|
|
PDF G190EG01V1 Data sheet ( Hoja de datos )
| Número de pieza | G190EG01V1 | |
| Descripción | SXGA Color TFT-LCD | |
| Fabricantes | AUO | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de G190EG01V1 (archivo pdf) en la parte inferior de esta página. Total 31 Páginas | ||
|
No Preview Available !
DATA DISPLAY GROUP
Datasheet
AUO
G190EG01V1
UP-02-054
The information contained in this document has been carefully researched and i s, to the best of ou r
knowledge, accurate. However, we assume no li ability for any product failures or damage s, immediate or
consequential, resulting from the use of the information provided herein. Our products are not intended for
use in systems in which failures of product could result in personal injury. All trademarks mentioned herein
are property of their respective owners. All specifications are subject to change without notice.
http://www.Datasheet4U.com
1 page  
Product Specification
AU OPTRONICS CORPORATION
G190EG01 V1
1. Handling Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth when
handling.
7) Do not open or modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a Module has to be put back into the packing container slot after once it was taken out
from the container, do not press the center of the Cold Cathode Fluorescent Lamp (CCFL) reflector
edge. Instead, press at the far ends of the CCFL reflector edge softly. Otherwise the TFT Module
may be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the
Interface Connector of the TFT Module.
11) After installation of the TFT Module into an enclosure, do not twist nor bend the TFT Module even
momentary. At designing the enclosure, it should be taken into consideration that no
bending/twisting forces are applied to the TFT Module from outside. Otherwise the TFT Module
may be damaged.
12) Cold Cathode Fluorescent Lamp (CCFL) in LCD contains a small amount of mercury. Please follow local
ordinances or regulations for disposal.
13) Small amount of materials having no flammability grade is used in the LCD module. The LCD module
should be supplied by power complied with requirements of Limited Power Source (IEC60950 or
UL1950), or be applied exemption.
14) The LCD module is designed so that the CCFL in it is supplied by Limited Current Circuit (IEC60950 or
UL1950). Do not connect the CCFL in Hazardous Voltage Circuit.
document version 0.1
4/29
5 Page 
Product Specification
AU OPTRONICS CORPORATION
G190EG01 V1
Note 6: Definition of response time, measured by WESTAR TRD-100A
The output signals of photo detector are measured when the input signals are changed from “Full Black” to
“Full White” (rising time), and from “Full White” to “Full Black” (falling time), respectively. The response time
is interval between the 10% and 90% of amplitudes. Please refer to the figure as below.
% TrF
Optical
response
100
90
10
0
White
Black
TrR
White
Note 7: Subchecker Pattern
RGB RGB
RGB RGB
RGB RGB
Gray Level = L127
Gray Level = L0
Method: Record dBV & DC value with (WESTAR)TRD-100
Amplitude
AC
DC
Flicker
(dB)
=
20 log
AC
Level(at 30 Hz)
DC Level
Time
document version 0.1
10/29
11 Page | ||
| Páginas | Total 31 Páginas | |
| PDF Descargar | [ Datasheet G190EG01V1.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| G190EG01V1 | SXGA Color TFT-LCD | AUO |
| G190EG01V1-V556A | TFT LCD |  Data Display |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |