Datasheet.kr   

KEH-P4013R 데이터시트 PDF




Pioneer에서 제조한 전자 부품 KEH-P4013R은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


 

PDF 형식의 KEH-P4013R 자료 제공

부품번호 KEH-P4013R 기능
기능 (KEH-Px01xR) Cassette Player with RDS Tuner
제조업체 Pioneer
로고 Pioneer 로고


KEH-P4013R 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.



전체 20 페이지수

미리보기를 사용할 수 없습니다

KEH-P4013R 데이터시트, 핀배열, 회로
MAN-KEH-P5010R-GB_B.fm Page 1 Friday, October 6, 2000 2:22 PM
Multi-CD control High power cassette player with RDS tuner
2SHUDWLRQ 0DQXDO
.(+35
.(+35
.(+35
.(+35%
Q




KEH-P4013R pdf, 반도체, 판매, 대치품
MAN-KEH-P5010R-GB_B.fm Page 4 Friday, October 6, 2000 2:22 PM
&RQQHFWLQJ WKH 8QLWV
1RWH
• This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in
a recreational vehicle, truck, or bus, check the battery voltage.
• To avoid shorts in the electrical system, be sure to disconnect the - battery cable before
beginning installation.
• Refer to the owner’s manual for details on connecting the power amp and other units, then
make connections correctly.
• Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive
tape around them where they lie against metal parts.
• Route and secure all wiring so it cannot touch any moving parts, such as the gear shift,
handbrake, and seat rails. Do not route wiring in places that get hot, such as near the heater
outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-
circuiting to the vehicle body.
• Don’t pass the yellow lead through a hole into the engine compartment to connect to the
battery. This will damage the lead insulation and cause a very dangerous short.
• Do not shorten any leads. If you do, the protection circuit may fail to work when it should.
• Never feed power to other equipment by cutting the insulation of the power supply lead of
the unit and tapping into the lead. The current capacity of the lead will be exceeded, causing
overheating.
• When replacing fuse, be sure to use only fuse of the rating prescribed on this unit.
• Since a unique BPTL circuit is employed, never wire so the speaker leads are directly
grounded or the left and right - speaker leads are common.
• Speakers connected to this unit must be high-power types with minimum rating of 45 W
(50 W)* and impedance of 4 to 8 ohms. Connecting speakers with output and/or impedance
values other than those noted here may result in the speakers catching fire, emitting smoke,
or becoming damaged.
*KEH-P5010R
• When this product’s source is switched ON, a control signal is output through the blue/white
lead. Connect to an external power amp’s system remote control or the car’s Auto-antenna
relay control terminal (max. 300 mA 12 V DC). If the car features a glass antenna, connect
to the antenna booster power supply terminal.
• When an external power amp is being used with this system, be sure not to connect the blue/
white lead to the amp’s power terminal. Likewise, do not connect the blue/white lead to the
power terminal of the auto-antenna. Such connection could cause excessive current drain
and malfunction.
• To avoid short-circuiting, cover the disconnected lead with insulating tape. Especially,
insulate the unused speaker leads without fail. There is a possibility of short-circuiting if the
leads are not insulated.
• To prevent incorrect connection, the input side of the IP-BUS connector is blue, and the
output side is black. Connect the connectors of the same colors correctly.
• If this unit is installed in a vehicle that does not have an ACC (accessory) position on the
ignition switch, the red lead of the unit should be connected to a terminal coupled with
ignition switch ON/OFF operations. If this is not done, the vehicle battery may be drained
when you are away from the vehicle for several hours.
#
ACC position
No ACC position
• The black lead is ground. Please ground this lead separately from the ground of high-current
products such as power amps.
If you ground the products together and the ground becomes detached, there is a risk of
damage to the products or fire.
• Cords for this product and those for other products may be different colors even if
they have the same function. When connecting this product to another product, refer
to the supplied Installation manuals of both products and connect cords that have
the same function.

4페이지










KEH-P4013R 전자부품, 판매, 대치품
MAN-KEH-P5010R-GB_B.fm Page 7 Friday, October 6, 2000 2:22 PM
%DVLF 2SHUDWLRQ
7R /LVWHQ WR 0XVLF
The following explains the initial operations required before you can listen to music.
1RWH
• Loading a cassette in this product. (Refer to page 8.)
 Tryrp‡Ã‡urÃqr†v…rqƂˆ…prÃrtÃUˆr…
Each press changes the Source ...
Each press of the SOURCE button selects the desired source in the following order:
Tuner ] Tape ] Multi-CD player ] External Unit ] AUX
1RWH
• External Unit refers to a Pioneer product (such as one available in the future) that, although
incompatible as a source, enables control of basic functions by this product. Only one
External Unit can be controlled by this product.
• In the following cases, the sound source will not change:
* When a product corresponding to each source is not connected to this product.
* When no tape is set in this product.
* When no magazine is set in the Multi-CD player.
* When the AUX (external input) is set to OFF. (Refer to page 18.)
• When this product's blue/white lead is connected to the car's Auto-antenna relay control
terminal, the car's Auto-antenna extends when this product's source is switched ON. To
retract the antenna, switch the source OFF.
! Shv†r…Ãy‚r…Çurɂyˆ€r
%DVLF 2SHUDWLRQ RI 7XQHU
This product’s AF function can be switched ON and OFF. AF should be switched OFF
for normal tuning operations. (Refer to page 10.)
HhˆhyÃhqÃTrrxÃUˆvt
* `‚ˆÃphÃ†ryrp‡Ã‡urLjvtÀr‡u‚qÃi’ÃpuhtvtÇurÃyrt‡uÂsÇv€r҂ˆÃ
4/6ƒ…r††Ã‡urÃ
Ãiˆ‡‡‚
Manual Tuning (step by step)
Seek Tuning
0.5 seconds or less
0.5 seconds or more
1RWH
• If you continue pressing the button for longer than 0.5 seconds, you can skip
broadcast stations. Seek Tuning starts as soon as you release the button.
• Stereo indicator “%” lights when a stereo station is selected.
A…r„ˆrp’ÃDqvph‡‚…
7hqÃDqvph‡‚…
Q…r†r‡ÃIˆ€ir…ÃDqvph‡‚…
" Uˆ…Ã‡urƂˆ…prÃPAA
Hold for 1 second
Q…r†r‡ÃUˆvt
* `‚ˆÃphÃ€r€‚…v“rÃi…‚hqph†‡Ã†‡h‡v‚†ÃvÃiˆ‡‡‚†Ã Ã
‡u…‚ˆtuÃ%Ãs‚…Ãrh†’r‡‚ˆpuƇh‡v‚Ã…rphyyÃ
Preset station recall
Broadcast station preset memory
2 seconds or less
2 seconds or more
7hq
F1 (FM1)
] F2 (FM2)
] MW/LW
1RWH
• Up to 12 FM stations (6 each in F1 (FM1) and F2 (FM2)) and 6 MW/LW stations
can be stored in memory.
• You can also use the 8 or 2 buttons to recall broadcast stations memorized in
buttons 1 through 6.
&

7페이지


구       성 총 20 페이지수
다운로드[ KEH-P4013R.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
KEH-P4013R

Multi CD Control High Power Cassette Player

Pioneer
Pioneer
KEH-P4013R

(KEH-Px01xR) Cassette Player with RDS Tuner

Pioneer
Pioneer

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵