DataSheet.es    


PDF IP178G Data sheet ( Hoja de datos )

Número de pieza IP178G
Descripción 8 Port 10/100 Ethernet Integrated Switch
Fabricantes IC Plus 
Logotipo IC Plus Logotipo



Hay una vista previa y un enlace de descarga de IP178G (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! IP178G Hoja de datos, Descripción, Manual

IP178G
Data Sheet
8 Port 10/100 Ethernet Integrated Switch
(85nm /Extreme Low Power, PWMT® and AFT® )
Features
General Description
8 port Embedded 10/100 PHY Switch Controller
Support 8 100BaseTX or 6 100Base TX + 2 FX
100M PHY support IEEE802.3az at full duplex
10M PHY only support 10BaseTe
Support Auto MDI-MDIX function
Power Management Tool (PWMT®)
- APS, auto-power saving while Link-off
- IEEE 802.3az protocol based power saving
- WOL+®, light traffic power saving
- PWD, force-off power saving
Support Auto Factory Test (AFT®)
Single Power 3.3V supply
Built in 1.1V core voltage LDO Regulator
Two Priority queues per port
Support 802.1p & DiffServ based QoS
QoS
- Port base
- 802.1p
- IP DiffServ IPV4/IPV6
- TCP/UDP port number
- Pins configure ports priority (VIP port)
Support max forwarding packet length 1552/1536
bytes option
Embedded 448K bits packet buffer
Support port mirror function
Support 1k MAC address
Support broadcast storm protection
Support port trunking (Link Aggregation)
Support 16 VLAN (IEEE Std 802.1q)
- Port-based/Tagged-based VLAN
- Support Port-based insert, remove tag
Built-in 50 ohm resistors for simplifying BOM
85nm Process
Package and operation temperature
- IP178G: 68 Pin QFN, 0~70
IP178G is fabricated with advanced CMOS
(85nm) technology and only requires a 3.3V single
power supply. This feature makes IP178G used
very low power consume, such as the full load
operation (100Mbps full duplex 8 ports), it only
takes 0.95W.
IP178G also supports Power Management Tool
(PWMT®) for IEEE 802.3az, APS, WOL+ and PWD
for Green Power. While two link devices have no
IEEE 802.3az capability, IP178G use WOL+ to
change link from 100Mbps to 10Mbps for saving
power.
The PWD, force-off power saving of IP178G is
designed for power down switch immediately by
pushing a button, user don’t plug out the power
adapter. Push the button again, it will power on
immediately.
Except Low Power and Rich Power Saving
method, IP178G supports AFT® for saving
Customer Testing Cost. By using a push button and
cables, IP178G will Auto test completely by itself.
Application
8 port 10/100 Dumb switch
6TX+2FX Dumb Switch or 7TX + 1FX Dumb Switch
www.BDTIC.com/ICplusCopyright© 2012, IC Plus Corp.
1 / 76
December 19, 2012
IP178G-DS-R01.3

1 page




IP178G pdf
IP178G
Data Sheet
List of Tables
Table 1 IP178D and IP178G/GA Features comparison table ..................................................... 8
Table 2 Pin description ............................................................................................................. 13
Table 3 Rserved Group MAC Address table............................................................................. 20
Table 4 VIP port pin setting table .............................................................................................. 25
Table 5 TCP/UDP logical port priority table .............................................................................. 28
Table 6 LED Blink Timing.......................................................................................................... 32
Table 7 Fiber port Parameter .................................................................................................... 33
Table 8 MII register map table .................................................................................................. 34
Table 9 PHY Register Map ....................................................................................................... 35
Table 10 MMD Control Register table....................................................................................... 43
Table 11 MMD Data Register table ........................................................................................... 44
Table 12 LED mode Control Register table .............................................................................. 47
Table 13 WOL+ Control Register table ..................................................................................... 48
Table 14 Page control registers table ....................................................................................... 49
Table 15 Switch control registers (I) table................................................................................. 50
Table 16 Test mode control registers table ............................................................................... 51
www.BDTIC.com/ICplusCopyright© 2012, IC Plus Corp.
5 / 76
December 19, 2012
IP178G-DS-R01.3

5 Page





IP178G arduino
IP178G
Data Sheet
2.3 TCP/UDP QoS Switch for time-sensitive application from EEPROM setting
IP178G
High Low Low Low Low Low Low Low
Priority Priority Priority Priority Priority Priority Priority Priority
Port 0 Port 1 Port 2 Port 3 Port 4 Port 5 Port 6 Port 7
24C01~16
TP
Port 0 received packet with reserved TCP/UDP port number, Port 0 will enable its
ingress port as a high priority port for 300 seconds.
If the other ports received packets with the same reserved port number, it also has the
same behavior as port 0.
2.4 Switch with VIP ports for specific users from Pin setting
IP178G
VIP VIP VIP
VIP VIP VIP
Port 0 Port 1 Port 2 Port 3 Port 4 Port 5 Port 6 Port 7
VIP port setting as follow,
HIGH_PRI[2:0]
IP178G Pin 42,43,44
IP178GA Pin 89,90,91
001
010
011
101
110
000
111
TP
high priority port number
6, 7
5, 6, 7
7
0, 1
0, 1, 2
0
disable (default)
www.BDTIC.com/ICplusCopyright© 2012, IC Plus Corp.
11 / 76
December 19, 2012
IP178G-DS-R01.3

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet IP178G.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
IP178A8-Port 10/100 Ethernet Integrated SwitchIC Plus
IC Plus
IP178C8-Port 10/100 Ethernet Integrated SwitchIC Plus
IC Plus
IP178G8 Port 10/100 Ethernet Integrated SwitchIC Plus
IC Plus

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar