|
|
|
부품번호 | BII112S-20000 기능 |
|
|
기능 | ROTOR DIMENSIONS | ||
제조업체 | ETC | ||
로고 | |||
ROTOR DIMENSIONS
iMODEL B I 112S/20000
GH
AA-225857/01
A *1
B
C
D
E *2
114.5+0.2/-0
(114.2+0.01/-0.01)
89
84
80
74
(Ef+0.01/-0.01)
I
G
H
I
11
113
135+2/-2
Unit: mm
¥Note¥
*1) After shrink-fitting the rotor to the spindle, apply finish machining to outer surface of the rotor and each part
bearings to be placed at the same process. Final finishing diameter is 114.2 +0.01/-0.01.
*2)Before shrink-fitting, apply finish machining to rotor bore within the dimension of Ef +0.01/-0.01. "Ef" could be
from 74.4 to 77 , so please choose the value. When machining, please refer to the reference figure below.
*3) To assemble the shaft and rotor, apply shrink-fitting at maximum 200 degrees centigrade. Ideally, within 180
degrees centigrade. Interference should be 60 - 90 micro meters in the case of 20,000 min-1.
*4)When you machine the rotor with coolant, please dry up after machining.
*5) To balance the spindle, please prepare another ring on each side of the rotor. Be sure not cut or drill the rotor to
balance the spindle.
MACHINING ROTOR BORE (reference)
Gauge
Rotor
FINISH DIMENSION OF SPINDLE
*The parameter of Ef must be the same value as
the value of rotor bore.
1.6S
Chuck
Jig
When machining the rotor bore, please hold the
outer surface of a rotor with a jig shown above.
If you hold the rotor bore, it may be deformed.
Non-magnetic rings for balance
http://www.Datasheet4U.com
| |||
구 성 | 총 1 페이지수 | ||
다운로드 | [ BII112S-20000.PDF 데이터시트 ] |
당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는 |
구매 문의 | 일반 IC 문의 : 샘플 및 소량 구매 ----------------------------------------------------------------------- IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한 광범위한 전력 반도체를 판매합니다. 전력 반도체 전문업체 상호 : 아이지 인터내셔날 사이트 방문 : [ 홈페이지 ] [ 블로그 1 ] [ 블로그 2 ] |
부품번호 | 상세설명 및 기능 | 제조사 |
BII112S-20000 | ROTOR DIMENSIONS | ETC |
DataSheet.kr | 2020 | 연락처 | 링크모음 | 검색 | 사이트맵 |