Datasheet.kr   

TLP714F 데이터시트 PDF




Toshiba에서 제조한 전자 부품 TLP714F은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


 

PDF 형식의 TLP714F 자료 제공

부품번호 TLP714F 기능
기능 PHOTOCOUPLER
제조업체 Toshiba
로고 Toshiba 로고


TLP714F 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.




전체 15 페이지수

미리보기를 사용할 수 없습니다

TLP714F 데이터시트, 핀배열, 회로
Photocouplers GaAℓAs Infrared LED & Photo IC
TLP714F
TLP714F
1. Applications
• Intelligent Power Module Signal Isolation
• Factory Automation (FA)
• Transistor Inverters
2. General
The TLP714F is a photocoupler in a 6-pin SDIP package that consists of a GaAℓAs infrared light-emitting diode
(LED) optically coupled to an integrated high-gain, high-speed photodetector IC chip. It provides guaranteed
performance and specifications at temperatures up to 125.
The TLP714F is physically smaller than the one in an 8-pin DIP package and compliant with international safety
standards for reinforced insulation. It thus provides a smaller footprint solution for applications that require
safety standard certification. An internal noise shield provides a guaranteed commonmode transient immunity
of 20 kV/µs. The TLP714F guarantees minimum and maximum of propagation delay time, pulse width distortion.
Therefore it is suitable for isolation interface between IPM and control IC circuits in motor control application.
Leads of the TLP714F is bend to satisfy 8 mm PC board spacing requirements. Absolute maximum ratings and
electrical characteristics are the same as in the TLP714.
3. Features
(1) Inverter logic type (open collector output)
(2) Package: SDIP6
(3) Operating temperature: -40 to 125
(4) Supply voltage: -0.5 to 30 V
(5) Threshold input current: 5.0 mA (max)
(6) Supply current: 1.3 mA (max)
(7) Propagation delay time: tpHL = 400 ns (max), tpLH = 550 ns (max)
(8) Pulse width distortion: |tpHL - tpLH| = 400 ns (max)
(9) Common-mode transient immunity: ±20 kV/µs (min)
(10) Isolation voltage: 5000 Vrms (min)
(11) Safety standards
UL-approved: UL1577 File No.E67349
cUL-approved: CSA Component Acceptance Service No.5A, File No.E67349
VDE-approved: Option (D4) EN60747-5-2 (Note)
Note: When an EN60747-5-2 approved type is needed, please designate the Option (D4).
4. Packaging and Pin Configuration
11-5J101S
1
1: Anode
2: N.C.
3: Cathode
4: GND
5: VO (Output)
6: VCC
2012-09-16
Rev.3.0
Free Datasheet http://www.datasheet4u.com/




TLP714F pdf, 반도체, 판매, 대치품
TLP714F
9. Electrical Characteristics (Note)
(Unless otherwise specified, Ta = -40 to 125, VCC = 4.5 to 30 V)
Characteristics
Symbol Note Test Circuit
Test Condition
Min Typ. Max Unit
Input forward voltage
VF
Input forward voltage
temperature coefficient
VF/Ta
Input reverse current
Input capacitance
High-level output current
IR
Ct
IOH
Low-level output voltage
VOL
High-level supply current
Low-level supply current
ICCH
ICCL
Output current
IO
Threshold input current (H/L)
Threshold input voltage (L/H)
IFHL
VFLH
Note: All typical values are at Ta = 25.
IF = 10 mA, Ta = 25
IF = 10 mA
VR = 5 V, Ta = 25
V = 0 V, f = 1 MHz
Fig. 12.1.1 VF = 0.8 V, VO < VCC
Fig. 12.1.2 IF = 10 mA, IO = 2.4 mA
Fig. 12.1.3 IF = 0 mA
Fig. 12.1.4 IF = 10 mA
Fig. 12.1.5 IF = 10 mA, VO = 0.6 V
IO = 0.75 mA, VO < 0.8 V
IO = 0.75 mA, VO > 2.0 V
1.45 1.55 1.7
V
-2.0 mV/
  10 µA
60 pF
  50 µA
0.2 0.6 V
1.0 1.3 mA
1.0 1.3
4.0
1.0 5.0
0.8   V
10. Isolation Characteristics (Unless otherwise specified, Ta = 25)
Characteristics
Symbol Note
Test Conditions
Min Typ. Max Unit
Total capacitance (input to output)
Isolation resistance
Isolation voltage
CS (Note 1) VS = 0 V, f = 1 MHz
RS (Note 1) VS = 500 V, R.H. 60%
BVS (Note 1) AC, 1 min
AC, 1 s in oil
DC, 1 min in oil
1×1012
5000
0.8
1014
10000
10000
pF
Vrms
Vdc
Note 1: This device is considered as a two-terminal device: Pins 1, 2 and 3 are shorted together, and pins 4, 5 and 6
are shorted together.
11. Switching Characteristics (Note)
(Unless otherwise specified, Ta = -40 to 125, VCC = 15 V)
Characteristics
Symbol Note
Test
Circuit
Test Condition
Min Typ. Max Unit
Propagation delay time (H/L) tpHL (Note 1) Fig. IF = 0 10 mA, RL = 20 k, 30 150 400
12.1.6 CL = 100 pF
IF = 0 10 mA, RL = 20 k,
70
CL = 10 pF
Propagation delay time (L/H) tpLH (Note 1)
IF = 10 0 mA, RL = 20 k, 150 350 550
CL = 100 pF
IF = 10 0 mA, RL = 20 k,
110
CL = 10 pF
Pulse width distortion
|tpHL-
tpLH|
(Note 1)
IF = 10 mA, RL = 20 k,
CL = 100 pF
  400
Propagation delay skew
(device to device)
tpsk (Note 1),
(Note 2)
-50 450
ns
Common-mode transient
immunity at output high
Common-mode transient
immunity at output low
CMH
CML
Fig.
12.1.7
VCM = 1500 Vp-p, IF = 0 mA,
RL = 20 k, Ta = 25,
CL = 10 pF or 100 pF
VCM = 1500 Vp-p, IF = 10 mA,
RL = 20 k, Ta = 25,
CL = 10 pF or 100 pF
±20
±20
±25
±25
kV/µs
Note: All typical values are at Ta = 25.
Note 1: Input signal (f = 10 kHz, duty = 10%, input current tr = tf = 5 ns or less )
Note 2: The propagation delay skew, tpsk, is defined as the propagation delay time of the largest or smallest tpLH minus
the largest or smallest tpHL of multiple samples. Evaluations of these samples are conducted under identical
test conditions (supply voltage, input current, temperature, etc).
4 2012-09-16
Rev.3.0
Free Datasheet http://www.datasheet4u.com/

4페이지










TLP714F 전자부품, 판매, 대치품
TLP714F
Fig. 12.2.7 IO - Ta
Fig. 12.2.8 Normalized IO - Ta
Fig. 12.2.9 VOL - Ta
Fig. 12.2.10 tpLH,tpHL,|tpHL-tpLH| - Ta
Fig. 12.2.11 tpLH,tpHL,|tpHL-tpLH| - IF
Fig. 12.2.12 tpLH,tpHL,|tpHL-tpLH| - VCC
7 2012-09-16
Rev.3.0
Free Datasheet http://www.datasheet4u.com/

7페이지


구       성 총 15 페이지수
다운로드[ TLP714F.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
TLP714F

PHOTOCOUPLER

Toshiba
Toshiba

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵