|
|
PDF MR-E-20AG Data sheet ( Hoja de datos )
| Número de pieza | MR-E-20AG | |
| Descripción | General Purpose AC Servo | |
| Fabricantes | MITSUBISHI | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de MR-E-20AG (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
General-Purpose AC Servo
MODEL
MR-E- A/AG
INSTRUCTION MANUAL
www.DataSheet4U.com
B
1 page  
(2) Wiring
CAUTION
Wire the equipment correctly and securely. Otherwise, the servo motor may misoperate.
Do not install a power capacitor, surge absorber or radio noise filter (FR-BIF option) between the servo
motor and servo amplifier.
Connect the output terminals (U, V, W) correctly. Otherwise, the servo motor will operate improperly.
Do not connect AC power directly to the servo motor. Otherwise, a fault may occur.
www.DataSheet4U.cTohme surge absorbing diode installed on the DC output signal relay must be wired in the specified direction.
Otherwise, the emergency stop and other protective circuits may not operate.
Servo
Amplifier
External
24VDC
Servo
Amplifier
External
24VDC
Control output
signal
RA
Control output
signal
RA
(3) Test run adjustment
CAUTION
Before operation, check the parameter settings. Improper settings may cause some machines to perform
unexpected operation.
The parameter settings must not be changed excessively. Operation will be insatiable.
(4) Usage
CAUTION
Provide an external emergency stop circuit to ensure that operation can be stopped and power switched
off immediately.
Any person who is involved in disassembly and repair should be fully competent to do the work.
Before resetting an alarm, make sure that the run signal is off to prevent an accident. A sudden restart is
made if an alarm is reset with the run signal on.
Do not modify the equipment.
Use a noise filter, etc. to minimize the influence of electromagnetic interference, which may be caused by
electronic equipment used near the servo amplifier.
Use the servo amplifier with the specified servo motor.
The electromagnetic brake on the servo motor is designed to hold the motor shaft and should not be used
for ordinary braking.
For such reasons as service life and mechanical structure (e.g. where a ballscrew and the servo motor
are coupled via a timing belt), the electromagnetic brake may not hold the motor shaft. To ensure safety,
install a stopper on the machine side.
A- 4
5 Page 
MEMO
www.DataSheet4U.com
A - 10
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet MR-E-20AG.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| MR-E-20A | General Purpose AC Servo | MITSUBISHI |
| MR-E-20A-KH003 | General-Purpose AC Servo | MITSUBISHI |
| MR-E-20A-QW003 | General Purpose AC Servo | MITSUBISHI |
| MR-E-20A-QW003 | EZ Motion E Serial | MITSUBISHI |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |