(PDF) NGC-30-Cxx Datasheet - Control and monitoring modules

Número de pieza	NGC-30-Cxx
Descripción	Control and monitoring modules
Fabricantes	Tyco Thermal Controls
Logotipo
Hay una vista previa y un enlace de descarga de NGC-30-Cxx (archivo pdf) en la parte inferior de esta página. Total 10 Páginas
No Preview Available ! DRAFT NELSON Job N° 075236 Date: 28/04/08 NGC-30-CR NGC-30-CRM NGC-30-CRMS NGC-30-CTM NGC-30-CVM Document Install-113 www.DataSheet.in Installation Instructions Montageanleitung Instructions d’installation 1 page Optional Voltage Sensor The optional voltage sensor can monitor 80 – 290 Vac. This voltage connects to one of the five line current/ground-fault inputs on the NGC-30-CRM. Note: By using the optional voltage sensor, you lose the ability to monitor the ground-fault and current for that circuit. Cable Preparation Notes: 1. Cut one end off of a ground- fault /line current cable. 2. Strip insulation approx. 2,5 cm from cut end. 3. Strip the red and black wire insulation approx. 0,5 cm. 4. Connect red and black wire to the two position terminal plug. No need to be concerned about polarity. 5. wTrim brown and orange wires from cut end. Mounting of NGC-30-CTM Each NGC-30-CTM mounts on a DIN 35 rail. It should be located between the circuit breaker or terminal block and contactor or SSR in the panel. NGC-30-CTM Installation Instructions www.DataSheet.in DigiTrace NGC-30 INSTALLATION INSTRUCTIONS 5 Page

Páginas	Total 10 Páginas
PDF Descargar	[ Datasheet NGC-30-Cxx.PDF ]

Número de pieza	Descripción	Fabricantes
SLA6805M	High Voltage 3 phase Motor Driver IC.	Sanken
SDC1742	12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.	Analog Devices

PDF NGC-30-Cxx Data sheet ( Hoja de datos )