|
|
|
부품번호 | G084SN03-V0 기능 |
|
|
기능 | TFT LCD Module | ||
제조업체 | AUO | ||
로고 | |||
전체 24 페이지수
www.DataSheet4U.net
Version: 0.3
Total Pages: 23
Date: 2005/8/29
Product Functional Specification
8.4 inch SVGA Color TFT LCD Module
Model Name: G084SN03 V.0
(u) Preliminary Specification
( ) Final Specification
Note: This Specification is subject to change without notice.
(C) Copyright AU Optroncis, Inc.
2005 All Right Reserved.
No Reproduction and Redistribution Allowed.
G084SN03 V.0
8/9
www.DataSheet4U.net
1.0 Handing Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnection from input
connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration
or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on
hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure
human earth when handling.
7) Do not open nor modify the module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a module has to be put back into the packing container slot after once it
was taken out from the container, do not press the center of the CCFL Reflector
edge. Instead, press at the far ends of the CFL Reflector edge softly. Otherwise
the TFT module may be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate
nor tilt the interface Connector of the TFT module.
11) After installation of the TFT module into an enclosure, do not twist nor bend the
TFT module even momentary. At designing the enclosure, it should be taken into
consideration that no bending/twisting forces are applied to the TFT module from
outside. Otherwise the TFT module may be damaged.
12) Cold cathode fluorescent lamp in LCD contains a small amount of mercury. Please
follow local ordinances or regulations for disposal.
13) Small amount of materials having no flammability grade is used in the LCD
module should be supplied by power complied with requirements of Limited Power
Source, or be applied exemption.
14) The LCD module is designed so that the CFL in it is supplied by Limited Current
Circuit. Do not connect the CFL in Hazardous Voltage Circuit.
(C) Copyright AU Optroncis, Inc.
2005 All Right Reserved.
No Reproduction and Redistribution Allowed.
G084SN03 V.0
8/9
4페이지 www.DataSheet4U.net
3.0 Absolute Maximum Ratings
Absolute maximum ratings of the module is as follows:
Item
Symbol Min
Max
Unit
Logic/LCD Drive Voltage
VDD
-0.3
+4.0 [Volt]
Input Voltage of Signal
Vin -0.3 VDD+0.3 [Volt]
CCFL Current
ICFL
3
6 [mA] rms
CCFL lgnition Voltage
Vs 441 539 Vrms
Operating Temperature
TOP
0
+50 [℃]
Operating Humidity
HOP
8
90 [%RH]
Storage Temperature
TST -20
+60 [℃]
Storage Humidity
HST
5
90 [%RH]
Vibration
1.0, 10-500 [G, Hz]
Shock
220, 2 [G, ms]
Conditions
Note1
Note1
Note1
Note1
2hr/axis X,Y,Z
Half sine wave
Note1:Maximum Wet-Bulb should be 39 ℃ and no condensation.
(C) Copyright AU Optroncis, Inc.
2005 All Right Reserved.
No Reproduction and Redistribution Allowed.
G084SN03 V.0
8/9
7페이지 | |||
구 성 | 총 24 페이지수 | ||
다운로드 | [ G084SN03-V0.PDF 데이터시트 ] |
당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는 |
구매 문의 | 일반 IC 문의 : 샘플 및 소량 구매 ----------------------------------------------------------------------- IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한 광범위한 전력 반도체를 판매합니다. 전력 반도체 전문업체 상호 : 아이지 인터내셔날 사이트 방문 : [ 홈페이지 ] [ 블로그 1 ] [ 블로그 2 ] |
부품번호 | 상세설명 및 기능 | 제조사 |
G084SN03-V0 | TFT LCD Module | AUO |
G084SN03-V1 | TFT LCD Module | AUO |
DataSheet.kr | 2020 | 연락처 | 링크모음 | 검색 | 사이트맵 |