Datasheet.kr   

LM358F 데이터시트 PDF




ROHM Semiconductor에서 제조한 전자 부품 LM358F은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 LM358F 자료 제공

부품번호 LM358F 기능
기능 Ground Sense Operational Amplifiers
제조업체 ROHM Semiconductor
로고 ROHM Semiconductor 로고


LM358F 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.




전체 23 페이지수

미리보기를 사용할 수 없습니다

LM358F 데이터시트, 핀배열, 회로
Datasheet
Operational Amplifiers
Ground Sense Operational Amplifiers
LM358F
General Description
LM358F integrate two independent Op-Amps on a
single chip and features low current consumption, and
wide operating voltage range of from +3V to +36V
(single power supply).
Features
Operable with a Single Power Supply
Wide Operating Supply Voltage Range
Input / Output GND Sense
High Large Signal Voltage Gain
Key Specification
Operating Supply Voltage (single supply):
+3.0V to +36.0V
Temperature Range:
-40°C to +85°C
Input Offset Voltage:
4.5mV (Max)
Input Bias Current:
20nA (Typ)
Package
SOP8
W(Typ) x D(Typ) x H(Max)
5.00mm x 6.20mm x 1.71mm
Application
Current Sense Application
Buffer Application Amplifier
Active Filter
Consumer Electronics
Pin Configuration
OUT1 1
-IN1 2
+IN1 3
VEE 4
-CH1++
CH2
+-
8 VCC
7 OUT2
6 -IN2
5 +IN2
Pin No.
1
2
3
4
5
6
7
8
Pin Name
OUT1
-IN1
+IN1
VEE
+IN2
-IN2
OUT2
VCC
Package
SOP8
LM358F
Product structureSilicon monolithic integrated circuit This product has no designed protection against radioactive rays.
www.rohm.com
©2015 ROHM Co., Ltd. All rights reserved.
TSZ2211114001
1/20
TSZ02201-0RAR0G200190-1-2
12.May.2015 Rev.001




LM358F pdf, 반도체, 판매, 대치품
LM358F
Datasheet
Description of Electrical Characteristics
Described below are descriptions of the relevant electrical terms used in this datasheet. Items and symbols used are also
shown. Note that item name and symbol and their meaning may differ from those on another manufacturer’s document or
general document.
1. Absolute maximum ratings
Absolute maximum rating items indicate the condition which must not be exceeded. Application of voltage in excess of absolute
maximum rating or use out of absolute maximum rated temperature environment may cause deterioration of characteristics.
(1) Supply Voltage (VCC/VEE)
Indicates the maximum voltage that can be applied between the VCC pin and VEE pin without deterioration or
destruction of characteristics of internal circuit.
(2) Differential Input Voltage (VID)
Indicates the maximum voltage that can be applied between non-inverting and inverting pins without damaging the IC.
(3) Input Common-mode Voltage Range (VICM)
Indicates the maximum voltage that can be applied to the non-inverting and inverting pins without deterioration or
destruction of electrical characteristics. Input common-mode voltage range of the maximum ratings does not assure
normal operation of IC. For normal operation, use the IC within the input common-mode voltage range characteristics.
(4) Power Dissipation (Pd)
Indicates the power that can be consumed by the IC when mounted on a specific board at the ambient temperature 25°C
(normal temperature). As for package product, Pd is determined by the temperature that can be permitted by the IC in
the package (maximum junction temperature) and the thermal resistance of the package.
2. Electrical characteristics
(1) Input Offset Voltage (VIO)
Indicates the voltage difference between non-inverting pin and inverting pin. It can be translated into the input voltage
difference required for setting the output voltage at 0V.
(2) Input offset voltage drift (VIO/T)
Denotes the ratio of the input offset voltage fluctuation to the ambient temperature fluctuation.
(3) Input Offset Current (IIO)
Indicates the difference of input bias current between the non-inverting and inverting pins.
(4) Input Bias Current (IB)
Indicates the current that flows into or out of the input pin. It is defined by the average of input bias currents at the
non-inverting and inverting pins.
(5) Supply Current (ICC)
Indicates the current that flows within the IC under specified no-load conditions.
(6) Maximum Output Voltage(High) / Maximum Output Voltage(Low) (VOH/VOL)
Indicates the voltage range of the output under specified load condition. It is typically divided into maximum output
voltage high and low. Maximum output voltage high indicates the upper limit of output voltage. Maximum output
voltage low indicates the lower limit.
(7) Large Signal Voltage Gain (AV)
Indicates the amplifying rate (gain) of output voltage against the voltage difference between non-inverting pin and
inverting pin. It is normally the amplifying rate (gain) with reference to DC voltage.
Av = (Output Voltage) / (Differential Input Voltage)
(8) Input Common-mode Voltage Range (VICM)
Indicates the input voltage range where IC normally operates.
(9) Common-mode Rejection Ratio (CMRR)
Indicates the ratio of fluctuation of input offset voltage when the input common-mode voltage is changed. It is normally
the fluctuation of DC.
CMRR = (Change of Input Common-mode Voltage)/(Input Offset Fluctuation)
www.rohm.com
©2015 ROHM Co., Ltd. All rights reserved.
TSZ2211115001
4/20
TSZ02201-0RAR0G200190-1-2
12.May.2015 Rev.001

4페이지










LM358F 전자부품, 판매, 대치품
LM358F
Typical Performance Curves - continued
Datasheet
5.0
4.5
4.0
3.5
3.0
2.5
2.0
1.5
1.0
0.5
0.0
-50
-25 0
25 50 75
Ambient Temperature [°C]
100
Figure 5. Maximum Output Voltage (High)
vs Ambient Temperature (VCC=5V, RL=2kΩ)
50
40
-40°C
30
25°C
20
85°C
10
0
012345
Output Voltage [V]
Figure 6. Output Source Current vs Output Voltage
(VCC=5V)
50
40
30
5V
20 36V 3V
10
0
-50
-25 0 25 50 75
Ambient Temperature [°C]
100
Figure 7. Output Source Current
vs Ambient Temperature (VOUT=0V)
50
40
30 25°C
85°C
20
-40°C
10
0
0
123
Output Voltage [V]
4
5
Figure 8. Output Sink Current vs Output Voltage
(VCC=5V)
(*) The above data are measurement value of typical sample, they are not guaranteed.
www.rohm.com
©2015 ROHM Co., Ltd. All rights reserved.
TSZ2211115001
7/20
TSZ02201-0RAR0G200190-1-2
12.May.2015 Rev.001

7페이지


구       성 총 23 페이지수
다운로드[ LM358F.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
LM358

DUAL DIFFERENTIAL INPUT OPERATIONAL AMPLIFIERS

Motorola  Inc
Motorola Inc
LM358

Single Supply Dual Operational Amplifier

ON Semiconductor
ON Semiconductor

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵