MX10FMAXDQC - SINGLE-CHIP 8-BIT MICROCONTROLLER

Macronix International에서 제조한 전자 부품 MX10FMAXDQC은 전자 산업 및 응용 분야에서
광범위하게 사용되는 반도체 소자입니다.

MX10FMAXDQC의 기능 및 특징 중 하나는 "SINGLE-CHIP 8-BIT MICROCONTROLLER" 입니다.

PDF 형식의 MX10FMAXDQC 자료 제공

MX10FMAXDQC 기능

SINGLE-CHIP 8-BIT MICROCONTROLLER

Macronix International

MX10FMAXDQC 데이터시트 를 다운로드하여 반도체의 전기적 특성과 매개변수에 대해 알아보세요.

PDF 파일안의 텍스트 미리보기

ADVANCED INFORMATION MX10FMAXDQC SINGLE-CHIP 8-BIT MICROCONTROLLER FEATURE • • • • • • • • High performance CMOS MTP ROM CPU Operation Voltage 5V Up to 40MHz operation (3.5MHz to 40MHz) Three 16-bit timer/counters 256 Bytes of on-chip data RAM 64 Kbytes on-chip Flash memory 32 Programmable I/O lines 6 interrupt Sources • • • • • • • Code protection Two priority levels Power saving Idle and power down modes 64 K external program memory space 64 K external data memory space Four 8-bit I/O ports Full-duplex enhanced UART compatible with the standard 80C51 and the 80C52 GENERAL DESCRIPTION The single-chi

Contents of page 4 out of 22 pages :

www.DataSheet4U.com MX10FMAXDQC If desired, ALE operation can be disabled by setting bit 5 of SFR location 87H (PCON). With this bit set, the pin is weakly pulled high. However, the ALE disable feature will be suspended during a MOVX or MOVC instruction, idle mode, power down mode. The ALE disable feature will be terminated by reset. When the ALE disable fea- ture is suspended or terminated, the ALE pin will no longer be pulled up weakly. Setting the ALE-disable bit has no affect if the micrcontroller is in external execu- tion mode. Throughout the remainder of this data sheet, ALE will refer to the signal coming out of the ALE pin, and the pin will be referred to as the ALE pin. PSEN : Program Store Enable is the read strobe to ex- ternal Program Memory. When the MX10FMAXDQC is executing code from ex- ternal Program memory, PSEN is activated twice each machine cycle, except that two PSEN activations are skipped during each access to external Data memory. EA/VPP : Extrernal Access enable. EA must be strapped to VSS in order to enable the twiceto fetch code from external Program Memory locations 0000H to 0FFFFH. EA will be internally latched on reset. EA should be strapped to VCC for internal program ex- ecutions. XTAL1 : Input to the inverting oscillator amplifier. XTAL2 : Output from the inverting oscillator

PDF 파일 전체 : 22 페이지중 1, 2페이지 미리보기

[ MX10FMAXDQC.PDF 데이터시트 ]

당사 플랫폼은 키워드, 제품 이름 또는

부품 번호를 사용하여 검색할 수 있는

포괄적인 데이터시트를 제공합니다.

MX10FMAXDQC 데이터시트 PDF

PDF 형식의 MX10FMAXDQC 자료 제공

PDF 파일안의 텍스트 미리보기

관련 데이터시트

부품번호	상세설명 및 기능	제조사
MX10FMAXDQC	SINGLE-CHIP 8-BIT MICROCONTROLLER	Macronix International