|
|
|
부품번호 | AA121SL02 기능 |
|
|
기능 | SVGA Display Module | ||
제조업체 | Mitsubishi | ||
로고 | |||
TENTATIVE
All information in this technical data sheet is tentative
and subject to change without notice
12.1” SVGA
TECHNICAL SPECIFICATION
AA121SL02
MITSUBISHI ELECTRIC Corp.
MITSUBISHI Confidential
(1/22)
Date: Feb.8,’05
AA121SL02_02_00
2. OVERVIEW
AA121SL02 is 12.1” color TFT-LCD (Thin Film Transistor Liquid Crystal Display) module
composed of LCD panel, driver ICs, control circuit, and backlight unit.
By applying 6 bit digital data, 800 × 600, 260 K-color images are displayed on the 12.1” diagonal
screen. Input power voltage is single 3.3V or 5.0V for LCD driving.
The type of date and control signals are digital and transmitted via CMOS interface per typ.
40MHz clock cycle.
Inverter for backlight is not included in this module. General specifications are summarized in the
following table:
ITEM
Display Area (mm)
Number of Dots
Pixel Pitch (mm)
Color Pixel Arrangement
Display Mode
Number of Color
Brightness (cd/m2)
Wide Viewing Angle Technology
Viewing Angle(CR≥10)
Surface Treatment
Electrical Interface
Optimum Viewing Angle(Contrast ratio)
Module Size (mm)
Module Mass (g)
Backlight Unit
SPECIFICATION
246.0(H) × 184.5(V)
(12.106-inch diagonal)
800 × 3 (H) × 600 (V)
0.3075 (H) × 0.3075 (V)
RGB vertical stripe
Normally whiteTN
260 K
400
Optical compensation Film
-65∼65°(H) -75∼45°(V)
Antireflection and hard-coating 2H
CMOS
6 o’clock
280.0 (W) × 210.0 (H) × 12.0 (D)
720
CCFL, 2-tubes, edge-light, replaceable
Characteristic value without any note is typical value.
MITSUBISHI Confidential
(4/22)
AA121SL02_02_00
4페이지 1) Lamp Current measurement method (The current meter is inserted in low voltage line.)
LCD
Module
CTL
CTH
CTH
A
Inverter
Power
Supply
2) Lamp frequency of inverter may produce interference with horizontal synchronous frequency, and
this may cause horizontal beat on the display. Therefore, please adjust lamp frequency, and keep
inverter as far from module as possible or use electronic shielding between inverter and module
to avoid the interference.
3) Lamp life time is defined as the time either when the brightness becomes 50% of the initial value,
or when the starting lamp voltage does not meet the value specified in this table.
4) The life time of the backlight depends on the ambient temperature. The life time will decrease
under low/high temperature.
5) Please use the inverter which has symmetrical current wave form as follows,
The degree of unbalance: less than 10%
The ratio of wave height: less than 2 ±10%
IPH IPH: High side peak The degree of unbalance = | IPH - IPL | / Irms × 100(%)
IPL IPL: Low side peak The ratio of wave height = IPH(or IPL) / Irms
CURRENT WAVE FORM
MITSUBISHI Confidential
(7/22)
AA121SL02_02_00
7페이지 | |||
구 성 | 총 22 페이지수 | ||
다운로드 | [ AA121SL02.PDF 데이터시트 ] |
당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는 |
구매 문의 | 일반 IC 문의 : 샘플 및 소량 구매 ----------------------------------------------------------------------- IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한 광범위한 전력 반도체를 판매합니다. 전력 반도체 전문업체 상호 : 아이지 인터내셔날 사이트 방문 : [ 홈페이지 ] [ 블로그 1 ] [ 블로그 2 ] |
부품번호 | 상세설명 및 기능 | 제조사 |
AA121SL01 | SVGA Display Module | Mitsubishi |
AA121SL02 | SVGA Display Module | Mitsubishi |
DataSheet.kr | 2020 | 연락처 | 링크모음 | 검색 | 사이트맵 |