Product Specification
AU OPTRONICS CORPORATION
( ) Preliminary Specifications
( v ) Final Specifications
Module
Model Name
Note ( )
11.6”(11.58 ”) 16:9 Color TFT-LCD
with LED Backlight design
B116HAN03.0 (H/W:0A )
LED Backlight without driving circuit design
Customer
Date
Approved by
Date
Checked &
Approved by
Date
Kevin KH Shen
04/26/2013
Prepared by
Date
Michael WJ Sun
04/26/2012
Note: This Specification is subject to change
without notice.
DMPBU Marketing Division
AU Optronics corporation
B116HAN03.0 Document Version : 1.0
1 of 32
Product Specification
AU OPTRONICS CORPORATION
1. Handling Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or
spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard
surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human
earth when handling.
7) Do not open nor modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt
the Interface Connector of the TFT Module.
11)After installation of the TFT Module into an enclosure (Notebook PC Bezel, for example),
do not twist nor bend the TFT Module even momentary. At designing the enclosure, it
should be taken into consideration that no bending/twisting forces are applied to the TFT
Module from outside. Otherwise the TFT Module may be damaged.
12)Small amount of materials having no flammability grade is used in the LCD module. The LCD
module should be supplied by power complied with requirements of Limited Power Source
(IEC60950 or UL1950), or be applied exemption.
13)Disconnecting power supply before handling LCD modules, it can prevent electric shock, DO
NOT TOUCH the electrode parts, cables, connectors and LED circuit part of TFT module that a
LED light bar build in as a light source of back light unit. It can prevent electrostic breakdown.
B116HAN03.0 Document Version : 1.0
4 of 32
Product Specification
AU OPTRONICS CORPORATION
Note 1: 5 points position (Ref: Active area)
W /4
W /4
W
W /4
W /4
H /4
H /4
H
H /4
H /4
12
3
45
Note 2: 13 points position (Ref: Active area)
W /4
10
W /4
W
W /4
W /4
10
10
H /4
1
4
23
5
H /4
H
H /4
6
9
78
10
H /4 11 12 13
10
Note 3: The luminance uniformity of 5 or13 points is defined by dividing the maximum luminance values by the
minimum test point luminance
δW5 =
Maximum Brightness of five points
Minimum Brightness of five points
δW13 =
Maximum Brightness of thirteen points
Minimum Brightness of thirteen points
B116HAN03.0 Document Version : 1.0
7 of 32