Datasheet.kr   

EFM32G230 데이터시트 PDF




Energy Micro에서 제조한 전자 부품 EFM32G230은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 EFM32G230 자료 제공

부품번호 EFM32G230 기능
기능 microcontrollers
제조업체 Energy Micro
로고 Energy Micro 로고


EFM32G230 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.




전체 30 페이지수

미리보기를 사용할 수 없습니다

EFM32G230 데이터시트, 핀배열, 회로
...the world's most energy friendly microcontrollers
EFM32G230 DATASHEET
F128/F64/F32
ARM Cortex-M3 CPU platform
• High Performance 32-bit processor @ up to 32 MHz
• Memory Protection Unit
• Wake-up Interrupt Controller
Flexible Energy Management System
• 20 nA @ 3 V Shutoff Mode
• 0.6 µA @ 3 V Stop Mode, including Power-on Reset, Brown-out
Detector, RAM and CPU retention
• 0.9 µA @ 3 V Deep Sleep Mode, including RTC with 32.768 kHz
oscillator, Power-on Reset, Brown-out Detector, RAM and CPU
retention
• 45 µA/MHz @ 3 V Sleep Mode
• 180 µA/MHz @ 3 V Run Mode, with code executed from flash
128/64/32 KB Flash
16/16/8 KB RAM
56 General Purpose I/O pins
• Configurable push-pull, open-drain, pull-up/down, input filter, drive
strength
• Configurable peripheral I/O locations
• 16 asynchronous external interrupts
• Output state retention and wake-up from Shutoff Mode
8 Channel DMA Controller
8 Channel Peripheral Reflex System (PRS) for autonomous in-
ter-peripheral signaling
Hardware AES with 128/256-bit keys in 54/75 cycles
Timers/Counters
• 3× 16-bit Timer/Counter
• 3×3 Compare/Capture/PWM channels
• Dead-Time Insertion on TIMER0
• 16-bit Low Energy Timer
• 1× 24-bit Real-Time Counter
• 3× 8-bit Pulse Counter
• Watchdog Timer with dedicated RC oscillator @ 50 nA
Communication interfaces
• 3× Universal Synchronous/Asynchronous Receiv-
er/Transmitter
• UART/SPI/SmartCard (ISO 7816)/IrDA
• Triple buffered full/half-duplex operation
• 2× Low Energy UART
• Autonomous operation with DMA in Deep Sleep
Mode
• I2C Interface with SMBus support
• Address recognition in Stop Mode
Ultra low power precision analog peripherals
• 12-bit 1 Msamples/s Analog to Digital Converter
• 8 single ended channels/4 differential channels
• On-chip temperature sensor
• 12-bit 500 ksamples/s Digital to Analog Converter
• 2 single ended channels/1 differential channel
• 2× Analog Comparator
• Capacitive sensing with up to 16 inputs
• Supply Voltage Comparator
Ultra efficient Power-on Reset and Brown-Out Detec-
tor
2-pin Serial Wire Debug interface
• 1-pin Serial Wire Viewer
Pre-Programmed UART Bootloader
Temperature range -40 to 85 ºC
Single power supply 1.98 to 3.8 V
QFN64 package
32-bit ARM Cortex-M0+, Cortex-M3 and Cortex-M4 microcontrollers for:
• Energy, gas, water and smart metering
• Health and fitness applications
• Smart accessories
• Alarm and security systems
• Industrial and home automation




EFM32G230 pdf, 반도체, 판매, 대치품
...the world's most energy friendly microcontrollers
into two blocks; the main block and the information block. Program code is normally written to the main
block. Additionally, the information block is available for special user data and flash lock bits. There is
also a read-only page in the information block containing system and device calibration data. Read and
write operations are supported in the energy modes EM0 and EM1.
2.1.4 Direct Memory Access Controller (DMA)
The Direct Memory Access (DMA) controller performs memory operations independently of the CPU.
This has the benefit of reducing the energy consumption and the workload of the CPU, and enables
the system to stay in low energy modes when moving for instance data from the USART to RAM or
from the External Bus Interface to a PWM-generating timer. The DMA controller uses the PL230 µDMA
controller licensed from ARM.
2.1.5 Reset Management Unit (RMU)
The RMU is responsible for handling the reset functionality of the EFM32G.
2.1.6 Energy Management Unit (EMU)
The Energy Management Unit (EMU) manage all the low energy modes (EM) in EFM32G microcon-
trollers. Each energy mode manages if the CPU and the various peripherals are available. The EMU
can also be used to turn off the power to unused SRAM blocks.
2.1.7 Clock Management Unit (CMU)
The Clock Management Unit (CMU) is responsible for controlling the oscillators and clocks on-board
the EFM32G. The CMU provides the capability to turn on and off the clock on an individual basis to all
peripheral modules in addition to enable/disable and configure the available oscillators. The high degree
of flexibility enables software to minimize energy consumption in any specific application by not wasting
power on peripherals and oscillators that are inactive.
2.1.8 Watchdog (WDOG)
The purpose of the watchdog timer is to generate a reset in case of a system failure, to increase appli-
cation reliability. The failure may e.g. be caused by an external event, such as an ESD pulse, or by a
software failure.
2.1.9 Peripheral Reflex System (PRS)
The Peripheral Reflex System (PRS) system is a network which lets the different peripheral module
communicate directly with each other without involving the CPU. Peripheral modules which send out
Reflex signals are called producers. The PRS routes these reflex signals to consumer peripherals which
apply actions depending on the data received. The format for the Reflex signals is not given, but edge
triggers and other functionality can be applied by the PRS.
2.1.10 Inter-Integrated Circuit Interface (I2C)
The I2C module provides an interface between the MCU and a serial I2C-bus. It is capable of acting as
both a master and a slave, and supports multi-master buses. Both standard-mode, fast-mode and fast-
mode plus speeds are supported, allowing transmission rates all the way from 10 kbit/s up to 1 Mbit/s.
Slave arbitration and timeouts are also provided to allow implementation of an SMBus compliant system.
The interface provided to software by the I2C module, allows both fine-grained control of the transmission
process and close to automatic transfers. Automatic recognition of slave addresses is provided in all
energy modes.
2015-05-22 - EFM32G230FXX - d0005_Rev1.90
4
www.silabs.com

4페이지










EFM32G230 전자부품, 판매, 대치품
Module
EMU
CMU
WDOG
PRS
I2C0
USART0
USART1
USART2
LEUART0
LEUART1
TIMER0
TIMER1
TIMER2
RTC
LETIMER0
PCNT0
PCNT1
PCNT2
ACMP0
ACMP1
VCMP
ADC0
DAC0
AES
GPIO
...the world's most energy friendly microcontrollers
Configuration
Full configuration
Full configuration
Full configuration
Full configuration
Full configuration
Full configuration with IrDA
Full configuration
Full configuration
Full configuration
Full configuration
Full configuration with DTI
Full configuration
Full configuration
Full configuration
Full configuration
Full configuration, 8-bit count register
Full configuration, 8-bit count register
Full configuration, 8-bit count register
Full configuration
Full configuration
Full configuration
Full configuration
Full configuration
Full configuration
56 pins
Pin Connections
NA
CMU_OUT0, CMU_OUT1
NA
NA
I2C0_SDA, I2C0_SCL
US0_TX, US0_RX. US0_CLK, US0_CS
US1_TX, US1_RX, US1_CLK, US1_CS
US2_TX, US2_RX, US2_CLK, US2_CS
LEU0_TX, LEU0_RX
LEU1_TX, LEU1_RX
TIM0_CC[2:0], TIM0_CDTI[2:0]
TIM1_CC[2:0]
TIM2_CC[2:0]
NA
LET0_O[1:0]
PCNT0_S[1:0]
PCNT1_S[1:0]
PCNT2_S[1:0]
ACMP0_CH[7:0], ACMP0_O
ACMP1_CH[7:0], ACMP1_O
NA
ADC0_CH[7:0]
DAC0_OUT[1:0]
NA
Available pins are shown in
Table 4.3 (p. 53)
2.3 Memory Map
The EFM32G230 memory map is shown in Figure 2.2 (p. 8) , with RAM and Flash sizes for the
largest memory configuration.
2015-05-22 - EFM32G230FXX - d0005_Rev1.90
7
www.silabs.com

7페이지


구       성 총 30 페이지수
다운로드[ EFM32G230.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
EFM32G230

microcontrollers

Energy Micro
Energy Micro
EFM32G230F128-QFN64

microcontrollers

Energy Micro
Energy Micro

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵