Datasheet.kr   

G104VN01-V0 데이터시트 PDF




AUO에서 제조한 전자 부품 G104VN01-V0은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 G104VN01-V0 자료 제공

부품번호 G104VN01-V0 기능
기능 LCD Module
제조업체 AUO
로고 AUO 로고


G104VN01-V0 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.




전체 24 페이지수

미리보기를 사용할 수 없습니다

G104VN01-V0 데이터시트, 핀배열, 회로
www.DataSheet4U.net
Product Specification
AU OPTRONICS CORPORATION
(V ) Preliminary Specifications
( ) Final Specifications
Module
Model Name
10.4 Inch Color TFT-LCD
G104VN01 V0
G104VN01 V0
Customer
Date
Approved by
Date
Checked &
Approved by
Note: This Specification is subject to change
without notice.
Peter ML Lee
2007/04/09
Prepared by
Grace Hung
2007/04/09
General Display Business Division /
AU Optronics corporation
G104VN01 V0 rev.0.1
1/24




G104VN01-V0 pdf, 반도체, 판매, 대치품
www.DataSheet4U.net
Product Specification
AU OPTRONICS CORPORATION
G104VN01 V0
1. Operating Precautions
1) Since front polarizer is easily damaged, please be cautious and not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or soft cloth.
5) Since the panel is made of glass, it may be broken or cracked if dropped or bumped on hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth when
handling.
7) Do not open nor modify the module assembly.
8) Do not press the reflector sheet at the back of the module to any direction.
9) In case if a module has to be put back into the packing container slot after it was taken out from the
container, do not press the center of the CCFL Reflector edge. Instead, press at the far ends of the
CCFL Reflector edge softly. Otherwise the TFT Module may be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the Interface
Connector of the TFT Module.
11) After installation of the TFT Module into an enclosure (Notebook PC Bezel, for example), do not twist
nor bend the TFT Module even momentary. At designing the enclosure, it should be taken into
consideration that no bending/twisting forces are applied to the TFT Module from outside. Otherwise
the TFT Module may be damaged.
12) Cold cathode fluorescent lamp in LCD contains a small amount of mercury. Please follow local ordinances or
regulations for disposal.
13) Small amount of materials having no flammability grade is used in the LCD module. The LCD module should
be supplied by power complied with requirements of Limited Power Source (IEC60950 or UL1950), or be
applied exemption.
14) The LCD module is designed so that the CCFL in it is supplied by Limited Current Circuit (IEC60950 or
UL1950). Do not connect the CCFL in Hazardous Voltage Circuit.
15) Severe temperature condition may result in different luminance, response time and lamp ignition voltage.
16) Continuous operating TFT-LCD display under low temperature environment may accelerate lamp exhaustion
and reduce luminance dramatically.
17) The data on this specification sheet is applicable when LCD module is placed in landscape position.
18) Continuous displaying fixed pattern may induce image sticking. It s recommended to use screen saver or
shuffle content periodically if fixed pattern is displayed on the screen.
G104VN01 V0 rev.0.1
4/24

4페이지










G104VN01-V0 전자부품, 판매, 대치품
www.DataSheet4U.net
Product Specification
AU OPTRONICS CORPORATION
Note 2: Definition of 5 points position (Display active area: 211.2mm (H) x 158.4mm (V))
W /4
W /4
W
W /4
W /4
G104VN01 V0
H /4
H /4
H
H /4
H /4
12
3
45
Note 3: The luminance uniformity of 5 points is defined by dividing the minimum luminance values by the
maximum test point luminance
δW5 =
Minimum Brightness of five points
Maximum Brightness of five points
Note 4: Definition of contrast ratio (CR):
Brightness on the Whitestate
Contrast ratio (CR)=
Brightness on the Blackstate
Note 5: Definition of response time:
The output signals of photo detector are measured when the input signals are changed from Whiteto Black
(falling time) and from Blackto White(rising time), respectively. The response time interval is between 10%
and 90% of amplitudes. Please refer to the figure as below.
% Tf
Tr
Optical
response
100
90
10
0
White
Black
White
G104VN01 V0 rev.0.1
7/24

7페이지


구       성 총 24 페이지수
다운로드[ G104VN01-V0.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
G104VN01-V0

LCD Module

AUO
AUO
G104VN01-V1

LCD Module

AUO
AUO

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵