|
|
Número de pieza | X9315 | |
Descripción | Digitally Controlled Potentiometer | |
Fabricantes | Intersil | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de X9315 (archivo pdf) en la parte inferior de esta página. Total 16 Páginas | ||
No Preview Available ! ®
Data Sheet
X9315
Low Noise, Low Power, 32 Taps
December 21, 2009
FN8179.2
Digitally Controlled Potentiometer
(XDCP™)
The Intersil X9315 is a digitally controlled potentiometer
(XDCP). The device consists of a resistor array, wiper
switches, a control section, and nonvolatile memory. The
wiper position is controlled by a 3-wire interface.
The potentiometer is implemented by a resistor array
composed of 31 resistive elements and a wiper switching
network. Between each element and at either end are tap
points accessible to the wiper terminal. The position of the
wiper element is controlled by the CS, U/D, and INC inputs.
The position of the wiper can be stored in nonvolatile
memory and then be recalled upon a subsequent power-up
operation.
The device can be used as a three-terminal potentiometer or
as a two-terminal variable resistor in a wide variety of
applications including:
• Control
• Parameter Adjustments
• Signal Processing
Block Diagram
Features
• Solid-state potentiometer
• 3-wire serial interface
• 32 wiper tap points
- Wiper position stored in nonvolatile memory and
recalled on power-up
• 31 resistive elements
- Temperature compensated
- End to end resistance range ± 20%
- Terminal voltage, 0 to VCC
• Low power CMOS
- VCC = 2.7V or 5V
- Active current, 80/400µA max.
- Standby current, 5µA max.
• High reliability
- Endurance, 100,000 data changes per bit
- Register data retention, 100 years
• RTOTAL values = 10kΩ, 50kΩ, 100kΩ
• Packages
- 8 Ld SOIC, MSOP and PDIP
• Pb-free available (RoHS compliant)
VCC (Supply Voltage)
Up/Down
(U/D)
Increment
(INC)
Device Select
(CS)
Control
and
Memory
VSS (Ground)
General
U/D
INC
CS
RH/VH
RW/VW
RL/VL
VVCSSC
5-Bit
Up/Down
Counter
5-Bit
Nonvolatile
Memory
Store and
Recall
Control
Circuitry
31
30
29
28
One
of
Thirty
Two
Decoder
2
1
0
Transfer
Gates
Resistor
Array
Detailed
RH/VH
RL/VL
RW/VW
1 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
XDCP is a trademark of Intersil Americas Inc. Copyright Intersil Americas Inc. 2005, 2009. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
1 page X9315
changed by the system or until a power-up/down cycle
recalled the previously stored data.
This procedure allows the system to always power-up to a
preset value stored in nonvolatile memory; then during
system operation minor adjustments could be made. The
adjustments might be based on user preference, system
parameter changes due to temperature drift, etc...
The state of U/D may be changed while CS remains LOW.
This allows the host system to enable the device and then
move the wiper up and down until the proper trim is attained.
Mode Selection
CS INC U/D
MODE
L H Wiper up
L L Wiper down
H X Store wiper position to nonvolatile
memory
H X X Standby
L X No store, return to standby
L H Wiper Up (not recommended)
L L Wiper Down (not recommended)
Power-up and Down Requirements
There are no restrictions on the power-up or power-down
conditions of VCC and the voltages applied to the
potentiometer pins provided that VCC is always more
positive than or equal to VH, VL, and VW, i.e., VCC ≥ VH, VL,
VW. The VCC ramp rate spec is always in effect.
5 FN8179.2
December 21, 2009
5 Page X9315
Typical Absolute% Error per Tap Position
40.0%
30.0%
20.0%
10.0%
0.0%
-10.0%
-20.0%
-30.0%
-40.0%
036
Typical Relative% Error per Tap Position
20.0%
15.0%
10.0%
5.0%
0.0%
-5.0%
-10.0%
-15.0%
-20.0%
036
9 12 15 18 21 24 27 30
Tap
9 12 15 18 21 24 27 30
Tap
Applications Information
Electronic digitally controlled (XDCP) potentiometers provide
three powerful application advantages; (1) the variability and
reliability of a solid-state potentiometer, (2) the flexibility of
computer-based digital controls, and (3) the retentivity of
nonvolatile memory used for the storage of multiple
potentiometer settings or data.
11 FN8179.2
December 21, 2009
11 Page |
Páginas | Total 16 Páginas | |
PDF Descargar | [ Datasheet X9315.PDF ] |
Número de pieza | Descripción | Fabricantes |
X9312 | E2POT Nonvolatile Digital Potentiometer | Xicor |
X9312 | Terminal Voltage 0V to 15V | Intersil Corporation |
X9313 | E2POT Nonvolatile Digital Potentiometer | Xicor |
X9313 | Digitally Controlled Potentiometer | Intersil Corporation |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |