|
|
PDF FAN5400 Data sheet ( Hoja de datos )
| Número de pieza | FAN5400 | |
| Descripción | USB-Compliant Single Cell Li-Ion Switching Charger | |
| Fabricantes | Fairchild Semiconductor | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de FAN5400 (archivo pdf) en la parte inferior de esta página. Total 5 Páginas | ||
|
No Preview Available !
www.DataSheet.co.kr
November 2010
FAN5400 Family
USB-Compliant Single-Cell Li-Ion Switching Charger with
USB-OTG Boost Regulator
Features
Fully Integrated, High-Efficiency Charger for Single-Cell
Li-Ion and Li-Polymer Battery Packs
Faster Charging than Linear
Charge Voltage Accuracy: ±0.5% at 25°C
±1% from 0 to 125°C
±5% Input Current Regulation Accuracy
±5% Charge Current Regulation Accuracy
20V Absolute Maximum Input Voltage
6V Maximum Input Operating Voltage
1.25A Maximum Charge Rate
Programmable through High-Speed I2C Interface
(3.4Mb/s) with Fast Mode Plus Compatibility
– Input Current
– Fast-Charge / Termination Current
– Charger Voltage
– Termination Enable
3MHz Synchronous Buck PWM Controller with Wide
Duty Cycle Range
Small Footprint 1μH External Inductor
Safety Timer with Reset Control
1.8V Regulated Output from VBUS for Auxiliary Circuits
Weak Input Sources Accommodated by Reducing
Charging Current to Maintain Minimum VBUS Voltage
Low Reverse Leakage to Prevent Battery Drain to VBUS
5V, 300mA Boost Mode for USB OTG for 2.5 to 4.5V
Battery Input
Applications
Cell Phones, Smart Phones, PDAs
Tablet, Portable Media Players
Gaming Device, Digital Cameras
Description
The FAN5400 family (FAN540X) combines a highly integrated
switch-mode charger, to minimize single-cell Lithium-ion (Li-
ion) charging time from a USB power source, and a boost
regulator to power a USB peripheral from the battery.
The charging parameters and operating modes are
programmable through an I2C Interface that operates up to
3.4Mbps. The charger and boost regulator circuits switch at
3MHz to minimize the size of external passive components.
The FAN540X provides battery charging in three phases:
conditioning, constant current, and constant voltage.
To ensure USB compliance and minimize charging time, the
input current is limited to the value set through the I2C host.
Charge termination is determined by a programmable
minimum current level. A safety timer with reset control
provides a safety backup for the I2C host.
The integrated circuit (IC) automatically restarts the charge
cycle when the battery falls below an internal threshold. If the
input source is removed, the IC enters a high-impedance
mode with leakage from the battery to the input prevented.
Charge status is reported back to the host through the I2C
port. Charge current is reduced when the die temperature
reaches 120°C.
The FAN540X can operate as a boost regulator on
command from the system. The boost regulator includes a
soft-start that limits inrush current from the battery.
The FAN540X is available in a 1.96 x 1.87mm, 20-bump,
0.4mm pitch WLCSP package.
VBUS
CBUS
1μF
PMID
CMID
4.7μF
SDA
SCL
DISABLE
OTG/USB#
STAT
FAN540X
SW L1 1μH
PGND COUT
CSIN
0.1μF
RSENSE
68mΩ
+ Battery
VBAT
VREG
CREG
SYSTEM
LOAD
1μF
CBAT
10μF
All trademarks are the property of their respective owners.
© 2008 Fairchild Semiconductor Corporation
FAN5400 Family • Rev. 1.0.2
Figure 1. Typical Application (FAN5403-05 Pinout)
www.fairchildsemi.com
Datasheet pdf - http://www.DataSheet4U.net/
1 page  
www.DataSheet.co.kr
© 2008 Fairchild Semiconductor Corporation
FAN5400 Family • Rev. 1.0.2
36
www.fairchildsemi.com
Datasheet pdf - http://www.DataSheet4U.net/
5 Page | ||
| Páginas | Total 5 Páginas | |
| PDF Descargar | [ Datasheet FAN5400.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| FAN5400 | USB-Compliant Single Cell Li-Ion Switching Charger | Fairchild Semiconductor |
| FAN5400 | (FAN5401 - FAN5405) USB-Compliant Single-Cell Li-Ion Switching Charger | Fairchild Semiconductor |
| FAN5401 | (FAN5401 - FAN5405) USB-Compliant Single-Cell Li-Ion Switching Charger | Fairchild Semiconductor |
| FAN54010 | (FAN54010 - FAN54015) USB-Compliant Single Cell Li-Ion Switching Charger | Fairchild Semiconductor |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |