ITSX95E 데이터시트 PDF

ITSX95E 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.



전체 30 페이지수

미리보기를 사용할 수 없습니다

Global LCD Panel Exchange Center

www.panelook.com

Engineering Specification

Engineering Specification

Type 15.0 SXGA+ Color TFT/LCD Module

Model Name:ITSX95E

Document Control Number : OEM I-95E-04

Note:Specification is subject to change without notice. Consequently it is better to contact to

International Display Technology before proceeding with the design

of your product incorporating this module.

Product Development

International Display Technology

(C) Copyright International Display Technology 2002 All Rights reserved.

January 15,2002

OEM I-95E-04

1/30

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

Global LCD Panel Exchange Center

www.panelook.com

Engineering Specification

1.0 Handling Precautions

1) Since front polarizer is easily damaged, pay attention not to scratch it.

2) Be sure to turn off power supply when inserting or disconnecting from input connector.

3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.

4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.

5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.

6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth

when handling.

7) Do not open nor modify the Module Assembly.

8) Do not press the reflector sheet at the back of the module to any directions.

9) In case if a Module has to be put back into the packing container slot after once it was taken out

from the container, do not press the center of the CFL Reflector edge.

Instead, press at the far ends of the CFL Reflector edge softly. Otherwise the TFT Module may

be damaged.

10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the

Interface Connector of the TFT Module.

11) After installation of the TFT Module into an enclosure ( Notebook PC Bezel, for example),

do not twist nor bent the TFT Module even momentary. At designing the

enclosure, it should be taken into consideration that no bending/twisting forces are applied

to the TFT Module from outside. Otherwise the TFT Module may be damaged.

12) The fluorescent lamp in the liquid crystal display (LCD) contains mercury. Do not put it in trash that is

disposed of in landfills. Dispose of it as required by local ordinances or regulations.

13) Small amount of materials having no flammability grade is used in the LCD module.

The LCD module should be supplied by power complied with requirements of

Limited Power Source (2.11, IEC60950 or UL1950), or be applied exemption

conditions of flammability requirements (4.4.3.3, IEC60950 or UL1950) in an end product.

O The information contained herein is presented only as a guide for the applications of our

products. No responsibility is assumed by International Display Technology for any

infringements of patents or other right of the third partied which may result from its use. No

license is granted by implication or otherwise under any patent or patent rights of International

Display Technology or others.

O The information contained herein may be changed without prior notice. It is therefore

advisable to contact International Display Technology before proceeding with the design of

equipment incorporating this product.

(C) Copyright International Display Technology 2002 All Rights reserved.

January 15,2002

OEM I-95E-04

4/30

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

Global LCD Panel Exchange Center

www.panelook.com

Engineering Specification

2.2 Functional Block Diagram

The following diagram shows the functional block of the 38.1cm(15.0") Color TFT/LCD Module.

Y-Driver

< 8 pairs LVDS >

6bit color data

for R/G/B

(even/odd)

DTCLK(even/odd)

DSPTMG

Vsync

Hsync

VEEDID

CLKEEDID

Data EEDID

VDD

LCD DRIVE

CARD

EVEN

PIXCEL

ODD

PIXCEL

LCD

Controller

Dual LVDS

RECEIVER

G/A

DC-DC

EEPROM Converter

Ref circuit

GND

LCD-DRIVE Connector

JAE FI-XB30S-HF10 (30pin)

Inverter Connector

MOLEX 52207-1690 (16pin)

Panel IDsp

SMB_CLK

SMB_DAT

FPVEE

PWR_SRC

5VSUS

5VALW

GND

INVERTER

X-Driver

TFT ARRAY/CELL

1400(R/G/B) x 1050

Backlight Unit

(C) Copyright International Display Technology 2002 All Rights reserved.

January 15,2002

OEM I-95E-04

7/30

One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.