|
|
PDF AT1312C Data sheet ( Hoja de datos )
| Número de pieza | AT1312C | |
| Descripción | High Efficiency Constant Current White-LEDs Driver | |
| Fabricantes | Aimtron Technology | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de AT1312C (archivo pdf) en la parte inferior de esta página. Total 16 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
AT1312A/B/C
Preliminary Product Information
High Efficiency, Constant Current
White-LEDs Driver
Feature
•Operating Voltage:2.5V to 6.0V.
•High Operating Frequency: 1MHz
•High Output Voltage: Up to 16V/23V/28V
•Shutdown Current <1µA
•16V/23V/28V Output Over-Voltage Protection
•Digital Dimming Control.
•Built-in Cycle-by Cycle Current-Limiting.
•Built-in Soft-Start Function.
•0.2V Low Reference Voltage
•Tiny SOT-26 Package
Application
Description
The AT1312A/B/C step-up converter drives white
LEDs with a constant current to provide backlight in
cell phones, PDAs, and other hand-held devices. It
features allowing series connection of the white
LEDs so that the LED currents are identical for
uniform brightness. An enable input can be pulsed
repeatedly to adjust LED’s brightness. The fast 1.0
MHz current-mode PWM control allows for smaller
capacitor and inductor. Fault condition protection
uses cycle-by-cycle current limiting to sense
maximum inductor current, thermal protection and
over-voltage protection. Also included soft-start
eliminates inrush current during start-up. The 0.2V
low reference voltage minimized the power loss
across the current-setting resistor.
• LED Module
• Compact Back Light Module
• Constant Current Source
The AT1312A/B/C is available in 6-pin SOT-26
packages.
Block Diagram
Aimtron reserves the right without notice to change this circuitry and specifications.
7F, No.9,PARK AVENUE. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C.
Tel: 886-3-563-0878 Fax: 886-3-563-0879
WWW: http://www.aimtron.com.tw
2/23/2006 REV:1.1
Email: [email protected]
1
1 page  
Typical Characteristics
AT1312A/B/C
Preliminary Product Information
High Efficiency, Constant Current
White-LEDs Driver
Conversion Efficiency
L:SR0302 D:RB501-40
90
85
80
75
70
65
0
6 L E D s, L = 2 2 u H , V in = 3 V
4 L E D s, L = 2 2 u H , V in = 3 V
3 L E D s,L = 2 2 u H , V in = 3 V
5 10 15
LED CURRENT(mA)
20
Efficiency vs. Vin (3 LED)
L:SR0302 D:RB501-40
90
88
86
84
82
80
78
76
Io=20 m A, L =22u H
7 4 Io=20 m A, L =10u H
7 2 Io = 20 m A,L = 6.8u H
7 0 Io = 20 m A,L = 4.7u H
23 456
Vin (V)
90
88
86
84
82
80
78
76
74
72
70
2
Efficiency vs. Vin (4 LED)
L:SR0302 D:RB501-40
Io=20mA, L=22uH
Io=20mA, L=10uH
Io=20mA, L=6.8uH
Io=20mA,L=4.7u
3 4 H5
Vin (V)
6
90
88
86
84
82
80
78
76
74
72
70
2
Efficiency vs. Vin (6 LED)
L:SR0302 D:RB501-40
Io=20mA, L=22uH
Io=20mA, L=10uH
Io=20mA,L=6.8uH
Io=20mA,L=4.7uH
345
Vin (V)
6
7F, No.9,PARK AVENUE. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C.
Tel: 886-3-563-0878 Fax: 886-3-563-0879
WWW: http://www.aimtron.com.tw
2/23/2006 REV:1.1
Email: [email protected]
5
5 Page 
AT1312A/B/C
Preliminary Product Information
High Efficiency, Constant Current
White-LEDs Driver
high to enable the device , or drive EN low for shutdown.
Soft-Start
Soft-start allows a gradual increase of the internal current-limit level for the step-up
converter during power-up to reduce input surge currents. As the internal current
source charges the internal soft-start capacitor, the peak N-MOS current is limited by
the voltage on the capacitor. In another story, when toggle or a logic-level transition
on EN pin from low to high, soft-start function must work to enable constant current
charging internal capacitor. When soft-start process has finished or appeared falling
edge of PWM signal on EN pin, soft-start capacitor must be discharged to ground
level.
Cycle-by-Cycle Over-Current Protection
The AT1312 series provides cycle-by-cycle over-current protection. Current limit is
accomplished using a separate dedicated comparator. The cycle-by-cycle current limit
abbreviates the on-time of the N-MOS in event that the current of flowing N-MOS is
greater than the current limit value. The current-limit feature protection against a hard
short or over-current fault at the output.
Over-Voltage Protection
If VOUT is above 16V/23V/28V( for AT1312A/B/C) or LEDs are disconnected from
the circuit, the FB pin is similar to pull down to ground with a sense resistor. This will
cause N-MOS to switch with a maximum duty cycle and come out output
over-voltage. This may cause the LX pin voltage to exceed its maximum voltage
rating to damage built-in N-MOS. In the state, the OVP protection circuitry stops the
internal N-MOS. When VOUT falls below 14V/21V/26V, IC will automatically recover
normal operation.
Thermal-Overload Protection
Thermal-overload protection limits total power dissipation in the AT1312 series.
When the junction temperature exceeds Tj=130 ℃, a thermal sensor activates the
thermal protection, which shuts down the IC, allowing the IC to cool. Once the device
cools down by 10 ℃, IC will automatically recover normal operation. For continuous
operation , do not exceed the absolute maximum junction-temperature rating of
Tj=120 ℃.
Power dissipation consideration
The AT1312 series maximum power dissipation depends on the thermal resistance of
the IC package and circuit board, the temperature difference between the die junction
and ambient air, and the rate of any airflow. The power dissipation in the device
depends on the operating conditions of the regulator. In continuous condition, the
step-up converter power dissipated internally across the internal N-MOS can be
approximated by :
7F, No.9,PARK AVENUE. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C.
Tel: 886-3-563-0878 Fax: 886-3-563-0879
WWW: http://www.aimtron.com.tw
2/23/2006 REV:1.1
Email: [email protected]
11
11 Page | ||
| Páginas | Total 16 Páginas | |
| PDF Descargar | [ Datasheet AT1312C.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| AT1312A | High Efficiency Constant Current White-LEDs Driver | Aimtron Technology |
| AT1312B | High Efficiency Constant Current White-LEDs Driver | Aimtron Technology |
| AT1312C | High Efficiency Constant Current White-LEDs Driver | Aimtron Technology |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |