Datasheet.kr   

ST7LITE30 데이터시트 PDF




STMicroelectronics에서 제조한 전자 부품 ST7LITE30은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 ST7LITE30 자료 제공

부품번호 ST7LITE30 기능
기능 8-BIT MCU
제조업체 STMicroelectronics
로고 STMicroelectronics 로고


ST7LITE30 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.



전체 30 페이지수

미리보기를 사용할 수 없습니다

ST7LITE30 데이터시트, 핀배열, 회로
www.DataSheet4U.com
ST7LITE3
8-BIT MCU WITH SINGLE VOLTAGE FLASH, DATA EEPROM, ADC,
TIMERS, SPI, LINSCI
Memories
– 8 Kbytes program memory: single voltage ex-
tended Flash (XFlash) Program memory with
read-out protection, In-Circuit Programming
and In-Application programming (ICP and
IAP), data retention: 20 years at 55°C.
– 384 bytes RAM
– 256 bytes data EEPROM with read-out pro-
tection. 300K write/erase cycles guaranteed,
data retention: 20 years at 55°C.
Clock, Reset and Supply Management
– Enhanced reset system
– Enhanced low voltage supervisor (LVD) for
main supply and an auxiliary voltage detector
(AVD) with interrupt capability for implement-
ing safe power-down procedures
– Clock sources: Internal RC1% oscillator, crys-
tal/ceramic resonator or external clock
– Optional x4 or x8 PLL for 4 or 8 MHz internal
clock
– Five Power Saving Modes: Halt, Active-Halt,
Wait and Slow, Auto Wake Up From Halt
I/O Ports
– Up to 15 multifunctional bidirectional I/O lines
– 7 high sink outputs
5 Timers
– Configurable Watchdog Timer
– Two 8-bit Lite Timers with prescaler,
1 realtime base and 1 input capture
– Two 12-bit Auto-reload Timers with 4 PWM
outputs, input capture and output compare
functions
Device Summary
DIP20
SO20
2 Communication Interfaces
– Master/slave LINSCIasynchronous serial
interface
– SPI synchronous serial interface
Interrupt Management
– 10 interrupt vectors plus TRAP and RESET
– 12 external interrupt lines (on 4 vectors)
A/D Converter
– 7 input channels
– 10-bit resolution
Instruction Set
8-bit data manipulation
– 63 basic instructions with illegal opcode
detection
– 17 main addressing modes
– 8 x 8 unsigned multiply instructions
Development Tools
– Full hardware/software development package
– DM (Debug module)
Features
Program memory - bytes
RAM (stack) - bytes
Data EEPROM - bytes
Peripherals
Operating Supply
CPU Frequency
Operating Temperature
Packages
ST7LITE30
ST7LITE35
ST7LITE39
8K
384 (128)
- - 256
Lite Timer, Autoreload Timer, SPI, LINSCI, 10-bit ADC
2.7V to 5.5V
Up to 8Mhz
(w/ ext OSC up to 16MHz)
Up to 8Mhz (w/ ext OSC up to 16MHz
and int 1MHz RC 1% PLLx8/4MHz)
-40°C to +85°C
SO20 300”, DIP20
July 2005
Rev. 4.0
1/167
1




ST7LITE30 pdf, 반도체, 판매, 대치품
ST7LITE3
1 INTRODUCTION
The ST7LITE3 is a member of the ST7 microcon-
troller family. All ST7 devices are based on a com-
mon industry-standard 8-bit core, featuring an en-
hanced instruction set.
The ST7LITE3 features FLASH memory with
byte-by-byte In-Circuit Programming (ICP) and In-
Application Programming (IAP) capability.
Under software control, the ST7LITE3 device can
be placed in WAIT, SLOW, or HALT mode, reduc-
ing power consumption when the application is in
idle or standby state.
The enhanced instruction set and addressing
modes of the ST7 offer both power and flexibility to
software developers, enabling the design of highly
Figure 1. General Block Diagram
efficient and compact application code. In addition
to standard 8-bit data management, all ST7 micro-
controllers feature true bit manipulation, 8x8 un-
signed multiplication and indirect addressing
modes.
For easy reference, all parametric data are located
in section 13 on page 129.
The devices feature an on-chip Debug Module
(DM) to support in-circuit debugging (ICD). For a
description of the DM registers, refer to the ST7
ICC Protocol Reference Manual.
CLKIN
OSC1
OSC2
VDD
VSS
RESET
Int.
1% RC
1MHz
PLL x 8
or PLL X4
Ext.
OSC
1MHz
to
16MHz
/2
LVD
POWER
SUPPLY
CONTROL
8-BIT CORE
ALU
Internal
CLOCK
PROGRAM
MEMORY
(8K Bytes)
RAM
(384 Bytes)
12-Bit
Auto-Reload
TIMER 2
8-Bit
LITE TIMER 2
PORT A
PORT B
ADC
Debug Module
SPI
LINSCI
WDG
DATA EEPROM
( 256 Bytes)
PA7:0
(8 bits)
PB6:0
(7 bits)
4/167
1

4페이지










ST7LITE30 전자부품, 판매, 대치품
ST7LITE3
Pin
No.
Pin Name
Level
Port / Control
Main
Input
Output Function
(after
reset)
Alternate Function
PA6 /MCO/
12 ICCCLK/
BREAK
I/O CT
X
ei1
13
PA5 /ATPWM3/
ICCDATA
I/O
CT
HS
14 PA4/ATPWM2 I/O CT HS
15 PA3/ATPWM1 I/O CT HS
16 PA2/ATPWM0 I/O CT HS
17 PA1/ATIC
I/O CT HS
18 PA0/LTIC
I/O CT HS
19 OSC2
O
X
X
X
X
X
X
ei0
X
20 OSC1/CLKIN I
Main Clock Output or In Circuit Commu-
nication Clock or External BREAK
Caution: During normal operation this
pin must be pulled- up, internally or ex-
X X Port A6 ternally (external pull-up of 10k manda-
tory in noisy environment). This is to
avoid entering ICC mode unexpectedly
during a reset. In the application, even if
the pin is configured as output, any re-
set will put it back in input pull-up.
X
X Port A5
Auto-Reload Timer PWM3 or In Circuit
Communication Data
X X Port A4 Auto-Reload Timer PWM2
X X Port A3 Auto-Reload Timer PWM1
X X Port A2 Auto-Reload Timer PWM0
X X Port A1 Auto-Reload Timer Input Capture
X X Port A0 Lite Timer Input Capture
Resonator oscillator inverter output
Resonator oscillator inverter input or External clock
input
Note:
For input with interrupt possibility “eix” defines the associated external interrupt vector which can be as-
signed to one of the I/O pins using the EISR register. Each interrupt can be either weak pull-up or floating
defined through option register OR.
7/167
1

7페이지


구       성 총 30 페이지수
다운로드[ ST7LITE30.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
ST7LITE3

8-BIT MCU

ST Microelectronics
ST Microelectronics
ST7LITE30

8-BIT MCU

STMicroelectronics
STMicroelectronics

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵