Datasheet.kr   

C8051F588 데이터시트 PDF




Silicon Laboratories에서 제조한 전자 부품 C8051F588은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 C8051F588 자료 제공

부품번호 C8051F588 기능
기능 Mixed Signal ISP Flash MCU Family
제조업체 Silicon Laboratories
로고 Silicon Laboratories 로고


C8051F588 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.




전체 30 페이지수

미리보기를 사용할 수 없습니다

C8051F588 데이터시트, 핀배열, 회로
Analog Peripherals
- 12-Bit ADC
Up to 200 ksps
Up to 32 external single-ended inputs
VREF from on-chip VREF, external pin or VDD
Internal or external start of conversion source
Built-in temperature sensor
- Three Comparators
Programmable hysteresis and response time
Configurable as interrupt or reset source
Low current
On-Chip Debug
- On-chip debug circuitry facilitates full speed, non-
intrusive in-system debug (no emulator required)
- Provides breakpoints, single stepping,
inspect/modify memory and registers
- Superior performance to emulation systems using
ICE-chips, target pods, and sockets
- Low cost, complete development kit
Supply Voltage 1.8 to 5.25 V
- Typical operating current: 15 mA at 50 MHz;
Typical stop mode current: 230 µA
High-Speed 8051 µC Core
- Pipelined instruction architecture; executes 70% of
instructions in 1 or 2 system clocks
- Up to 50 MIPS throughput with 50 MHz clock
- Expanded interrupt handler
Automotive Qualified
- Temperature Range: –40 to +125 °C
C8051F58x/F59x
Mixed Signal ISP Flash MCU Family
Memory
- 8448 bytes internal data RAM (256 + 8192 XRAM)
- 128 or 96 kB Banked Flash; In-system programma-
ble in 512-byte Sectors
- External 64 kB data memory interface programma-
ble for multiplexed or non-multiplexed mode
Digital Peripherals
- 40, 33, or 25 Port I/O; All 5 V push-pull with high
sink current
- CAN 2.0 Controller—no crystal required
- LIN 2.1 Controller (Master and Slave capable); no
crystal required
- Two Hardware enhanced UARTs, SMBus™, and
enhanced SPI™ serial ports
- Six general purpose 16-bit counter/timers
- Two 16-Bit programmable counter array (PCA)
peripherals with six capture/compare modules each
and enhanced PWM functionality
Clock Sources
- Internal 24 MHz with ±0.5% accuracy for CAN and
master LIN operation.
- External oscillator: Crystal, RC, C, or clock
(1 or 2 pin modes)
- Can switch between clock sources on-the-fly;
useful in power saving modes
Packages
- 48-Pin QFP/QFN (C8051F580/1/4/5)
- 40-Pin QFN (C8051F588/9-F590/1)
- 32-Pin QFP/QFN (C8051F582/3/6/7)
ANALOG
PERIPHERALS
A 12-bit
M
U
200 ksps
X ADC
TEMP
SENSOR
Voltage VREG
Comparators 0-2 VREF
DIGITAL I/O
UART 0-1
SMBus
SPI
PCA x 2
Timers 0-5
CAN
LIN
Ports 0-4
Crossbar
External
Memory
Interface
24 MHz PRECISION
INTERNAL OSCILLATOR
2x Clock Multiplier
HIGH-SPEED CONTROLLER CORE
128 kB
ISP FLASH
FLEXIBLE
INTERRUPTS
8051 CPU
(50 MIPS)
DEBUG
CIRCUITRY
8 kB XRAM
POR WDT
Rev. 1.2 4/11
Copyright © 2011 by Silicon Laboratories C8051F580/1/2/3/4/5/6/7/8/9-F590/1
Free Datasheet http://www.Datasheet4U.com




C8051F588 pdf, 반도체, 판매, 대치품
C8051F58x/F59x
12.2.1.2. Bit Addressable Locations ............................................................ 105
12.2.1.3. Stack .......................................................................................... 105
13. Special Function Registers................................................................................. 106
13.1. SFR Paging ................................................................................................... 106
13.2. Interrupts and SFR Paging ............................................................................ 106
13.3. SFR Page Stack Example ............................................................................. 107
14. Interrupts .............................................................................................................. 126
14.1. MCU Interrupt Sources and Vectors.............................................................. 126
14.1.1. Interrupt Priorities.................................................................................. 127
14.1.2. Interrupt Latency ................................................................................... 127
14.2. Interrupt Register Descriptions ...................................................................... 129
14.3. External Interrupts INT0 and INT1................................................................. 136
15. Flash Memory....................................................................................................... 138
15.1. Programming The Flash Memory .................................................................. 138
15.1.1. Flash Lock and Key Functions .............................................................. 138
15.1.2. Flash Erase Procedure ......................................................................... 138
15.1.3. Flash Write Procedure .......................................................................... 139
15.1.4. Flash Write Optimization ....................................................................... 139
15.2. Non-volatile Data Storage ............................................................................. 140
15.3. Security Options ............................................................................................ 140
15.4. Flash Write and Erase Guidelines ................................................................. 142
15.4.1. VDD Maintenance and the VDD monitor ................................................ 142
15.4.2. PSWE Maintenance .............................................................................. 142
15.4.3. System Clock ........................................................................................ 143
16. Power Management Modes................................................................................. 147
16.1. Idle Mode....................................................................................................... 147
16.2. Stop Mode ..................................................................................................... 148
16.3. Suspend Mode .............................................................................................. 148
17. Reset Sources ...................................................................................................... 150
17.1. Power-On Reset ............................................................................................ 151
17.2. Power-Fail Reset/VDD Monitor ..................................................................... 152
17.3. External Reset ............................................................................................... 153
17.4. Missing Clock Detector Reset ....................................................................... 153
17.5. Comparator0 Reset ....................................................................................... 154
17.6. PCA Watchdog Timer Reset ......................................................................... 154
17.7. Flash Error Reset .......................................................................................... 154
17.8. Software Reset .............................................................................................. 154
18. External Data Memory Interface and On-Chip XRAM ....................................... 156
18.1. Accessing XRAM........................................................................................... 156
18.1.1. 16-Bit MOVX Example .......................................................................... 156
18.1.2. 8-Bit MOVX Example ............................................................................ 156
18.2. Configuring the External Memory Interface ................................................... 157
18.3. Port Configuration.......................................................................................... 157
18.4. Multiplexed and Non-multiplexed Selection................................................... 162
18.4.1. Multiplexed Configuration...................................................................... 162
4 Rev. 1.2
Free Datasheet http://www.Datasheet4U.com

4페이지










C8051F588 전자부품, 판매, 대치품
C8051F58x/F59x
25.2.1. 8-Bit UART ............................................................................................ 265
25.2.2. 9-Bit UART ............................................................................................ 265
25.3. Multiprocessor Communications ................................................................... 266
26. Enhanced Serial Peripheral Interface (SPI0) ..................................................... 270
26.1. Signal Descriptions........................................................................................ 271
26.1.1. Master Out, Slave In (MOSI)................................................................. 271
26.1.2. Master In, Slave Out (MISO)................................................................. 271
26.1.3. Serial Clock (SCK) ................................................................................ 271
26.1.4. Slave Select (NSS) ............................................................................... 271
26.2. SPI0 Master Mode Operation ........................................................................ 272
26.3. SPI0 Slave Mode Operation .......................................................................... 274
26.4. SPI0 Interrupt Sources .................................................................................. 274
26.5. Serial Clock Phase and Polarity .................................................................... 275
26.6. SPI Special Function Registers ..................................................................... 276
27. Timers ................................................................................................................... 283
27.1. Timer 0 and Timer 1 ...................................................................................... 285
27.1.1. Mode 0: 13-bit Counter/Timer ............................................................... 285
27.1.2. Mode 1: 16-bit Counter/Timer ............................................................... 286
27.1.3. Mode 2: 8-bit Counter/Timer with Auto-Reload..................................... 286
27.1.4. Mode 3: Two 8-bit Counter/Timers (Timer 0 Only)................................ 287
27.2. Timer 2 .......................................................................................................... 293
27.2.1. 16-bit Timer with Auto-Reload............................................................... 293
27.2.2. 8-bit Timers with Auto-Reload............................................................... 293
27.2.3. External Oscillator Capture Mode ......................................................... 294
27.3. Timer 3 .......................................................................................................... 299
27.3.1. 16-bit Timer with Auto-Reload............................................................... 299
27.3.2. 8-bit Timers with Auto-Reload............................................................... 299
27.3.3. External Oscillator Capture Mode ......................................................... 300
27.4. Timer 4 and Timer 5 ...................................................................................... 305
27.4.1. Configuring Timer 4 and 5 to Count Down............................................ 305
27.4.2. Capture Mode ....................................................................................... 305
27.4.3. Auto-Reload Mode ................................................................................ 306
27.4.4. Toggle Output Mode ............................................................................. 307
28. Programmable Counter Array 0 (PCA0)............................................................. 312
28.1. PCA0 Counter/Timer ..................................................................................... 313
28.2. PCA0 Interrupt Sources................................................................................. 314
28.3. Capture/Compare Modules ........................................................................... 315
28.3.1. Edge-triggered Capture Mode............................................................... 315
28.3.2. Software Timer (Compare) Mode.......................................................... 316
28.3.3. High-Speed Output Mode ..................................................................... 317
28.3.4. Frequency Output Mode ....................................................................... 318
28.3.5. 8-bit, 9-bit, 10-bit and 11-bit Pulse Width Modulator Modes ................. 319
28.3.5.1. 8-bit Pulse Width Modulator Mode................................................ 319
28.3.5.2. 9/10/11-bit Pulse Width Modulator Mode...................................... 320
28.3.6. 16-Bit Pulse Width Modulator Mode...................................................... 321
Rev. 1.2
7
Free Datasheet http://www.Datasheet4U.com

7페이지


구       성 총 30 페이지수
다운로드[ C8051F588.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
C8051F580

Mixed Signal ISP Flash MCU Family

Silicon Laboratories
Silicon Laboratories
C8051F581

Mixed Signal ISP Flash MCU Family

Silicon Laboratories
Silicon Laboratories

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵