Datasheet.kr   

GA10JT12-263 데이터시트 PDF




GeneSiC에서 제조한 전자 부품 GA10JT12-263은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.


PDF 형식의 GA10JT12-263 자료 제공

부품번호 GA10JT12-263 기능
기능 Normally - OFF Silicon Carbide Junction Transistor
제조업체 GeneSiC
로고 GeneSiC 로고


GA10JT12-263 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.




전체 12 페이지수

미리보기를 사용할 수 없습니다

GA10JT12-263 데이터시트, 핀배열, 회로
Normally – OFF Silicon Carbide
Junction Transistor
Features
175 °C Maximum Operating Temperature
Gate Oxide Free SiC Switch
Exceptional Safe Operating Area
Excellent Gain Linearity
Temperature Independent Switching Performance
Low Output Capacitance
Positive Temperature Coefficient of RDS,ON
Suitable for Connecting an Anti-parallel Diode
Advantages
Compatible with Si MOSFET/IGBT Gate Drive ICs
> 20 µs Short-Circuit Withstand Capability
Lowest-in-class Conduction Losses
High Circuit Efficiency
Minimal Input Signal Distortion
High Amplifier Bandwidth
Package
RoHS Compliant
D
GA10JT12-263
VDS
RDS(ON)
ID (Tc = 25°C)
hFE (Tc = 25°C)
=
=
=
=
1200 V
120 mΩ
25 A
80
D
GDS
G
S
TO-263
 
Applications
Down Hole Oil Drilling, Geothermal Instrumentation
Hybrid Electric Vehicles (HEV)
Solar Inverters
Switched-Mode Power Supply (SMPS)
Power Factor Correction (PFC)
Induction Heating
Uninterruptible Power Supply (UPS)
Motor Drives
Table of Contents
Section I: Absolute Maximum Ratings .......................................................................................................... 1 
Section II: Static Electrical Characteristics................................................................................................... 2 
Section III: Dynamic Electrical Characteristics ............................................................................................ 2 
Section IV: Figures .......................................................................................................................................... 3 
Section V: Driving the GA10JT12-263 ........................................................................................................... 7 
Section VI: Package Dimensions ................................................................................................................. 11 
Section VII: SPICE Model Parameters ......................................................................................................... 12 
Section I: Absolute Maximum Ratings
Parameter
Drain – Source Voltage
Continuous Drain Current
Continuous Drain Current
Continuous Gate Current
Turn-Off Safe Operating Area
Short Circuit Safe Operating Area
Reverse Gate – Source Voltage
Reverse Drain – Source Voltage
Power Dissipation
Storage Temperature
Symbol
VDS
ID
ID
IG
RBSOA
SCSOA
VSG
VSD
Ptot
Tstg
VGS = 0 V
TC = 25°C
TC = 155°C
Conditions
TVJ = 175 oC,
Clamped Inductive Load
TVJ = 175 oC, IG = 1 A, VDS = 800 V,
Non Repetitive
TC = 25 °C / 155 °C, tp > 100 ms
Value
1200
25
10
1.3
ID,max = 10
@ VDS VDSmax
>20
30
25
170 / 22
-55 to 175
Aug 2014
http://www.genesicsemi.com/commercial-sic/sic-junction-transistors/
Unit
V
A
A
A
A
Notes
Fig. 17
Fig. 17
Fig. 19
µs
V
V
W Fig. 16
°C
Pg1 of 11




GA10JT12-263 pdf, 반도체, 판매, 대치품
GA10JT12-263
Figure 7: Typical Transfer Characteristics
B: Dynamic Characteristic Figures
Figure 8: Typical Blocking Characteristics
Figure 9: Input, Output, and Reverse Transfer Capacitance
Figure 10: Output Capacitance Stored Energy
Figure 11: Typical Switching Times and Turn On Energy
Losses vs. Temperature
Figure 12: Typical Switching Times and Turn Off Energy
Losses vs. Temperature
Aug 2014
http://www.genesicsemi.com/commercial-sic/sic-junction-transistors/
Pg4 of 11

4페이지










GA10JT12-263 전자부품, 판매, 대치품
GA10JT12-263
Section V: Driving the GA10JT12-263
A: Gate Drive Theory of Operation
The SJT transistor is a current controlled transistor which requires a positive gate current for turn-on as well as to remain in on-state. An ideal
gate current waveform for ultra-fast switching of the SJT, while maintaining low gate drive losses, is shown in Figure 22.
Figure 22: Idealized Gate Current Waveform
A:1: Gate Currents, IG,pk/-IG,pk and Voltages during Turn-On and Turn-Off
An SJT is rapidly switched from its blocking state to on-state, when the necessary gate charge, QG, for turn-on is supplied by a burst of high
gate current, IG,on, until the gate-source capacitance, CGS, and gate-drain capacitance, CGD, are fully charged.
,
As an example, an IG,pon 2.5 A is required to achieve a 18 ns VDS fall time for a 800 V switching transition, due to the gate-drain charge, QGD
of 44 nC for the GA10JT12-263. The IG,pon pulse should ideally terminate, when the drain voltage falls to its on-state value, in order to avoid
unnecessary drive losses during the steady on-state. In practice, the rise time of the IG,on pulse is affected by the parasitic inductances, Lpar in
the TO-263 package and drive circuit. A voltage developed across the parasitic inductance in the source path, Ls, can de-bias the gate-source
junction, when high drain currents begin to flow through the device. The applied gate voltage should be maintained high enough, above the
VGS,ON (see Figure 7) level to counter these effects.
A high negative peak current, -IG,off is recommended at the start of the turn-off transition, in order to rapidly sweep out the injected carriers from
the gate, and achieve rapid turn-off. While satisfactory turn off can be achieved with VGS = 0 V, a negative gate voltage VGS may be used in
order to speed up the turn-off transition.
A:2: Steady On-State
After the device is turned on, IG may be advantageously lowered to IG,steady for reducing unnecessary gate drive losses. The IG,steady is
determined by noting the DC current gain, hFE, of the device from Figures 5 and 6.
The desired IG,steady is determined by the peak device junction temperature TJ during operation, drain current ID, DC current gain hFE, and a
50 % safety margin to ensure operating the device in the saturation region with low on-state voltage drop by the equation:
, , 1.5
Aug 2014
http://www.genesicsemi.com/commercial-sic/sic-junction-transistors/
Pg7 of 11

7페이지


구       성 총 12 페이지수
다운로드[ GA10JT12-263.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는 부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.


구매 문의
일반 IC 문의 : 샘플 및 소량 구매
-----------------------------------------------------------------------

IGBT, TR 모듈, SCR 및 다이오드 모듈을 포함한
광범위한 전력 반도체를 판매합니다.

전력 반도체 전문업체

상호 : 아이지 인터내셔날

사이트 방문 :     [ 홈페이지 ]     [ 블로그 1 ]     [ 블로그 2 ]



관련 데이터시트

부품번호상세설명 및 기능제조사
GA10JT12-263

Normally - OFF Silicon Carbide Junction Transistor

GeneSiC
GeneSiC

DataSheet.kr       |      2020   |     연락처      |     링크모음      |      검색     |      사이트맵