|
|
PDF AD9867 Data sheet ( Hoja de datos )
| Número de pieza | AD9867 | |
| Descripción | Broadband Modem Mixed-Signal Front End | |
| Fabricantes | Analog Devices | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de AD9867 (archivo pdf) en la parte inferior de esta página. Total 2 Páginas | ||
|
No Preview Available !
FEATURES
Low cost, 3.3 V CMOS MxFE® for broadband modems
10-bit digital-to-analog converter (DAC)
2×/4× interpolation filter
250 MSPS DAC update rate
10-bit, 75 MSPS ADC
Low noise RxPGA
Dual channel muxed input
6 dB input overload attenuator
−12 dB to +48 dB (without attenuator)
Third-order programmable low-pass filter
Flexible digital datapath interface
Half-duplex and full-duplex operation
Programmable delay Tx driver disable signal
Various power-down/reduction modes
Internal clock multiplier (PLL)
2 auxiliary programmable clock outputs
64-lead LFCSP
APPLICATIONS
www.DataSheet4U.com Power-line networking
GENERAL DESCRIPTION
The AD9867 is a mixed-signal front-end (MxFE) IC for
transceiver applications requiring Tx and Rx path functionality
with data rates up to 75 MSPS. Its flexible digital interface,
power-saving modes, and high Tx-to-Rx isolation make the
part well suited for half-duplex and full-duplex applications.
The digital interface is extremely flexible allowing simple
interfaces to digital back ends. Power-saving modes can reduce
power consumption of individual functional blocks or can
power down unused blocks in half-duplex applications. A serial
port interface (SPI®) allows software programming of the
various functional blocks. An on-chip PLL clock multiplier and
synthesizer provide all the required internal clocks, as well as
two external clocks from a single crystal or clock source.
The Tx signal path consists of a bypassable 2×/4× low-pass
interpolation filter and a 10-bit, 250 MSPS TxDAC. The
transmit path signal bandwidth can be as high as 33.6 MHz at
an input data rate of 75 MSPS. The TxDAC provides differential
current outputs that can be steered directly to a differential or
single-ended external load. Tx power can be digitally controlled
over a 7.5 dB range in 0.5 dB steps.
Broadband Modem
Mixed-Signal Front End
AD9867
PWR_DWN
FUNCTIONAL BLOCK DIAGRAM
OSCIN
XTAL
CLKOUT1
CLKOUT2
AD9867
2M CLK
MULTIPLIER
CLK
SYN/DIST
TX PWDN
DELAY
TXEN/TXSYNC
TXCLK/TXQUIET
ADIO[9:5]/
Tx[4:0]
DCTCXO
10
2×/4×
TxDAC
0 TO –7.5dB
ADIO[4:0]/
Rx[4:0]
RXCLK
RXEN/RXSYNC
AGC[4:0]
SPORT
RXSELECT
ATTEN/RXQUIET
5
4
1
1
10
ADC
80MSPS
THIRD-ORDER LPF
f–3dB = 33MHz
2-POLE
LPF
1-POLE
LPF
REGISTER
CONTROL
0dB TO 6dB – 6dB TO +18dB –6dB TO +24dB
Δ = 1dB
Δ = 6dB
Δ = 6dB
TX_DISABLE
IOUT_P+
IOUT_P–
RX2+
RX2–
RX1+
RX1–
Figure 1.
The receive path consists of a programmable amplifier
(RxPGA), a tunable low-pass filter (LPF), and a 10-bit analog-
to-digital converter (ADC). The low noise RxPGA has a
programmable gain range of −12 dB to +48 dB in 1 dB steps.
Its input referred noise is less than 3.6 nV/√Hz for gain settings
beyond 36 dB. An optional attenuator provides an additional
6 dB (or more) of attenuation (when combined with external
series resistors). The receive path LPF cutoff frequency can
either be set over a 22 MHz to 38 MHz range or simply
bypassed. The 10-bit ADC achieves excellent dynamic
performance over a 5 MSPS to 75 MSPS span. Both the RxPGA
and the ADC offer scalable power consumption allowing
power/performance optimization.
The AD9867 provides a highly integrated solution for
broadband modems. It is available in a space-saving, 64-lead
LFCSP and is specified over the commercial (−40°C to +85°C)
temperature range.
For more information on the AD9867, contact Analog Devices,
Inc. at email [email protected].
Rev. SpA
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarksandregisteredtrademarksarethepropertyoftheirrespectiveowners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
www.analog.com
Fax: 781.461.3113
©2007 Analog Devices, Inc. All rights reserved.
1 page | ||
| Páginas | Total 2 Páginas | |
| PDF Descargar | [ Datasheet AD9867.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| AD9860 | Mixed-Signal Front-End (MxFE) Processor for Broadband Communications | Analog Devices |
| AD9861 | Mixed-Signal Front-End (MxFE-TM) Baseband Transceiver | Analog Devices |
| AD9862 | Mixed-Signal Front-End (MxFE) Processor for Broadband Communications | Analog Devices |
| AD9863 | Mixed-Signal Front-End (MxFE) Baseband Transceiver | Analog Devices |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |