Datasheet.kr   

HPS35W-NNR-000 데이터시트 PDF




Emerson에서 제조한 전자 부품 HPS35W-NNR-000은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 HPS35W-NNR-000 자료 제공

부품번호 HPS35W-NNR-000 기능
기능 AC-DC / Distributed Power Front End 1U
제조업체 Emerson
로고 Emerson 로고


HPS35W-NNR-000 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.



전체 4 페이지수

미리보기를 사용할 수 없습니다

HPS35W-NNR-000 데이터시트, 핀배열, 회로
Embedded Power for
Business-Critical Continuity
HPS35 Series
350 - 1400 Watts
Total Power:
Input Voltage:
# of Outputs:
350 Watts
per module
90-264 VAC
Single and
standby
Special Features
• Active Power Factor Correction
• EN61000-3-2 compliant
• CISPR22, EN55022 Level-B
conducted/radiated EMI
• EN61000 immunity standards
• 5Vsb@2A
• Overvoltage protection (OVP)
• Overcurrent protection (OCP)
• Overtemperature protection
(OTP)
• AC OK signal and indicator LED
• DC OK signal and indicator LED
• Remote Inhibit
• Remote Sense on main output
• Hot Plug
• N+1 Redundant
• 2 year warranty
Safety
UL
CSA
TUV
CB
CE
UL60950-1, 1st Ed.
(April 1, 2003)
CSA C22.2 60950-1-03
EN60950-1:2001
(1st Ed.)
IEC60950-1,
1st Ed. (2001)
Mark (LVD)
Rev. 3.4.09_133
HPS35 Series
 of 4
Electrical Specifications
Input
Input voltage:
90-264 VAC typical
Frequency:
47-440 Hz
Inrush current:
40 A peak typical @ 25 °C
Efficiency:
80% typ @ full load, 230 VAC
Power factor:
0.98 typical @ 115 VAC, full load
Turn-on time:
AC ON -2 sec., Inhibit / Enable 160 ms
EMI filter standard:
CISPR 22, EN55022 Level “B”
Leakage current standard: <0.5 mA max @ 230 VAC @ 60Hz (per module)
Radiated EMI:
CISPR 22, EN55022 Level “B”
Holdup time:
20 ms minimum (independent of input VAC)
AC OK:
5 ms early warning minimum before outputs lose regulation
Harmonic distortion:
Meets EN61000-3-2
Isolation:
Meets EN60950
Output
Adjustability:
±5% of nominal output voltage
Overall regulation:
±3%
Ripple:
1% of Vout pk - pk (20 MHz bandwidth)
Dynamic response:
4% from 25% to 75% load step
Recovery time:
To within 1% in <300 µsec
Overcurrent protection: 115 - 130% of rated output current
Short circuit protection: Protected for continuous short circuit. Auto recovery.
Overvoltage protection: 120 - 140% AC Reset.
Reverse voltage protection: 100% of rated output voltage
Thermal protection:
Main and Aux disabled when internal temp exceeds
safe operating range
Remote sense:
Single wire parallel:
DC OK:
Up to 0.5 V total drop
Current share to within 10% of total rated current on
main output
±5% of nominal




HPS35W-NNR-000 pdf, 반도체, 판매, 대치품
D. Sub Connector Additional Notes
Pin 2 + Remote Sense
Pin 3 - Remote Sense
Compensates for up to 0.5V drop.
Recommended shielded twisted wire
pair.
DC OK (OUT Signal)
Pin 12 - Global AC OK (OUT signal)
Note: DC OK signals for each slot in the
rack is accessible in the D-sub
connector (J18). Refer to Connector
Pin-out table for pin assignments. Pin 1
is the Return Pin.
Note: AC OK signals are OR’ed together
internally. If any module fails, the LED
on the affected module will be off and
the logic signal will indicate AC NOT OK.
AC OK (OUT Signal)
Pin 19 - Global Inhibit (IN signal)
Note: All outputs disabled when Pin 19
is open or High.
Pin 22 - SWP (IN/OUT signal)
SWP Pin is used when
PIN 22
connecting racks in
parallel to achieve
current sharing. Current
PIN 3 share accuracy is
typically 10% of full load.
Note: AC OK signals for each slot in the
rack is accessible in the D-sub
connector (J18). Refer to Connector
Pin-out table for pin assignments. Pin 1
is the Return Pin.
Hi state: Source 100uA @ 4V
Low State: Sink 10mA @ 0.5V
Fan Monitor (OUT Signal)
Note: SWP Voltage is 5V at 100% load
current.
Module Inhibit (IN Signal)
Note: Fan Monitor signals for each slot
in the rack is accessible in the D-sub
connector (J18). Refer to Connector
Pin-out table for pin assignments. Pin 1
is the Return Pin.
Note: Module Inhibit signals for each
slot in the rack is accessible in the D-sub
connector (J18). Refer to Connector
Pin-out table for pin assignments. Pin 1
is the Return Pin.
I2C_ADD#1
I2C_ADD#2
TBD
Embedded Power for
Business-Critical Continuity
Americas
5810 Van Allen Way
Carlsbad, CA 92008
USA
Telephone: +1 760 930 4600
Facsimile: +1 760 930 0698
Rev.3.4.09_133
HPS35 Series
 of 4
Europe (UK)
Waterfront Business Park
Merry Hill, Dudley
West Midlands, DY5 1LX
United Kingdom
Telephone: +44 (0) 1384 842 211
Facsimile: +44 (0) 1384 843 355
Asia (HK)
14/F, Lu Plaza
2 Wing Yip Street
Kwun Tong, Kowloon
Hong Kong
Telephone: +852 2176 3333
Facsimile: +852 2176 3888
For global contact, visit:
www.PowerConversion.com
techsupport.embeddedpower
@emerson.com
While every precaution has been taken to ensure
accuracy and completeness in this literature, Emerson
Network Power assumes no responsibility, and disclaims
all liability for damages resulting from use of this
information or for any errors or omissions.
Emerson Network Power.
The global leader in enabling
business-critical continuity.
AC Power
Connectivity
DC Power
Embedded Computing
Embedded Power
Monitoring
Outside Plant
Power Switching & Controls
Precision Cooling
Racks & Integrated Cabinets
Services
Surge Protection
EmersonNetworkPower.com
Emerson Network Power and the Emerson
Network Power logo are trademarks and
service marks of Emerson Electric Co.
©2008 Emerson Electric Co.

4페이지












구       성 총 4 페이지수
다운로드[ HPS35W-NNR-000.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
HPS35W-NNR-000

AC-DC / Distributed Power Front End 1U

Emerson
Emerson

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵