Datasheet.kr   

LC151X01-C3 데이터시트 PDF




LG에서 제조한 전자 부품 LC151X01-C3은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 LC151X01-C3 자료 제공

부품번호 LC151X01-C3 기능
기능 XGA TFT LCD
제조업체 LG
로고 LG 로고


LC151X01-C3 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.



전체 27 페이지수

미리보기를 사용할 수 없습니다

LC151X01-C3 데이터시트, 핀배열, 회로
Product Specification
SPECIFICATION
FOR
APPROVAL
LC151X01
Liquid Crystal Display
Title 15.1 XGA TFT LCD
BUYER
MODEL
SUPPLIER
LG.Philips LCD Co., Ltd.
-
*MODEL
LC151X01
MODEL
C3
*When you obtain standard approval,
please use the above model name without suffix
SIGNATURE
/
/
/
DATE
Please return 1 copy for your confirmation with
your signature and comments.
SIGNATURE
S.W Lee / G.Manager
REVIEWED BY
J.H Park / Manager
PREPARED BY
O.H LEE / Engineer
C.O Chang / Engineer
DATE
MNT/TV Products Engineering Dept.
LG. Philips LCD Co., Ltd
Ver. 0.2
Mar.06. 2002
1 / 27




LC151X01-C3 pdf, 반도체, 판매, 대치품
Product Specification
LC151X01
Liquid Crystal Display
1. General Description
The LC151X01 is a Color Active Matrix Liquid Crystal Display with an integral Cold Cathode Fluorescent
Lamp(CCFL) backlight system. The matrix employs a-Si Thin Film Transistor as the active element.
It is a transmissive type display operating in the normally white mode. This TFT-LCD has a 15.1 inch
diagonally measured active display area with XGA resolution (768 vertical by 1024 horizontal pixel array)
Each pixel is divided into Red, Green and Blue sub-pixels or dots which are arranged in vertical stripes.
Gray scale or the brightness of the sub-pixel color is determined with a 8-bit gray scale signal for each dot,
thus, presenting a palette of more than 16,2M colors with 6Bit FRC algorithm.
The LC151X01 has been designed to apply the 8Bit LVDS interface.
The LC151X01 is intended to support LCD TV, PCTV where high brightness, wide viewing angle,
high color saturation, and high color are important.
RGB,DLK,DE
Hsync,Vsync
(LVDS 1Port)
CN1
(20pin)
+5.0V
Timing Controller
(LVDS Rx integrated)
G1
TFT - LCD Panel
(1024 RGB 768 pixels)
G768
Power Circuit
Block
RGB
CN2,3(2pin)
CN4,5(2pin)
S1 S1024
Source Driver Circuit
Back light Assembly (4CCFL)
General Features
Active Screen Size
Outline Dimension
Pixel Pitch
Pixel Format
Color Depth
Luminance, White
Power Consumption
Weight
Display Operating Mode
Surface Treatment
Ver. 0.2
15.1 inches(38.4cm) diagonal
352(H) x 263.5(V) x 18.0(D) mm(Typ.)
0.300mm x 0.300mm
1024 horiz. By 768 vert. Pixels RGB strip arrangement
6bit FRC algorithm, 16,2 M colors
400 cd/m2 (Center 1 points typ.)
Total 18.7 Watt(Typ.)
1,750 g (typ.)
Transmissive mode, normally white
Hard coating(3H) & Anti-glare (Haze 13%) treatment of the front polarizer
Mar.06. 2002
4 / 27

4페이지










LC151X01-C3 전자부품, 판매, 대치품
Product Specification
LC151X01
Liquid Crystal Display
5. The output of the inverter must have symmetrical(negative and positive) voltage waveform and
symmetrical current waveform.(Unsymmetrical ratio is less than 10%) Please do not use the inverter
which has unsymmetrical voltage and unsymmetrical current and spike wave.
Lamp frequency may produce interface with horizontal synchronous frequency and as a result this may
cause beat on the display. Therefore lamp frequency shall be as away possible from the horizontal
synchronous frequency and from its harmonics in order to prevent interference.
6. Let s define the brightness of the lamp after being lighted for 5 minutes as 100%.
TS is the time required for the brightness of the center of the lamp to be not less than 95%.
7. The lamp power consumption shown above does not include loss of external inverter.
The used lamp current is the lamp typical current.
8. The life is determined as the time at which brightness of the lamp is 50% compared to that of initial
value at the typical lamp current on condition of continuous operating at 25 ± 2 C.
9. Requirements for a system inverter design, which is intended to have a better display performance, a
better power efficiency and a more reliable lamp, are following.
It shall help increase the lamp lifetime and reduce leakage current.
a. The asymmetry rate of the inverter waveform should be less than 10%.
b. The distortion rate of the waveform should be within 2 ±10%.
* Inverter output waveform had better be more similar to ideal sine wave.
Ip
I -p
* Asymmetry rate:
| I p – I –p | / Irms * 100%
* Distortion rate
I p (or I –p) / Irms
Do not attach a conducting tape to lamp connecting wire.
If the lamp wire attach to a conducting tape, TFT-LCD Module has a low luminance and the inverter
has abnormal action. Because leakage current is occurred between lamp wire and conducting tape.
Ver. 0.2
Mar.06. 2002
7 / 27

7페이지


구       성 총 27 페이지수
다운로드[ LC151X01-C3.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
LC151X01-C3

XGA TFT LCD

LG
LG

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵