|
|
|
부품번호 | TFTMD80120CBB 기능 |
|
|
기능 | WXGA Super-TFT Module | ||
제조업체 | Hitachi | ||
로고 | |||
Global LCD Panel Exchange Center
www.panelook.com
Hitachi Displays, Ltd.
DATE : Nov. 10, 2003
Technical Sheets of 32 cm diagonal WXGA Super-TFT Module
Product Name : TFTMD80120CBB
CONTENTS
No. Item
- COVER
- RECORD OF REVISION
- DESCRIPTION
1 ABSOLUTE MAXIMUM RATINGS
2 OPTICAL CHARACTERISTICS
3 ELECTRICAL CHARACTERISTICS
4 BLOCK DIAGRAM
5 INTERFACE PIN CONNECTION
6 INTERFACE TIMING
7 DIMENSIONAL OUTLINE
8 DESIGNATION OF LOTMARK
9 PRECAUTION
Sheet No.
3284STD-2188-1
3284STD-2188-1
3284STD-2188-1
3284STD-2188-1
3284STD-2188-1
3284STD-2188-1
3284STD-2188-1
3284STD-2188-1
3284STD-2188-1
3284STD-2188-1
3284STD-2188-1
Page
1-1/1
2-1/1
3-1/1
4-1/1
5-1/2 - 2/2
6-1/1
7-1/1
8-1/6 - 6/6
9-1/3-3/3
10 -1/2-2/2
11-1/1
12-1/3-3/3
The information described in this technical specification is tentative and it is possible to be changed without prior notice.
Hitachi Displays, Ltd.
Sheet
No.
3284STD-2188-1
Page 1-1/1
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center
www.panelook.com
1. ABSOLUTE MAXIMUM RATINGS
1.1 Environmental Absolute Maximum Ratings
ITEM
Operating
Min. Max.
Temperature
Humidity
Vibration
Shock
Corrosive Gas
0 50
2)
- 4.9(0.5G)
- 29.4(3G)
Not Acceptable
Illumination at
LCD Surface
-
50,000
Storage
Min. Max.
-20 60
2)
- 9.8 (1G)
- 147 (15G)
Not Acceptable
- 50,000
Unit
RH
m/s 2
m/s 2
-
lx
Note
1),5)
1)
3)
4)
Note 1) Temperature and Humidity should be applied to the glass surface of a Super-TFT module,
not to the system installed with a module.
The temperature at the center of rear surface should be less than 70 on the condition of operating.
The brightness of a CCFL tends to drop at low temperature. Besides, the life-time becomes shorter
at low temperature.
2) Ta 40
Relative humidity should be less than
85%RH max. Dew is prohibited.
Ta 40
Relative humidity should be lower than
the moisture of the 85%RH at 40 .
3) Frequency of the vibration is between 15Hz and 100Hz. (Remove the resonance point)
4) Pulse width of the shock is 10 ms.
5) Long operation under low temperature may cause some portion of display area to be reddish for
several minutes after turning on the product.
However, it does not affect the characteristics and reliability of the product.
1.2 Electrical Absolute Maximum Ratings
(1)Super-TFT Module
ITEM
Power Supply Voltage
Input Voltage for logic
Electrostatic Durability
SYMBOL
DD
I
ESD0
ESD1
Min. Max.
0 13.2
-0.3 3.6
100
8
Unit
V
V
V
V
Vss = 0 V
Note
1)
2),3)
2),4)
Note 1)It is applied to pixel data signal and clock signal.
2)Discharge Coefficient 200pF-250 , Environmental 25 -70 RH
3)It is applied to I/F connector pins.
4)It is applied to the surface of a metallic bezel and a LCD panel.
(2) Back-light
GND = 0 V
ITEM
Input Current
Input Voltage
SYMBOL
IL
VL
Min.
-
-
Max.
7.0
2,000
Unit
mArms
Vrms
Note
1)
2)
Note 1)The specification shall be applied to each CFL. The specification is defined at ground line.
2)The specification shall be applied at connector pins for a CFL at start-up.
Hitachi Displays, Ltd.
Date Nov.10,2003 Sheet
No.
3284STD-2188-1
Page 4-1/1
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
4페이지 Global LCD Panel Exchange Center
www.panelook.com
3. ELECTRICAL CHARACTERISTICS
3.1 TFT-LCD Module
ITEM
Power Supply Voltage
SYMBOL
DD
Min.
11.4
Power Supply Current
DD
Ripple Voltage of Power Supply
DDR
Typ.
12.0
0.59
Ta=25 Vss=0V
Max. Unit
Note
12.6 V
0.80 A
1),2)
0.15 V
Note 1) DC current at fv=60.0Hz, fCLK=82MHz, VDD=12.0V and Display pattern is white.
DC Ampere Meter
Super-TFT Module
DD
SS
2) Current fuse is built in a module. Current capacity of power supply for VDD
should be larger than 4A, so that the fuse can be opened at the trouble of power supply.
3.2 Back Light
ITEM
Input Current
Input Voltage
Frequency
Kick-Off Voltage
SYMBOL
IL
VL
f0
Vs
Min.
3 .0
-
50
-
Typ.
5 .0
1290
55
-
Max.
6 .0
-
60
1,600
Unit
mArms
Vrms
kHz
V
Note
1)
2)
3)
Notes 1) The specification shall be applied to each CFL. The specification is defined at ground line.
2) Frequency of power supply for a CFL may cause the interference with HSYNC frequency
and cause beat or flicker on the display. Therefore, lamp frequency shall be as different
as possible from HSYNC frequency in order to avoid the interference.
3) Ta = 0 degree
Hitachi Displays, Ltd.
Date Nov.10,2003 Sheet
No.
3284STD-2188-1
Page 6-1/1
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
7페이지 | |||
구 성 | 총 22 페이지수 | ||
다운로드 | [ TFTMD80120CBB.PDF 데이터시트 ] |
당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는 |
구매 문의 | 일반 IC 문의 : 샘플 및 소량 구매 ----------------------------------------------------------------------- IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한 광범위한 전력 반도체를 판매합니다. 전력 반도체 전문업체 상호 : 아이지 인터내셔날 사이트 방문 : [ 홈페이지 ] [ 블로그 1 ] [ 블로그 2 ] |
부품번호 | 상세설명 및 기능 | 제조사 |
TFTMD80120CBB | WXGA Super-TFT Module | Hitachi |
DataSheet.kr | 2020 | 연락처 | 링크모음 | 검색 | 사이트맵 |