Datasheet.kr   

G084SN03-V1 데이터시트 PDF




AUO에서 제조한 전자 부품 G084SN03-V1은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 G084SN03-V1 자료 제공

부품번호 G084SN03-V1 기능
기능 TFT LCD Module
제조업체 AUO
로고 AUO 로고


G084SN03-V1 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.




전체 26 페이지수

미리보기를 사용할 수 없습니다

G084SN03-V1 데이터시트, 핀배열, 회로
www.DataSheet4U.net
( ) Preliminary Specifications
(V ) Final Specifications
Module
Model Name
8.4 Inch Color TFT-LCD
G084SN03 V1
G084SN03 V1
Customer
Date
Approved by
Date
Checked &
Approved by
Note: This Specification is subject to change
without notice.
Debbie Chiu
2008/7/31
Prepared by
Alex Cheng
2008/7/31
General Display Business Division /
AU Optronics corporation
provided by
www.display-solution.com
G084SN03 V1 rev. 1.0
1/26




G084SN03-V1 pdf, 반도체, 판매, 대치품
www.DataSheet4U.net
G084SN03 V1
1. Operating Precautions
1) Since front polarizer is easily damaged, please be cautious not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or
spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or soft cloth.
5) Since the panel is made of glass, it may be broken or cracked if dropped or bumped on
hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human
earth when handling.
7) Do not open nor modify the module assembly.
8) Do not press the reflector sheet at the back of the module to any direction.
9) In case if a module has to be put back into the packing container slot after it was taken
out from the container, do not press the center of the CCFL Reflector edge. Instead,
press at the far ends of the CFL Reflector edge softly. Otherwise the TFT Module may
be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor
tilt the Interface Connector of the TFT Module.
11) After installation of the TFT Module into an enclosure (Notebook PC Bezel, for
example), do not twist nor bend the TFT Module even momentary. At designing the
enclosure, it should be taken into consideration that no bending/twisting forces are
applied to the TFT Module from outside. Otherwise the TFT Module may be damaged.
12) Cold cathode fluorescent lamp in LCD contains a small amount of mercury. Please follow
local ordinances or regulations for disposal.
13) Small amount of materials having no flammability grade is used in the LCD module. The
LCD module should be supplied by power complied with requirements of Limited Power
Source (IEC60950 or UL1950), or be applied exemption.
14) The LCD module is designed so that the CFL in it is supplied by Limited Current Circuit
(IEC60950 or UL1950). Do not connect the CFL in Hazardous Voltage Circuit.
15) Severe temperature condition may result in different luminance, response time and lamp
ignition voltage.
16) Continuous operating TFT-LCD display under low temperature environment may accelerate
lamp exhaustion and reduce luminance dramatically.
17) The data on this specification sheet is applicable when LCD module is placed in landscape
position.
18) Continuous displaying fixed pattern may induce image sticking. It is recommended to use
screen saver or shuffle content periodically if fixed pattern is displayed on the screen.
provided by
www.display-solution.com
G084SN03 V1 rev. 1.0
4/26

4페이지










G084SN03-V1 전자부품, 판매, 대치품
www.DataSheet4U.net
G084SN03 V1
Note 2: Definition of 9 points position (Display active area : 170.4(H) x 127.8(V))
90 %
50 %
10 %
10 %
50 %
90 %
Note 3: The luminance uniformity of 9 points is defined by dividing the minimum luminance value by the maximum
test point luminance.
Minimum Brightness of nine points
=δW9
Maximum Brightness of nine points
Note 4Definition of contrast ratio (CR):
Brightness on the “White” state
Contrast ratio (CR)=
Brightness on the “Black” state
Note 5: Definition of response time:
The output signals of photo detector are measured when the input signals are changed from “White” to “Black”
(falling time) and from “Black” to “White” (rising time), respectively. The response time interval is between 10% and
90% of amplitudes. Please refer to the figure as below.
% Tf
Tr
Optical
response
100
90
10
0
White
Black
White
Note 6: Definition of viewing angle
Viewing angle is the measurement of contrast ratio 10, at the screen center, over a 180°horizontal and 180°
G084SN03 V1 rev. 1.0
provided by
www.display-solution.com
7/26

7페이지


구       성 총 26 페이지수
다운로드[ G084SN03-V1.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
G084SN03-V0

TFT LCD Module

AUO
AUO
G084SN03-V1

TFT LCD Module

AUO
AUO

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵