|
|
Número de pieza | SKY77546 | |
Descripción | Tx-Rx Front-End Module | |
Fabricantes | Skyworks Solutions | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de SKY77546 (archivo pdf) en la parte inferior de esta página. Total 2 Páginas | ||
No Preview Available ! PRODUCT SUMMARY
SKY77546 Tx–Rx Front-End Module for Dual-Band
GSM / GPRS / EDGEwww.datasheet4u.com
Applications
• Dual-band cellular handsets
encompassing
- Class 4 GSM900
- DCS1800
- Class 12 GPRS multi-slot
operation
- Linear EDGE operation
Features
• High efficiency
45% (GSM900)
40% (DCS1800)
• Current limiting for
protection and extended
battery life
• Input/Output internally
matched 50 Ω
• TX–VCO-to-antenna and
antenna-to-RX-SAW filter
RF interface
• TX harmonics below
–36 dBm
• Small outline: 7 x 6 mm
• Low profile: 1.0 mm Max.
• Low APC current: 25 μA
Description
The SKY77546 is a transmit and receive Front-End Module (FEM) designed in a compact form factor
for dual-band cellular handsets comprising GSM900 and DCS1800 operation. The SKY77546 offers a
complete Transmit VCO-to-Antenna and Antenna-to-Receive SAW filter solution that supports Class
12 General Packet Radio Service (GPRS) multi-slot operation and EDGE operation for handsets and
modules.
The module consists of a GSM900 PA block and a DCS1800 PA block, impedance-matching circuitry
for 50 Ω input and output impedances, TX harmonics filtering, high linearity and low insertion loss RF
switches, and a Power Amplifier Control (PAC) block. A custom CMOS integrated circuit provides the
internal PAC function, external interface circuitry, and decoder circuitry to control the RF switches.
The integrated PAC function provides envelope amplitude control by reducing sensitivity to input drive,
temperature, power supply, and process variations. The Heterojunction Bipolar Transistor (HBT) PA
blocks are fabricated onto a single InGaP/GaAs die. One PA block supports the GSM900 band and the
other PA block supports the DCS1800 band. Both PA blocks share common power supply pads to
distribute current. The output of each PA block and the outputs to the two receive pads are connected
to the antenna pad through a diplexer and SP2T switch. The GaAs die, switch die, Silicon (Si) die, and
passive components are mounted on a multi-layer laminate substrate. The assembly is encapsulated
with plastic overmold.
Band selection and control of transmit and receive RF signal flows are performed using three external
control pads. The band select pad (BS) selects GSM or DCS modes of operation. The TxEN pad selects
receive or transmit mode of the respective RF switch (Tx = logic 1). Proper timing of the logic on this
pad, the band-select pads, and Analog Power Control (APC) allows for high isolation between the
antenna and Tx-VCO while the VCO is being tuned prior to the transmit burst.
The Enable input allows initial turn-on of the PAC circuitry to minimize battery drain. Low leakage
current (6.5 μA, typical) of the dual PA module maximizes handset standby time.
Figure 1. Functional Block Diagram
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [email protected] • www.skyworksinc.com
201052A • Skyworks Proprietary and Confidential Information • Products and Product Information are Subject to Change Without Notice. • March 13, 2009
1
1 page |
Páginas | Total 2 Páginas | |
PDF Descargar | [ Datasheet SKY77546.PDF ] |
Número de pieza | Descripción | Fabricantes |
SKY77544 | Tx-Rx FEM | Skyworks Solutions |
SKY77546 | Tx-Rx Front-End Module | Skyworks Solutions |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |