DataSheet.es    


PDF TS16GCF400 Data sheet ( Hoja de datos )

Número de pieza TS16GCF400
Descripción 400X CompactFlash Card
Fabricantes Transcend 
Logotipo Transcend Logotipo



Hay una vista previa y un enlace de descarga de TS16GCF400 (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! TS16GCF400 Hoja de datos, Descripción, Manual

TTSS1166GG~~6644GGCCFF440000
Description
Dedicated to fulfill the demanding requirements of
performance-conscious photographers, Transcend
proudly releases its Extreme 400X CompactFlash
cards. With its amazing performance, the Transcend
400X CompactFlash memory card allows the
professional photographers and enthusiasts to get the
most from your digital single lens reflex (DSLR)
camera. Users are guaranteed to make consecutive
shooting and non-stop video recording and share their
digital artwork with the world!
Placement
Dimensions
400X CompactFlash Card
Features
CompactFlash Specification Version 4.1 Compliant
RoHS compliant products
Single Power Supply: 3.3V±5% or 5V±10%
Operating Temperature: -25oC to 85oC
Storage Temperature: -40oC to 85oC
Operating/ Storage Humidity: 5% to 95%
Operation Modes:
PC Card Memory Mode
PC Card IO Mode
True IDE Mode
True IDE Mode supports:
Ultra DMA Mode 0 to Ultra DMA Mode 6 (Ultra DMA
mode 5/6 must supply with 3.3V)
MultiWord DMA Mode 0 to MultiWord DMA Mode 4
PIO Mode 0 to PIO Mode 6
http://www.DataSheet4U.net/
PC Card Mode supports up to Ultra DMA Mode 6
True IDE mode: Fixed Disk (Default)
PC Card Mode: Removable Disk (Default)
Durability of Connector: 10,000 times
Built-in 15 bit ECC (Error Correction Code) functionality
Support Global Wear-Leveling to extend product life
Transfer rate up to read 90MB/s write 60MB/s based on
TestMetrix.
Transcend Information Inc.
1
V1.0
datasheet pdf - http://www.DataSheet4U.net/

1 page




TS16GCF400 pdf
TTSS1166GG~~6644GGCCFF440000
400X CompactFlash Card
http://www.DataSheet4U.net/
Transcend Information Inc.
5
V1.0
datasheet pdf - http://www.DataSheet4U.net/

5 Page





TS16GCF400 arduino
TTSS1166GG~~6644GGCCFF440000
400X CompactFlash Card
Signal Name
-CE1, -CE2
(PC Card Memory Mode)
Card Enable
-CE1, -CE2
(PC Card I/O Mode)
Card Enable
-CS0, -CS1
(True IDE Mode)
-CSEL
(PC Card Memory Mode)
-CSEL
(PC Card I/O Mode)
-CSEL
(True IDE Mode)
D15 - D00
(PC Card Memory Mode)
D15 - D00
(PC Card I/O Mode)
D15 - D00
(True IDE Mode)
GND
(PC Card Memory Mode)
GND
(PC Card I/O Mode)
GND
(True IDE Mode)
Dir. Pin
Description
These input signals are used both to select the card and to indicate to the card
I
7,32
whether a byte or a word operation is being performed. -CE2 always accesses
the odd byte of the word.-CE1 accesses the even byte or the Odd byte of the
word depending on A0 and -CE2. A multiplexing scheme based on A0,-CE1,
-CE2 allows 8 bit hosts to access all data on D0-D7. See Table 27, Table 29,
Table 31, Table 35, Table 36 and Table 37.
This signal is the same as the PC Card Memory Mode signal.
In the True IDE Mode, -CS0 is the address range select for the task file
registers while -CS1 is used to select the Alternate Status Register and the
Device Control Register.
While –DMACK is asserted, -CS0 and –CS1 shall be held negated and the
width of the transfers shall be 16 bits.
I 39 This signal is not used for this mode, but should be connected by the host to PC
Card A25 or grounded by the host.
This signal is not used for this mode, but should be connected by the host to PC
Card A25 or grounded by the host.
http://www.DataSheet4U.net/
This internally pulled up signal is used to configure this device as a Master or a
Slave when configured in the True IDE Mode.
When this pin is grounded, this device is configured as a Master.
When the pin is open, this device is configured as a Slave.
I/O 31,30,29,28, These lines carry the Data, Commands and Status information between the host
27,49,48,47, and the controller. D00 is the LSB of the Even Byte of the Word. D08 is the LSB
6,5,4,3,2,
23, 22, 21
of the Odd Byte of the Word.
This signal is the same as the PC Card Memory Mode signal.
In True IDE Mode, all Task File operations occur in byte mode on the low order
bus D[7:0] while all data transfers are 16 bit using D[15:0].
-- 1,50 Ground.
This signal is the same for all modes.
This signal is the same for all modes.
Transcend Information Inc.
11
V1.0
datasheet pdf - http://www.DataSheet4U.net/

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet TS16GCF400.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
TS16GCF400400X CompactFlash CardTranscend
Transcend

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar