|
|
|
부품번호 | CX1599 기능 |
|
|
기능 | Hydrogen-Filled Ceramic Thyratron | ||
제조업체 | E2V | ||
로고 | |||
www.DataSheet4U.com
CX1599
Hydrogen-Filled Ceramic Thyratron
The data to be read in conjunction with the Hydrogen
Thyratron Preamble.
ABRIDGED DATA
Hydrogen-filled tetrode thyratron with ceramic envelope,
featuring extremely low jitter, low anode delay time drift and
high rate of rise of current. A hydrogen reservoir operating
from a separate, variable heater supply is incorporated.
CX1599 is a fast, precise switch originally designed for use in
pulse generators to drive Kerr cells, Pockel cells or spark
chambers. Anode voltage must be command charged and
applied for less than 10 ms. The tube geometry allows it to be
mounted in a coaxial housing in order to minimise the total
circuit inductance.
Peak forward anode voltage (see note 1) . 12.5 kV max
Peak anode current . . . . . . . 1000
A max
Anode heating factor . . . . . . 12.5 x 107 VApps max
Peak output power . . . . . . . . . 6.25 MW max
Rate of rise of anode current
(see notes 2 and 3) . . . . . . . . 100
kA/ms
Typical jitter (see note 3) . . . . . . . 0.2
ns
Typical p.r.f. . . . . . . . . . . . 10
Hz
GENERAL
Electrical
Cathode (connected internally
to one end of heater) . . . . . . . . oxide coated
Cathode heater voltage (see note 3) . . .
6.8
+
7
0.0
0.3
Vdc
Cathode heater current . . . . . . . 9.5
A
Reservoir heater voltage
(see note 4) . . . . . . . . . . 4.0 V nom
Reservoir heater current . . . . . . . 1.5
A
Tube heating time (minimum) . . . . . 5.0 minutes
Mechanical
Seated height . . . . . 79.38 mm (3.125 inches) max
Clearance required below
mounting flange . . . . . 31.75 mm (1.250 inches) min
Overall diameter
(mounting flange) . . . 57.15 mm (2.250 inches) nom
Net weight . . . . . . . . 284 g (10 ounces) approx
Mounting position (see note 5) . . . . . . . . . any
Tube connections . . . . . . . . . . . see outline
Cooling . . . . . . . . natural, forced-air or liquid
Where natural cooling is insufficient to maintain the envelope
temperatures below the specified rated values, cooling by
forced-air, or by oil or coolant immersion may be used.
The temperature of the anode terminal and the base, measured
at the points indicated on the outline drawing, must not exceed
the values specified below.
Anode terminal . . . . . . . . . . 250
Base . . . . . . . . . . . . . 220
8C max
8C max
e2v technologies limited, Waterhouse Lane, Chelmsford, Essex CM1 2QU England Telephone: +44 (0)1245 493493 Facsimile: +44 (0)1245 492492
e-mail: [email protected] Internet: www.e2vtechnologies.com Holding Company: e2v holdings limited
e2v technologies inc. 4 Westchester Plaza, PO Box 1482, Elmsford, NY10523-1482 USA Telephone: (914) 592-6050 Facsimile: (914) 592-5148
e-mail: [email protected]
# e2v technologies limited 2004
A1A-CX1599 Issue 4, June 2004
282G/2298
MAXIMUM RECOVERY CHARACTERISTICS
40
2396B PEAK ANODE CURRENT
300 A
RE-APPLIED ANODE VOLTAGE 1 kV
35
GRID 2 VOLTAGE 0 V
30
712.5
25
725
20 750
15 7100
10
5
0
100
500
GRID 2 RECOVERY IMPEDANCE (O)
1000
SCHEMATIC DIAGRAM
8242 ANODE
VOLTAGE
ANODE
10 ms
MAX
G2 R2
5000
10 000
50 000
GRID 2 DELAYED
WITH RESPECT TO GRID 1
GRID 2 VOLTAGE
750 V, 0.5 ms
0
NEGATIVE BIAS VOLTAGE
CATHODE
HEATER
SUPPLY
RESERVOIR
HEATER
SUPPLY
(VARIABLE)
G1
C1
C2
R1
GRID 1 CURRENT
30 A, 1 ms
0.3 ms
GRID 1/GRID 2 DELAY
RECOMMENDED GRID, CATHODE AND RESERVOIR HEATER CONNECTIONS
R1 = Grid 1 series resistor. 12 W vitreous enamelled wirewound is recommended, of a total impedance to set the grid 1
drive pulse circuit.
R2 = Grid 2 series resistor. 12 W vitreous enamelled wirewound is recommended, of an impedance to match the grid 2
drive pulse circuit.
C1, C2 7 reservoir protection capacitors with a voltage rating 5500 V;
C1 = 1000 pF low inductance (e.g. ceramic),
C2 = 1 mF (e.g. polycarbonate or polypropylene).
Components R1, R2, C1 and C2 should be mounted as close to the tube as possible.
CX1599, page 4
# e2v technologies
4페이지 | |||
구 성 | 총 5 페이지수 | ||
다운로드 | [ CX1599.PDF 데이터시트 ] |
당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는 |
구매 문의 | 일반 IC 문의 : 샘플 및 소량 구매 ----------------------------------------------------------------------- IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한 광범위한 전력 반도체를 판매합니다. 전력 반도체 전문업체 상호 : 아이지 인터내셔날 사이트 방문 : [ 홈페이지 ] [ 블로그 1 ] [ 블로그 2 ] |
부품번호 | 상세설명 및 기능 | 제조사 |
CX1594 | Five-Gap Ceramic Thyratron | ETC |
CX1599 | Hydrogen-Filled Ceramic Thyratron | E2V |
DataSheet.kr | 2020 | 연락처 | 링크모음 | 검색 | 사이트맵 |