). It can
also be used for other serial applications where high
data rates are required. This specification applies to
a pin through hole (PTH) module which has a 2 by 5
or a 2 by 6 electrical connector pin configuration.
The SFF-PTH-1063/1250-SW-2X5/2X6 uses a short
wavelength (850nm) VCSEL (Vertical Cavity Sur-
face Emitting Laser) source. This enables low cost
data transmission over optical fibers at distances up
to 500m at 1.0625Gb/s and 550m at 1.25Gb/s. A
50/125µm multimode optical fiber, terminated with
an industry standard LC connector, is the preferred
medium. (A 62.5/125µm multimode fiber can be
substituted with shorter maximum link distances.)
The SFF-PTH-1063/1250-LW-2X5/2X6 uses a long
wavelength (1310nm) edge-emitting laser. This
enables data transmission at distances up to
10,000m on a single mode (9/125µm) optical fiber.
Encoded (8B/10B) [4], [5], gigabit serial differential
PECL signals traverse a PTH connector interfacing
the SFF-PTH-1063/1250-SW/LW-2X5/2X6 to the
host card. The incoming serial data modulates the
laser and is sent out over the outgoing fiber of a
duplex cable.
Incoming modulated light is detected by a photore-
ceiver mounted in the LC receptacle. The optical
signal is converted to an electrical signal, amplified
and delivered to the host card. This module is
designed to work with industry standard “10b” Seri-
alizer/Deserializer modules.
The SFF-PTH-1063/1250-SW/LW-2X5/2X6 is a
Class 1 laser safe product. The optical power levels
under normal operation are at eye safe levels, and
optical fiber can be connected and disconnected
without shutting off the laser transmitter.
08/15/00
Page 1 of 23




IBM42F10LNNAA30 pdf, 반도체, 판매, 대치품
www.DataSheet4U.com
IBM42F10SNNAA30 IBM42F12SNNAA30 IBM42G10SNNAA30 IBM42G12SNNAA30
IBM42F10LNNAA30 IBM42F12LNNAA30 IBM42G10LNNAA30 IBM42G12LNNAA30
Gigabit Ethernet/Fibre Channel Small Form Factor PTH Transceiver
Input Signal Definitions
Levels for the signals described in this section are listed in Transmit Signal Interface on page 8 and Control
Electrical Interface on page 9.
Tx_DAT
A differential PECL serial data stream is presented to the SFF-PTH-1063/1250-SW/LW-2X5/2X6 for trans-
mission onto an optical fiber by modulating the optical output intensity of the laser.
Tx_Disable
When high (a logical one), the Tx_Disable signal turns off the power to both the AC and DC laser driver cir-
cuits. It will also reset a laser fault if one should happen. When low (a logical zero), the laser will be turned on
within 1ms if a hard fault is not detected. The transceiver contains a pull-down resistor to enable the laser
when the line is not connected on the host side. If driven, this line should be connected to a push-pull output
driver.
Timing of Tx_Disable Function
Tx_Disable
t_reset
> 10µs
Transmitter optical
signal
t_off
< 10µs
t_on
< 1ms
Page 4 of 23
08/15/00

4페이지










IBM42F10LNNAA30 전자부품, 판매, 대치품
www.DataSheet4U.com
..
IBM42G12SNNAA30 IBM42G10SNNAA30 IBM42F12SNNAA30 IBM42F10SNNAA30
IBM42G12LNNAA30 IBM42G10LNNAA30 IBM42F12LNNAA30 IBM42F10LNNAA30
Gigabit Ethernet/Fibre Channel Small Form Factor PTH Transceiver
Absolute Maximum Ratings
Symbol
TS
RHS
VCC
VI
TSOLD
TSOLD
Parameter
Storage Temperature
Relative Humidity–Storage
Supply Voltage
TTL DC Input Voltage
Connector Pin Temp during soldering
Optics Temperature during soldering
Min.
Typical
Max.
Unit
-40 85 °C
0 95 %
-0.5 4.0 V
0
VCC + 0.7
V
165/5
°C/s
100/60
°C/s
Notes
1
1, 2
1
1
1,3
4
1. Stresses listed may be applied one at a time without causing permanent damage. Exposure to these values for extended periods
may affect reliability. Specification Compliance is only defined within Specified Operating Conditions.
2. Non-condensing environment.
3. The connector pin temperature can be measured with a thermocouple attached to pin 3 of 2x5 header
4. The optics temperature can be measured with a thermocouple on the device with the cover off.
Specified Operating Conditions
Symbol
Parameter
TOP Ambient Operating Temperature
VDDT, VDDR Supply Voltage
RHOP Relative Humidity-Operating
Power Supply Interface
Symbol
ITx
IRx
ITx
IRx
Parameter
Tx Power Current (@ 3.3V)
Rx Power Current (@ 3.3V)
Tx Power Current (@3.465V)
Rx Power Current (@3.465V)
Ripple & Noise
Min.
0
3.135
8
Typical
3.3
Max.
70
3.465
80
Unit
°C
V
%
Min
Typical
Max.
Unit
60 mA
90 mA
85 mA
115 mA
100 mV (pk-pk)
08/15/00
Page 7 of 23

7페이지


구       성 총 24 페이지수
다운로드[ IBM42F10LNNAA30.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
IBM42F10LNNAA30

(IBM42x1xxNNAA30) Gigabit Ethernet / Fiber Channel Small Form Factor PTH Transceiver

IBM Microelectronics
IBM Microelectronics

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵