|
|
|
부품번호 | AD7951 기능 |
|
|
기능 | 14-Bit Programmable Input ADC | ||
제조업체 | Analog Devices | ||
로고 | |||
전체 30 페이지수
www.DataSheet4U.com
14-Bit, 1 MSPS, Unipolar/Bipolar
Programmable Input PulSAR® ADC
AD7951
FEATURES
Multiple pins/software programmable input ranges:
5 V, 10 V, ±5 V, ±10 V
Pins or serial SPI® compatible input ranges/mode selection
Throughput
1 MSPS (warp mode)
800 kSPS (normal mode)
670 kSPS (impulse mode)
14-bit resolution with no missing codes
INL: ±0.3 LSB typ, ±1 LSB max (±61 ppm of FSR)
SNR: 85 dB @ 2 kHz
iCMOS® process technology
5 V internal reference: typical drift 3 ppm/°C; TEMP output
No pipeline delay (SAR architecture)
Parallel (14- or 8-bit bus) and serial 5 V/3.3 V interface
SPI-/QSPI™-/MICROWIRE™-/DSP-compatible
Power dissipation:
10 mW @ 100 kSPS
235 mW @ 1 MSPS
48-lead LQFP and LFCSP (7 mm × 7 mm) packages
APPLICATIONS
Process control
Medical instruments
High speed data acquisition
Digital signal processing
Instrumentation
Spectrum analysis
ATE
GENERAL DESCRIPTION
The AD7951 is a 14-bit, charge redistribution, successive
approximation register (SAR) architecture analog-to-digital
converter (ADC) fabricated on Analog Devices, Inc.’s iCMOS
high voltage process. The device is configured through hardware or
via a dedicated write only serial configuration port for input
range and operating mode. The AD7951 contains a high speed
14-bit sampling ADC, an internal conversion clock, an internal
reference (and buffer), error correction circuits, and both serial
and parallel system interface ports. A falling edge on CNVST
samples the analog input on IN+ with respect to a ground
sense, IN−. The AD7951 features four different analog input
ranges and three different sampling modes: warp mode for the
fastest throughput, normal mode for the fastest asynchronous
throughput, and impulse mode where power is scaled with
throughput. Operation is specified from −40°C to +85°C.
FUNCTIONAL BLOCK DIAGRAM
TEMP REFBUFIN REF REFGND VCC VEE DVDD DGND
AGND
AVDD
PDREF
PDBUF
IN+
IN–
REF
REF
AMP
SWITCHED
CAP DAC
CNVST
PD
RESET
CLOCK
CONTROL LOGIC AND
CALIBRATION CIRCUITRY
AD7951
SERIAL DATA
PORT
SERIAL
CONFIGURATION
PORT
14
PARALLEL
INTERFACE
OVDD
OGND
D[13:0]
SER/PAR
BYTESWAP
OB/2C
BUSY
RD
CS
WARP IMPULSE BIPOLAR TEN
Figure 1.
Table 1. 48-Lead 14-/16-/18-Bit PulSAR Selection
Type
100 kSPS to 500 kSPS to 570 kSPS to
250 kSPS
570 kSPS
1000 kSPS
Pseudo
Differential
AD7651
AD7660
AD7661
AD7650
AD7652
AD7664
AD7666
AD7653
AD7667
True Bipolar
AD7610
AD7663
AD7665
AD7951
AD7612
AD7671
True
Differential
AD7675
AD7676
AD7677
18-Bit, True
Differential
Multichannel/
Simultaneous
AD7678
AD7679
AD7654
AD7655
AD7674
>1000
kSPS
AD7621
AD7622
AD7623
AD7641
AD7643
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarksandregisteredtrademarksarethepropertyoftheirrespectiveowners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
www.analog.com
Fax: 781.461.3113
©2006 Analog Devices, Inc. All rights reserved.
www.DataSheet4U.com
AD7951
Parameter
REFERENCE BUFFER
REFBUFIN Input Voltage Range
EXTERNAL REFERENCE
Voltage Range
Current Drain
TEMPERATURE PIN
Voltage Output
Temperature Sensitivity
Output Resistance
DIGITAL INPUTS
Logic Levels
VIL
VIH
IIL
IIH
DIGITAL OUTPUTS
Data Format
Pipeline Delay5
VOL
VOH
POWER SUPPLIES
Specified Performance
AVDD
DVDD
OVDD
VCC
VEE
Operating Current7, 8
AVDD
With Internal Reference
With Internal Reference Disabled
DVDD
OVDD
VCC
VEE
Power Dissipation
With Internal Reference
With Internal Reference Disabled
In Power-Down Mode9
TEMPERATURE RANGE10
Specified Performance
Conditions/Comments
PDREF = high
PDREF = PDBUF = high
REF
1 MSPS throughput
@ 25°C
Min Typ
2.4 2.5
4.75 5
200
311
1
4.33
Parallel or serial 14-bit
ISINK = 500 μA
ISOURCE = –500 μA
−0.3
2.1
−1
−1
OVDD − 0.6
@ 1 MSPS throughput
4.756
4.75
2.7
7
−15.75
VCC = 15 V, with internal reference buffer
VCC = 15 V
VEE = −15 V
@ 1 MSPS throughput
PDREF = PDBUF = low
PDREF = PDBUF = high
PD = high
TMIN to TMAX
−40
5
5
15
−15
20
18.5
7
0.5
4
3
2
235
215
10
Max Unit
2.6 V
AVDD + 0.1 V
μA
mV
mV/°C
kΩ
+0.6
OVDD + 0.3
+1
+1
V
V
μA
μA
0.4
5.25
5.25
5.25
15.75
0
260
240
+85
V
V
V
V
V
V
V
mA
mA
mA
mA
mA
mA
mA
mW
mW
μW
°C
1 With VIN = 0 V to 5 V or 0 V to 10 V ranges, the input current is typically 100 μA. In all input ranges, the input current scales with throughput. See the Analog Inputs section.
2 Linearity is tested using endpoints, not best fit. All linearity is tested with an external 5 V reference.
3 LSB means least significant bit. All specifications in LSB do not include the error contributed by the reference.
4 All specifications in dB are referred to a full-scale range input, FSR. Tested with an input signal at 0.5 dB below full-scale, unless otherwise specified.
5 Conversion results are available immediately after completed conversion.
6 4.75 V or VREF – 0.1 V, whichever is larger.
7 Tested in parallel reading mode.
8 With internal reference, PDREF = PDBUF = low; with internal reference disabled, PDREF = PDBUF = high. With internal reference buffer, PDBUF = low.
9 With all digital inputs forced to OVDD.
10 Consult sales for extended temperature range.
Rev. 0 | Page 4 of 32
4페이지 www.DataSheet4U.com
ABSOLUTE MAXIMUM RATINGS
Table 5.
Parameter
Analog Inputs/Outputs
IN+1, IN−1 to AGND
REF, REFBUFIN, TEMP,
REFGND to AGND
Ground Voltage Differences
AGND, DGND, OGND
Supply Voltages
AVDD, DVDD, OVDD
AVDD to DVDD, AVDD to OVDD
DVDD to OVDD
VCC to AGND, DGND
VEE to GND
Digital Inputs
PDREF, PDBUF2
Internal Power Dissipation3
Internal Power Dissipation4
Junction Temperature
Storage Temperature Range
Rating
VEE − 0.3 V to VCC + 0.3 V
AVDD + 0.3 V to
AGND − 0.3 V
±0.3 V
−0.3 V to +7 V
±7 V
±7 V
–0.3 V to +16.5 V
+0.3 V to −16.5 V
−0.3 V to OVDD + 0.3 V
±20 mA
700 mW
2.5 W
125°C
−65°C to +125°C
1 See the Analog Inputs section.
2 See the Voltage Reference Input section.
3 Specification is for the device in free air: 48-Lead LQFP; θJA = 91°C/W,
θJC = 30°C/W.
4 Specification is for the device in free air: 48-Lead LFCSP; θJA = 26°C/W.
AD7951
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
ESD CAUTION
Rev. 0 | Page 7 of 32
7페이지 | |||
구 성 | 총 30 페이지수 | ||
다운로드 | [ AD7951.PDF 데이터시트 ] |
당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는 |
구매 문의 | 일반 IC 문의 : 샘플 및 소량 구매 ----------------------------------------------------------------------- IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한 광범위한 전력 반도체를 판매합니다. 전력 반도체 전문업체 상호 : 아이지 인터내셔날 사이트 방문 : [ 홈페이지 ] [ 블로그 1 ] [ 블로그 2 ] |
부품번호 | 상세설명 및 기능 | 제조사 |
AD795 | Low Power/ Low Noise Precision FET Op Amp | Analog Devices |
AD7951 | 14-Bit Programmable Input ADC | Analog Devices |
DataSheet.kr | 2020 | 연락처 | 링크모음 | 검색 | 사이트맵 |